Advertisement

Advertisement

IN AN EMERGENCY -> AUTOMATIC TRANSMISSION GEAR LEVER UNLOCKING for Your Fiat 500 X 4 Door First Generation (2014-2024)

fully depress the brake pedal and  
hold it down;  
To remove the key manually, proceed  
as follows:  
AUTOMATIC  
TRANSMISSION  
GEAR LEVER  
UNLOCKING  
insert the screwdriver supplied  
perpendicularly in hole B fig. 137 and  
adjust the release lever;  
stop the vehicle in safety conditions,  
engage a gear and the electric parking  
brake;  
In the event of a fault, to move the gear  
lever from P (Park), proceed as follows:  
using the provided key A fig. 138  
(located in the casing containing the  
on-board documents), undo the fixing  
screws B fig. 139 for the lower cover C;  
stop the engine;  
engage the electric parking brake;  
working carefully in the point  
indicated by the arrow, remove the trim  
A fig. 135 (complete with gaiter) lifting  
it upwards (see also fig. 136);  
F1B0056C  
137  
place the gear lever in N (Neutral)  
position;  
refit the gear lever gaiter and trim  
correctly;  
F1B0022C  
138  
start the engine.  
EMERGENCY REMOVAL  
OF THE IGNITION KEY  
F1B0028C  
135  
58)  
The ignition key (for versions with key  
without remote control) can be  
removed only if the gear lever is in  
position P (Park).  
If the vehicle battery is flat and the  
ignition key is engaged, the latter is  
locked in position.  
F1B0143C  
139  
remove the lower steering wheel  
cover C by releasing it from its housing;  
F1B0055C  
136  
151  
pull tab D fig. 140 downwards using  
one hand and with the other one  
remove the key, sliding it outwards;  
TWIN CLUTCH  
AUTOMATIC  
TRANSMISSION  
LEVER UNLOCK  
WARNING  
58) It is advisable to contact a Fiat  
Dealership to have the refitting procedure  
carried out. If you would like to proceed  
autonomously, special attention must  
be paid to the correct coupling of  
In case of failure or flat battery, to  
unlock the gear lever, proceed  
as follows:  
the retaining clips. Otherwise, noise might  
be heard due to an incorrect fastening  
of the lower cover with the upper cover.  
stop the engine;  
engage the electric parking brake;  
working carefully in the point  
indicated by the arrow, remove the trim  
A fig. 141 (complete with gaiter) lifting  
it upwards (see also fig. 142);  
F1B0222C  
140  
F1B0028C  
141  
once the key has been removed, refit  
lower cover C fig. 139, make sure it  
locks correctly and tighten the fixing  
screws B firmly.  
fully depress the brake pedal and  
hold it down;  
insert the screwdriver supplied  
perpendicularly in hole B fig. 143 and  
adjust the release lever;  
place the gear lever in N (Neutral)  
position;  
152