SERVICING AND MAINTENANCE -> Bodywork for Your Fiat Panda SUV Fourth Generation (2024-2026)

inflate tyres to +0.5 bar above the  
standard specified pressure and check  
it at intervals;  
do not drain the engine cooling  
system.  
Warnings for the 1.0 FireFly Hybrid  
version  
WARNING In the event of extended  
inactivity, start the engine every three  
months and drive a section of road to  
recharge the auxiliary lithium battery.  
CAR INACTIVITY  
WARNING  
If the car is to be left inactive for longer  
than a month, observe the following  
precautions:  
178) Do not cross switch the tyres if they  
are "unidirectional" type. In this case,  
always take care not to fit the tyres with a  
direction of rotation that is opposite to that  
indicated: you would risk losing grip and  
control of the vehicle.  
179) Travelling with partially or completely  
deflated tyres can cause safety problems  
and damage the concerned tyre beyond  
repair.  
park the car in covered, dry and if  
possible well-ventilated premises and  
slightly open the windows;  
engage a gear and check that the  
handbrake is not engaged;  
disconnect the negative terminal  
from the conventional battery pole  
(for versions with Start&Stop system  
refer to "Start&Stop system" chapter  
in the "Knowing your car" section). If  
the battery is not disconnected from  
the electrical system, check its charge  
every thirty days;  
for the 1.0 FireFly Hybrid version:  
park the car with the auxiliary (lithium)  
battery fully charged;  
clean and protect the painted parts  
using protective wax;  
clean and protect the shiny metal  
parts using special compounds  
available commercially;  
sprinkle talcum powder on the  
windscreen and rear window wiper  
rubber blades and lift them off the  
glass;  
WARNING If the auxiliary battery has  
a low charge, this will not affect car  
starting.  
IMPORTANT  
60) The road holding qualities of the car  
also depend on the correct inflation  
pressure of the tyres.  
61) If tyre pressure is too low, the tyre may  
overheat and be severely damaged as a  
result.  
62) Do not switch tyres from the  
right-hand side of the vehicle to the  
left-hand side, and vice versa.  
63) Never submit alloy rims to repainting  
treatments requiring the use of  
temperatures exceeding 150°C. The  
mechanical properties of the wheels could  
be impaired.  
BODYWORK  
PRESERVING THE  
BODYWORK  
Paintwork  
64) 65)  
6)  
To correctly wash the car, proceed as  
follows:  
remove the aerial from the roof  
to prevent damage to it if the car is  
washed in an automatic system;  
if high pressure jets or cleaners are  
used to wash the car, keep a distance  
of at least 40 cm from the bodywork to  
avoid damage or alteration. It should be  
remembered that a build up of water  
cover the car with a cloth or  
perforated plastic sheet. Do not use  
sheets of non-perforated plastic as they  
do not allow moisture on the car body  
to evaporate;  
157  
could cause damage, in the long term,  
to the car;  
wet the bodywork with a low-  
pressure water jet;  
wipe a sponge with a slightly soapy  
solution over the bodywork, frequently  
rinsing the sponge;  
rinse well with water and dry with a  
jet of air or a chamois leather.  
Dry the less visible parts (e.g. door  
frames, bonnet, headlight frames  
etc.) with special care, as water  
may stagnate more easily in these  
areas. The car should not be taken to  
a closed area immediately, but left  
outside so that residual water can  
evaporate.  
After use off-road  
acetone) for cleaning the plastic lenses  
of the headlights.  
After using the car off road, with  
significant fouling of wheels, bodywork,  
below-engine cover and underbody  
protection, it is necessary to wash the  
car cleaning the radiators carefully  
(engine cooling and air conditioning),  
radiator fan, wheels (rims and wheel  
arches), under-engine and underbody  
guards, in order not to affect their  
operation.  
