correctly position the new arm, fully
tighten the nut (B) then lower the cover
(A).
WARNING
WARNING
176) Driving with worn windscreen/rear
window wiper blades is a serious risk,
because visibility is reduced in bad
weather.
177) Lift the vehicle exclusively by
positioning the jack arms or the workshop
jack in the points illustrated.
WHEELS AND TYRES
IMPORTANT
178) 179)
60) 61) 62) 63)
59) Do not operate the windscreen wiper
with the blades lifted from the windscreen.
Before long trips, and every two weeks,
check the tyre and space-saver wheel
inflation pressure (for versions/markets,
where provided). Check the tyres when
cold.
171
F1D0101
LIFTING THE
VEHICLE
NOZZLES
Windscreen washer
It is normal for the pressure to increase
when the car is used; for the correct
tyre inflation pressure, see the
"Wheels" chapter in the "Technical
specifications" section.
177)
The windscreen washer jets can be
adjusted rotating the side notch with
a screwdriver. If there is no jet of
fluid, firstly check that there is fluid in
the reservoir (see the "Checking fluid
levels" paragraph in this section). Then
check that the nozzle holes are not
clogged; use a needle to unblock them
if necessary.
If the vehicle needs to be jacked up, go
to a Fiat Dealership which is equipped
with workshop jacks and jack arms
fig. 172.
Incorrect pressure causes abnormal
tyre wear fig. 173:
Rear window washer
The rear window washer jets are fixed.
The nozzle holder is located above the
rear window.
172
F1D0135
173
F1D0793
155
English 