Opening
ANTI-PINCH DEVICE
ROOF
The sunroof has an anti-pinch safety
system capable of detecting the
presence of an obstacle whilst the roof
is closing. When this happens, the
system stops and the movement of the
roof is immediately reversed.
Hold button A located near the front
ceiling light pressed fig. 30, to move the
roof to “spoiler” position.
With the roof open in “spoiler” position,
hold button A pressed again to move
the roof to all open position. The roof
will stop in the position reached when
the button is released.
FIXED GLASS SUNROOF
(for versions/markets, where provided)
The roof comprises a wide fixed glass
panel and a manually-operated sun
blind. The blind can be used in the "all
closed" or "all open" positions.
To open the blind, grab the handle,
press the tooth A fig. 29 and move it to
the completely open position.
To close it, grab the handle and move
the blind to the closing position until
tooth A is attached.
INITIALISATION
PROCEDURE
The sunroof must be re-initialised after
disconnecting the battery or if the
relevant protection fuse is blown.
Proceed as follows:
press button B fig. 30 and hold it
down so that the roof closes
completely in stages
after full closing, wait for the sunroof
motor to stop.
F0S0096
30
EMERGENCY OPERATION
Closing
If the electrical device for moving the
roof fails, the sun roof can be moved
manually proceeding as described
below:
Press button B fig. 30 from the all open
position: the front glass panel will move
into the “spoiler” position. The roof
will stop in the position reached when
the button is released. Hold button
B pressed again to reach the all closed
position of the roof.
F0S0097
29
for manual activation remove the
protective cap A fig. 31 from its housing
which is located on the internal
covering behind the sun blind
SUNROOF
(for versions/markets, where provided)
22)
take the Allen key provided from the
tool box in the boot
11) 12) 13)
To move the sunshade, follow the
instructions in “fixed glass roof”.
28
English 
