STARTING AND OPERATING 187
PARKVIEW REAR BACK UP CAMERA
When enabled, active guidelines are overlaid on the image
to illustrate the width of the vehicle and its projected
backup path based on the steering wheel position. A
dashed center line overlay indicates the center of the
vehicle to assist with parking.
Your vehicle is equipped with the ParkView Rear Back Up
Camera that allows you to see an on-screen image of the
rear surroundings of your vehicle whenever the gear
selector is put into REVERSE. The image will be displayed
in the touchscreen display along with a caution note to
“check entire surroundings” across the top of the screen.
After five seconds, this note will disappear. The ParkView
camera is located on the rear of the vehicle above the rear
license plate.
Different colored zones indicate the distance to the rear of
the vehicle.
The following table shows the approximate distances for
each zone:
6
Zone
Distance To The Rear Of
The Vehicle
When the vehicle is shifted out of REVERSE, the rear
camera mode is exited and the last selected touchscreen
appears again.
Red
0 - 1 ft (0 - 30 cm)
Yellow
Green
1 ft - 3 ft (30 cm - 1 m)
If your vehicle is equipped with the Camera Delay feature
and it is turned on, the rear camera image will be displayed
for up to ten seconds after the vehicle is shifted out of
REVERSE unless one of the following conditions occurs:
3 ft or greater
(1 m or greater)
WARNING!
• The vehicle speed exceeds 8 mph (13 km/h).
• The gear selector is moved to PARK.
Drivers must be careful when backing up even when
using the ParkView Rear Back Up Camera. Always
check carefully behind your vehicle, and be sure to
• The soft button “Image defeat [X]” to disable the image
is pressed.
(Continued)
English 
