MAINTENANCE AND CARE -> CHARGING THE CONVENTIONAL BATTERY for Your Fiat Tipo 4 Door Second Generation (2015-2026)

179) Some commercial additives for  
windscreen washer fluid are flammable.  
The engine compartment contains hot  
components which may start a fire.  
180) Brake fluid is poisonous and highly  
corrosive. In the event of accidental  
contact, immediately wash the affected  
parts with water and mild soap. Then rinse  
thoroughly. Call a doctor immediately if  
swallowed.  
181) The symbol , on the brake fluid  
container indicates if a brake fluid is  
synthetic or mineral-based. Use of mineral  
type fluids will damage the special rubber  
seals of the braking system beyond repair.  
182) The conventional battery fluid is  
poisonous and corrosive. Avoid contact  
with the skin and eyes. Keep naked flames  
and sources of sparks away from the  
conventional battery: risk of explosion and  
fire.  
183) Using the conventional battery with  
insufficient battery fluid may irreparably  
damage the battery and may cause an  
explosion.  
184) Always wear appropriate goggles to  
protect your eyes when working on or near  
the conventional battery.  
185) If the car will be unused for an  
extended period of time in extremely  
cold weather conditions, remove the  
conventional battery and store it in a  
heated area to prevent it from freezing.  
186) If the conventional battery needs  
to be replaced, always contact a Fiat  
Dealership. Replace the battery with a new  
one of the same type (EFB - Enhanced  
Flooded Battery) and specifications.  
5) Traditional batteries contain  
WARNING  
substances which are very harmful for the  
environment. For conventional battery  
replacement, contact a Fiat Dealership.  
65) The oil level must never exceed the  
MAX. mark.  
66) Always top up using engine oil of the  
same specifications as that already in the  
engine.  
CHARGING THE  
CONVENTIONAL  
BATTERY  
UP  
67) PARAFLU protective anti-freeze  
is used in the engine cooling system.  
Use fluid of the same type as that  
contained in the cooling system for  
UP  
WARNINGS  
WARNING The conventional battery  
charging procedure is given for  
information only. To carry out this  
operation, contact a Dealership.  
topping up. PARAFLU  
fluid cannot be  
mixed with any other type of fluid. If this  
happens, do not start the engine under  
any circumstances and contact a Fiat  
Dealership.  
68) Prevent brake fluid, which is highly  
corrosive, from coming into contact  
with painted parts. Should it happen,  
immediately wash with water.  
69) Incorrect installation of electric and  
electronic devices may cause severe  
damage to your car. After purchasing your  
car, if you wish to install any accessories  
(e.g. anti-theft, radio phone, etc.), go to  
a Fiat Dealership, which will suggest the  
most suitable devices and advise you  
whether a higher capacity battery needs to  
be installed.  
WARNING After setting the ignition  
device to STOP and closing the driver's  
door, wait at least two minutes before  
disconnecting the electrical supply  
from the traditional battery. When  
reconnecting the electrical supply to  
the conventional battery, make sure  
that the ignition device is in the STOP  
position and the driver's door is closed.  
WARNING Charging should be slow at  
a low ampere rating for approximately  
24 hours. Charging for a longer time  
may damage the battery.  
WARNING  
4) The used engine oil and the filter that  
has been replaced contain substances  
that are harmful to the environment. To  
change the oil and filters, we advise you to  
contact a Fiat Dealership.  
WARNING The cables of the electrical  
system must be correctly reconnected  
to the conventional battery, i.e. the  
194  
positive cable (+) to the positive  
VERSIONS WITH  
START&STOP SYSTEM  
(where provided)  
To charge, proceed as follows:  
disconnect the connector (1) fig. 218  
by pressing the button (2) from the  
sensor (3) monitoring the status of the  
conventional battery, on the negative  
() pole (4) of the battery;  
connect the positive cable (+) of  
the battery charger to the positive  
traditional battery terminal (5) and the  
negative cable () to sensor terminal (4)  
as shown;  
turn on the battery charger. At the  
end of the charging process, switch the  
battery charger off;  
SERVICING  
PROCEDURES  
terminal and the negative cable () to  
the negative terminal. The conventional  
battery terminals are marked with the  
positive (+) and negative (-) terminal  
symbols, and are shown on the cover  
of the conventional battery. The battery  
terminals must also be corrosion-free  
and firmly secured to the terminals. If  
a quick-type battery charger is used  
with the battery fitted on the car, before  
connecting it disconnect both cables  
of the traditional battery itself. Do not  
use a "quick-type" battery charger to  
provide the starting voltage.  
70) 71) 72)  
The following pages contain the  
rules on the required maintenance  
envisaged by the technical personnel  
who designed the car.  
In addition to these specific  
maintenance instructions specified for  
routine scheduled servicing, there are  
other components which may require  
intervention or replacements over the  
car’s life cycle.  
ENGINE OIL  
Engine oil level check  
73)  
VERSIONS WITHOUT  
START&STOP SYSTEM  
To charge, proceed as follows:  
disconnect the terminal from the  
negative conventional battery pole;  
connect the charger cables to  
the conventional battery terminals,  
observing the polarity;  
after having disconnected the battery  
charger, reconnect connector (1) to the  
sensor (3) as shown.  
To ensure correct engine lubrication,  
the oil must always be kept at  
the prescribed level (see "Engine  
compartment" in this chapter).  
ENGINE OIL FILTER  
Replacing the engine oil filter  
The engine oil filter must be replaced  
each time the engine oil is changed.  
It is advisable to replace it with a  
genuine spare part, specifically  
designed for this car.  
turn on the battery charger;  
when it is recharged, turn the charger  
off before disconnecting it from the  
conventional battery;  
reconnect the terminal to the  
negative conventional battery pole.  
218  
09036J0001EM  
195