IN CASE OF EMERGENCY 217
4. Disconnect the positive (+) end of the jumper cable from
the positive (+) post of the discharged vehicle.
3. Remove the gear selector override access cover (located
on the right side of the gear selector housing) by prying
at the bottom edge of the cover.
If frequent jump starting is required to start your vehicle,
you should have the battery and charging system in-
spected at an authorized dealer.
CAUTION!
Accessories plugged into the vehicle power outlets
draw power from the vehicle’s battery, even when not
in use (i.e., cellular devices, etc.). Eventually, if plugged
in long enough without engine operation, the vehicle’s
battery will discharge sufficiently to degrade battery
life and/or prevent the engine from starting.
7
GEAR SELECTOR OVERRIDE
Gear Selector Override Access Hole
4. Press and maintain firm pressure on the brake pedal.
If a malfunction occurs and the gear selector cannot be
moved out of the PARK position, you can use the following
procedure to temporarily move the gear selector:
5. Insert a small screwdriver or similar tool into the access
hole, and push and hold the override release lever in.
1. Turn the engine OFF.
6. Move the gear selector to the NEUTRAL position.
7. The vehicle may then be started in NEUTRAL.
8. Reinstall the gear selector override access cover.
2. Firmly apply the parking brake.
English 