Advertisement

Advertisement

What To Do In Emergencies -> Gear Selector Override for Your Fiat 500 SUV First Generation (2007-2019)

276 WHAT TO DO IN EMERGENCIES  
CAUTION! (Continued)  
CAUTION!  
reduce the risk of clutch or transmission failure  
during prolonged efforts to free a stuck vehicle.  
When “rocking” a stuck vehicle by shifting be-  
tween DRIVE/SECOND GEAR and REVERSE,  
do not spin the wheels faster than 15 mph  
(24 km/h), or drivetrain damage may result.  
Revving the engine or spinning the wheels too  
fast may lead to transmission overheating and  
failure. It can also damage the tires. Do not spin  
the wheels above 30 mph (48 km/h) while in gear  
(no transmission shifting occurring).  
NOTE: Push the ЉESC OffЉ switch, to place the Elec-  
tronic Stability Control (ESC) system in ЉPartial OffЉ  
mode, before rocking the vehicle. Refer to “Electronic  
Brake Control” in “Starting And Operating” for further  
information. Once the vehicle has been freed, push the  
ЉESC OffЉ switch again to restore ЉESC OnЉ mode.  
WARNING!  
GEAR SELECTOR OVERRIDE  
Fast spinning tires can be dangerous. Forces gener-  
ated by excessive wheel speeds may cause damage,  
or even failure, of the axle and tires. A tire could  
explode and injure someone. Do not spin your  
vehicle’s wheels faster than 30 mph (48 km/h) or for  
longer than 30 seconds continuously without stop-  
ping when you are stuck and do not let anyone near  
a spinning wheel, no matter what the speed.  
If a malfunction occurs and the gear selector cannot be  
moved out of the PARK position, you can use the  
following procedure to temporarily move the gear  
selector:  
1. Turn the engine OFF.  
2. Firmly apply the parking brake.  
WHAT TO DO IN EMERGENCIES 277  
3. Remove the gear selector override access cover (lo-  
cated on the right side of the gear selector housing)  
by prying at the bottom edge of the cover.  
4. Press and maintain firm pressure on the brake pedal.  
5. Insert a small screwdriver or similar tool into the  
access hole, and push and hold the override release  
lever in.  
6. Move the gear selector to the NEUTRAL position.  
7. The vehicle may then be started in NEUTRAL.  
8. Reinstall the gear selector override access cover.  
6
TOWING A DISABLED VEHICLE  
This section describes procedures for towing a disabled  
vehicle using a commercial towing service.  
Gear Selector Override Access Hole  
Towing Condition  
Wheels OFF The  
Ground  
AUTOMATIC  
TRANSMISSION  
MANUAL  
TRANSMISSION  
Flat Tow  
NONE  
NOT ALLOWED  
If transmission is  
operable:  
Transmission in  
NEUTRAL  
65 mph (104 km/h)  
max speed