Engine compartment  
At the end of every winter, wash the  
engine compartment thoroughly, taking  
care not to aim the jet of water directly  
at the electronic control units or at the  
windscreen wiper motors. Have this  
operation performed at a specialised  
workshop.  
Thorough washing of the car, in  
addition to ensuring good ventilation of  
the brake discs and perfect balance of  
the wheels, also guarantees that the  
propeller shaft operates correctly.  
WARNING The washing should take  
place with the engine cold and the  
ignition key in the STOP position. After  
the washing operation, make sure that  
the various protections (e.g. rubber  
caps and guards) have not been  
removed or damaged.  
Windows  
Do not wash the car after it has been  
left in the sun or with the bonnet  
hot: this may alter the shine of the  
paintwork. Exterior plastic parts must  
be cleaned in the same way as the rest  
of the car.  
Use specific detergents and clean  
cloths to prevent scratching or altering  
the transparency.  
VERSIONS WITH MATT  
PAINT  
WARNING Wipe the rear window  
inside gently with a cloth following  
the direction of the filaments to avoid  
damaging the heating device.  
(for versions/markets, where provided)  
These versions have exclusive matt  
paintwork which requires special care  
for its preservation.  
Avoid parking under trees; the resin  
dropped by trees makes the paintwork  
go opaque and increases the possibility  
of corrosion.  
The instructions for good preservation  
follow below.  
Headlights  
Use a soft cloth soaked in water and  
detergent for washing cars.  
WARNING Bird droppings must be  
washed off immediately and thoroughly  
as the acid they contain is particularly  
aggressive.  
66)  
Versions with stickers, liner or  
wrapping  
WARNING Never use aromatic  
substances (e.g. petrol) or ketones (e.g.  
To correctly clean and wash the car,  
proceed as follows:  
avoid washing with rollers and/or  
158  
wash the car after it has been parked in  
the sun.  
ENGINE COMPARTMENT  
WASHING  
brushes in washing stations. Then,  
wash the car, only by hand, using pH-  
neutral detergents; dry it with a wet  
chamois leather. Abrasive products  
and/or polishes should not be used for  
cleaning the car.  
Exterior plastic parts must be cleaned  
in the same way as the rest of the car.  
Where possible, do not park the car  
under trees; the resinous substances  
that many species release give the  
paint a dull appearance and increase  
the possibility of triggering rusting  
processes.  
69)  
If the engine compartment is washed  
(at low pressure, e.g. in very dusty  
areas), this must be done with the  
engine cold and with ignition device  
turned to STOP. Take care not to direct  
the water jet straight at the electronic  
control modules or the wiper motors.  
Moreover, do not direct the jet towards  
the drop catcher area around the  
engine oil cap to avoid splashing oil in  
the engine compartment. Have this  
operation performed by a specialised  
workshop. After washing, check that  
the various protective components (e.g.  
rubber guards and caps) have not been  
removed or damaged.  
The use of solvents, waxes,  
detergents or similar products is not  
recommended for the care of the car  
as they could damage the stickers or  
cause them to detach. The use of such  
washing or cleaning instruments and  
methods will therefore invalidate the  
warranty.  
WARNING In case of water stains  
(rings) on the wrapping, remove it,  
washing again and drying it with a  
non-abrasive soft cloth.  
NOTE We recommend using mild  
products for cleaning the car.  
It should be remembered that a build  
up of water could cause damage, in  
the long term, to the car.  
Wet the bodywork with a low-  
pressure water jet.  
Wipe a sponge with a slightly soapy  
solution over the bodywork, frequently  
rinsing the sponge.  
Rinse well with water and dry with  
a jet of air or a chamois leather. Dry  
the less visible parts with special care,  
such as the door frames, bonnet and  
the headlight frames, where water  
may stagnate more easily. The car  
should not be taken to a closed area  
immediately, but left outside so that  
residual water can evaporate. Do not  
WARNINGS  
Bird droppings must be washed off  
immediately and thoroughly as the acid  
they contain is particularly aggressive.  
