Get STARTING AND DRIVING -> CRUISE CONTROL Guide for Fiat Doblo Van 2010-2022

108) The system only warns that the tyre

pressure is low: it is not able to inflate

them.

SPEED BLOCK

(for versions/markets, where provided)

CRUISE CONTROL

(for versions/markets, where provided)

The vehicle is equipped with a speed

limitation function that can be set at the

user's request to one of four predefined

values: 90, 100, 110, 130 km/h.

To activate/deactivate this function,

contact a Fiat Dealership.

109) Insufficient tyre inflation increases fuel

consumption, reduces the tread duration

and may affect the capacity to drive safely.

IN BRIEF

110) Always refit the valve stem cap after

inspecting or adjusting tyre pressure.

This prevents dampness or dirt from

entering the valve stem and thus

the pressure control sensor from being

damaged.

This is an electronic driving aid that

allows you to drive at a speed of

above 30 km/h on long and straight

dry roads (e.g. motorways) with

few driving changes at a preset

speed without having to press the

accelerator pedal. It is therefore not

recommended to use this device

on extra-urban roads with traffic. Do

not use it in town.

Following the operation, a sticker will be

applied to the windscreen showing the

top speed setting.

111) The tyre repair kit (Fix&Go) provided

with the vehicle (for versions/markets,

where provided) is compatible with the

TPMS sensors; using sealants not

equivalent with that in the original kit may

adversely affect its operation. If sealants

not equivalent with the original one are

used, it is recommended to have the

TPMS sensor operation checked by a

qualified repair centre.

IMPORTANT The speedometer could

indicate a higher maximum speed than

the effective one, set by the Dealership,

in accordance with the regulations in

force.

Activating the device

When the device is activated, warning

light

comes on together with the

relevant message in the instrument

panel (for versions/markets where

provided).

The speed adjustment function cannot

be activated in 1st or reverse gear; it

is advisable to activate the function

in 4th or higher gears.

When travelling downhill with the device

activated, the vehicle speed may

exceed the memorised one.

112) 113)

133

Storing vehicle speed

Restoring the stored

speed

If the device has been deactivated, for

Reducing the stored

speed

Proceed as follows:

This can be done in two ways:

turn ring nut A fig. 148 to ON and

press the accelerator pedal so that the

vehicle reaches the desired speed;

example by depressing the brake or

clutch pedal, the stored speed can be

restored as follows:

by deactivating the device and then

storing the new speed

move the stalk upwards (+) for at

least one second, then release it: the

vehicle speed is memorised and you

can therefore release the accelerator

pedal.

accelerate progressively until a

speed close to that stored is reached;

by moving the stalk downwards (-)

until the new speed, which will

automatically remain memorised, is

reached.

engage the gear selected at the time

that the speed was stored;

press button B fig. 148.

Each movement of the stalk will

correspond to a slight reduction in

speed of about 1 km/h, while keeping

the stalk held downwards will decrease

the speed continuously.

If necessary (when overtaking for

instance) acceleration is possible by

simply pressing the accelerator pedal:

releasing the accelerator pedal, the

vehicle will return to the speed

memorised previously.

Increasing the stored

speed

This can be done in two ways:

by pressing the accelerator and

memorizing the new speed reached;

Deactivating the device

The device can be switched off by the

driver in the following ways:

by moving the stalk upwards (+).

Each operation of the stalk will

correspond to a slight increase in

speed of about 1 km/h, while keeping

the stalk upwards will increase the

speed continuously.

by turning ring nut A to the OFF

position;

if the engine is stopped (leaving the

stalk ring nut at ON), when the ignition

key is next turned to ON, Cruise

Control will be activated automatically.

F0V0092

148

134

Deactivating the

function

TRACTION PLUS

SYSTEM

(for versions/markets, where provided)

WARNING

The device can be switched off by the

driver in the following ways:

112) When travelling with the device active,

never move the gear lever to neutral.

Traction Plus is a driving aid, useful

for setting off in poor grip conditions

(snow, ice, mud, etc.) which allows the

drive force to be distributed in the

best way over the front axle when one

wheel is slipping.

by pressing the brake pedal when

the device is adjusting the speed:

113) In the event of device faults or failures,

turn the ring nut A to OFF and contact a

Fiat Dealership.

by pressing the clutch pedal when

the device is adjusting the speed;

by pressing button B fig. 148 when

the device is adjusting the speed (for

versions/markets, where provided);

Traction Plus acts by braking the

wheels with poor grip (or those slipping

more than the others), thereby

by pressing the accelerator pedal (in

this case the system is not actually

turned off but the acceleration request

takes priority; the cruise control remains

activated, without the need to the

press button B fig. 148 to restore the

previous conditions once the

transferring the drive force to those

which have greater grip on the ground.

This function can be activated manually

by pressing the A fig. 149 button on

the control panel and operates under

50 km/h. When this speed is exceeded,

it is automatically deactivated and it is

reactivated again when the speed

falls below 50 km/h.

acceleration is over).

The device is automatically switched off

in the following cases:

if the ABS or ESC systems intervene

with the vehicle speed below the

set limit

in the event of system failure.

F0V0575

149

135

Download User Manual App

STARTING AND DRIVING -> CRUISE CONTROL for Your Fiat Doblo Van 2010-2022

Related Topics

STARTING AND DRIVING

Popular Owner Manuals

Latest Owner Manuals