2013-2023 Fiat Panda SUV STARTING AND DRIVING -> REFUELLING THE VEHICLE User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

STARTING AND DRIVING -> REFUELLING THE VEHICLE for Your Fiat Panda SUV Third Generation (2013-2023)

OPERATION WITH A  
TRAILER  
the presence of ultrasonic systems  
(e.g. pneumatic brake systems of  
trucks or pneumatic drills) near the  
vehicle could alter the signals sent to  
the sensor;  
PARKING SENSORS  
The operation of the sensors is  
automatically deactivated when the  
trailer electric cable plug is inserted in  
the tow hook socket of the car. The  
sensors are automatically reactivated  
when the trailer's cable plug is  
removed.  
127)  
47)  
SENSORS  
the variation in sensor position,  
caused by variation in ride (due  
to suspension or shock absorber wear),  
changing tyres, overloaded car, or  
tuning that lowers the car, for example,  
may affect parking sensor system  
performance;  
The sensors are located in the rear  
bumper fig. 89 and their function is to  
detect the presence of any obstacles  
near the rear part of the car and inform  
the driver, through an intermittent  
acoustic signal.  
IMPORTANT NOTES  
When parking, take the utmost care  
over obstacles that may be above  
or under the sensor.  
the presence of a tow hook without  
trailer interferes with the correct  
operation of the parking sensors. If a  
fixed tow hook is installed, the sensors  
cannot be used. If the customer installs  
a removable tow hook, this must  
always be disconnected from  
Objects close to the car are not  
detected under certain circumstances  
and could therefore cause damage  
to the car or be damaged.  
The following conditions may influence  
the performance of the parking  
assistance system:  
the crossmember whenever the trailer  
is not attached to prevent the activation  
of the sensors.  
the presence of ice, snow, mud or  
multiple layers of paint on the surface of  
the sensor may reduce its sensitivity  
and the system performance;  
F1D0045  
89  
WARNING  
ACTIVATION/  
DEACTIVATION  
mechanical interference (e.g.  
washing the car, rain, strong wind, hail)  
may cause the sensor to detect a  
non-existent obstacle ("echo  
interference");  
127) Parking manoeuvres, however, are  
always the driver’s responsibility. While  
carrying out these manoeuvres, always  
make sure that no people (especially  
children) or animals are in the area  
concerned. The parking sensors are used  
to assist the driver, who must never allow  
his attention to lapse during potentially  
dangerous manoeuvres, even those  
executed at low speeds.  
The sensors are automatically activated  
when reverse gear is engaged. The  
acoustic warning becomes more  
frequent as the obstacle behind the car  
gets closer.  
99  
DIESEL ENGINES  
REFUELLING THE  
VEHICLE  
Operation at low temperatures  
Only use Diesel for motor vehicles  
(EN590 specification).  
WARNING  
47) For correct operation of the system,  
sensors must always be clean from mud,  
dirt, snow or ice. Be careful not to scratch  
or damage the sensors while cleaning  
them. Avoid using dry, rough or hard  
cloths. The sensors must be washed using  
clean water, with the addition of vehicle  
shampoo if necessary. When using special  
washing equipment such as high pressure  
jets or steam cleaning, clean the sensors  
very quickly keeping the jet more than  
10 cm away.  
When using or parking the car for a  
long time in the mountains or cold  
areas, it is advisable to refuel using  
locally available diesel fuel. In this case,  
it is also advisable to keep the tank  
over 50% full.  
128) 129) 130)  
Always stop the engine before  
refuelling.  
PETROL ENGINES  
Only use unleaded petrol, with an  
octane number (R.O.N.) not lower than  
95. In order to prevent damage to the  
catalytic converter never introduce even  
the smallest amount of leaded petrol,  
even in the event of an emergency.  
REFUELLING  
PROCEDURE  
48)  
IMPORTANT If the filler compartment is  
washed with a high-pressure jet, keep  
it at a distance of at least 20 cm.  
IMPORTANT An inefficient catalytic  
converter leads to harmful exhaust  
emissions, thus contributing to air  
pollution.  
Diesel and petrol versions  
The refuelling procedure described  
below is illustrated on the label B fig. 90  
located inside the fuel flap. The label  
also indicates the fuel type (UNLEADED  
FUEL=petrol, DIESEL=diesel fuel).  
To refuel proceed as follows:  
IMPORTANT Never introduce leaded  
petrol to the tank, even in small  
amounts in an emergency, as this  
would damage the catalytic converter  
beyond repair.  
open flap A fig. 90, pulling it  
outwards;  
introduce the dispenser in the filler  
and refuel;  
100  

Related Topics

Popular Owner Manuals