Avoid (if at all possible) parking the  
car under trees; remove vegetable  
resins immediately as, when dried, it  
may only be possible to remove them  
with abrasive products and/or polishes,  
which is highly inadvisable as they  
could alter the paint, the stickers or the  
wrapping.  
IMPORTANT  
64) Abrasive products and/or polishes  
should not be used for cleaning the car.  
Bird droppings must be washed off  
immediately and thoroughly as the acid  
they contain is particularly aggressive.  
Avoid parking the vehicle under trees  
(unless it is absolutely necessary). Remove  
any resinous plant matter immediately  
because, once it has dried, it may require  
the use of abrasive and/or polishing  
products to be removed, which are  
strongly discouraged as they could  
potentially alter the characteristics  
Do not use pure windscreen washer  
fluid for cleaning the windscreen and  
the rear window: dilute it to at least  
50% with water.  
67) 68)  
159  
INTERIOR  
of the paintwork. Do not use pure  
windscreen washer fluid for cleaning  
the front windscreen and rear window;  
dilute it min. 50% with water. Only use  
pure screen washer fluid when strictly  
necessary due to outside temperature  
conditions. Do not use chemicals/acids to  
defrost windows/vehicle glass as they can  
damage the paint.  
65) In order to preserve the appearance  
of the paint abrasive products and/or  
polishes should not be used for cleaning  
the car.  
distance of 40 cm with water at room  
temperature.  
180) 181)  
68) Abrasive products and/or polishes  
should not be used for cleaning the car  
69) A high pressure jet cleaner should  
not be used for cleaning the engine  
compartment. The appropriate  
precautions have been taken to protect all  
parts and connections, but the pressures  
generated by these devices are so high  
that complete protection against water  
seepages cannot be guaranteed.  
SEATS AND FABRIC  
PARTS  
Remove dust with a soft brush or a  
vacuum cleaner. Rub the seats using a  
soft microfibre cloth moistened with a  
solution of water and neutral detergent.  
WARNING To avoid ruining the  
66) Avoid washing with rollers and/or  
brushes in washing stations. Wash  
the car only by hand using neutral pH  
detergents; dry it with a wet chamois  
leather. Abrasive products and/or polishes  
should not be used for cleaning the car.  
Bird droppings must be washed off  
immediately and thoroughly as the acid  
they contain is particularly aggressive.  
Avoid (if at all possible) parking the car  
under trees; remove vegetable resins  
immediately as, when dried, it may only be  
possible to remove them with abrasive  
products and/or polishes, which is highly  
inadvisable as they could alter the typical  
opacity of the paint. Do not use pure  
windscreen washer fluid for cleaning  
the front windscreen and rear window;  
dilute it min. 50% with water. Only use  
pure screen washer fluid when strictly  
necessary due to outside temperature  
conditions. Do not use chemicals/acids to  
defrost windows/vehicle glass as they can  
damage the paint.  
upholstery, do not use acetone, acetic  
alcohol, denatured ethyl alcohol or  
any highly aggressive solvents or  
detergents to clean the fabric parts.  
Use spotting agents such as isopropyl  
alcohol or dry stain removers.  
IMPORTANT  
6) Detergents pollute the water. Only wash  
your vehicle in areas equipped to collect  
and treat waste water from this type of  
activity.  
Cleaning heat press images on  
seats  
(for versions/markets, where provided)  
Due to the colour, opacity and wear-  
resistant protection with which the heat  
press images on some seat versions  
are made, they may be subject to  
temporary scratching if they are  
touched by finger nails, keys, or other  
hard objects.  
In such cases, the visible signs do  
not impair the profiled images, and  
can easily be removed by wiping the  
affected area with a microfibre cloth  
67) It is not advisable to wash with  
pressure washer or, in case of use, it is  
necessary to maintain at least a minimum  
160