Get IN CASE OF EMERGENCY -> BULB REPLACEMENT Guide for Fiat 500 C 2 Door Second Generation (2016-2020)

198 IN CASE OF EMERGENCY

HAZARD WARNING FLASHERS

BULB REPLACEMENT

Replacement Bulbs

Interior Bulbs

The Hazard Warning flasher switch is located on the

instrument panel below the radio.

Push the switch to turn on the Hazard Warning

flashers. When the switch is activated, all direc-

tional turn signals will flash on and off to warn oncoming

traffic of an emergency. Push the switch a second time to

turn off the Hazard Warning flashers.

Bulb Number

C5W

Overhead Lamp

Courtesy Lamp

Rear Cargo Lamp

W5W

Do not use this emergency warning system when the

vehicle is in motion. Use it when your vehicle is disabled

and it is creating a safety hazard for other motorists.

Exterior Bulbs

Bulb Number

Front Low and High

Beam Headlamp

Front Parking/Daytime

Running Lamps

HIR2LL

If it is necessary to leave the vehicle to go for service, the

Hazard Warning flashers will continue to operate with the

ignition key removed and the vehicle locked.

W21/5W

NOTE: With extended use, the Hazard Warning flashers

may wear down your battery.

Front Fog Lamps

H11LL

W3W

WY21W

WY5W

PY21W

W3W

Front Side Marker Lamps

Front Turn Signal Lamps

Side Direction Lamps

Rear Turn Signal Lamps

Rear Side Marker Lamps

Rear Tail and Stop Lamps

P21/5W

IN CASE OF EMERGENCY 199

Front Turn Signal, Parking And Daytime Running

Lamps

Bulb Number

W16W

Rear Backup Lamps

1. Turn the steering wheel completely to the left or right.

2. Open the wheel housing access door.

Center High Mounted

Stop Lamp

License Plate Lamps

W5W

LED (See Authorized

Dealer)

NOTE: Numbers refer to commercial bulb types that

can be purchased from an authorized dealer.

If a bulb needs to be replaced, visit an authorized

dealer or refer to the applicable Service Manual.

7

Replacing Exterior Bulbs

Headlamps Low Beam And High Beam

1. Remove the plastic cap from the back of the headlamp

housing.

Wheel Housing Access Door

2. Rotate the bulb counter-clockwise.

3. Remove the bulb and replace as needed.

4. Install the bulb and rotate clockwise to lock in place.

5. Reinstall the plastic cap.

3. Remove the plastic cap from the back of the lamp

housing.

4. Rotate bulb/socket counter-clockwise.

5. Remove the bulb and replace as needed.

200 IN CASE OF EMERGENCY

6. Install the bulb into socket, and rotate bulb/socket

clockwise into lamp locking it in place.

Rear Tail, Stop, Backup And Turn Signal Lamps

1. Open the liftgate.

7. Reinstall the plastic cap.

2. Remove the two screws and remove the tail lamp

assembly.

Front Fog Lamps

To replace the front fog lights, see an authorized dealer.

Front/Rear Side Marker Lamps

1. Remove portion of the wheel liner to allow hand access

to side marker lamp.

2. Rotate the bulb socket counterclockwise, and remove

the bulb and socket assembly from the housing.

3. Pull the bulb from the socket and insert the replacement

bulb.

4. Install the bulb and socket assembly into the housing,

and rotate the socket clockwise to lock it in place.

Tail Lamp Assembly Screws

5. Reinstall the wheel liner.

3. Remove four screws and separate the backplate from the

lamp housing.

IN CASE OF EMERGENCY 201

4. Remove the tail, stop, or turn signal bulbs by pushing

them slightly and turning counter-clockwise.

FUSES

WARNING!

5. Remove the backup lamp bulb by pulling straight out.

6. Replace lamps as required and reinstall lamp.

Replacing Interior Bulbs

• When replacing a blown fuse, always use an appro-

priate replacement fuse with the same amp rating as

the original fuse. Never replace a fuse with another

fuse of higher amp rating. Never replace a blown

fuse with metal wires or any other material. Do not

place a fuse inside a circuit breaker cavity or vice

versa. Failure to use proper fuses may result in

serious personal injury, fire and/or property damage.

• Before replacing a fuse, make sure that the ignition is

off and that all the other services are switched off

and/or disengaged.

Rear Cargo Lamp

1. Using a suitable tool open the light box.

2. Pull the bulb out.

7

3. Replace the bulb, and reinstall the light box cover.

• If the replaced fuse blows again, contact an autho-

rized dealer.

• If a general protection fuse for safety systems (air

bag system, braking system), power unit systems

(engine system, transmission system) or steering

system blows, contact an authorized dealer.

IN CASE OF EMERGENCY -> BULB REPLACEMENT for Your Fiat 500 C 2 Door Second Generation (2016-2020)

Related Topics

IN CASE OF EMERGENCY

Popular Owner Manuals

Latest Owner Manuals