Driver Controls -> Steering wheel adjustment for Your Ford Fusion 4 Door First Generation (2006-2012)

Driver Controls  
Windshield washer: Press the end  
of the stalk:  
briefly: causes a single swipe of  
the wipers without washer fluid.  
a quick press and hold: the  
wipers will swipe three times with  
washer fluid.  
a long press and hold: the wipers  
and washer fluid will be activated  
for up to ten seconds.  
Courtesy wipe feature: One extra wipe will occur a few seconds after  
washing the front window to clear any excess washer fluid remaining on  
the windshield.  
Note: Do not operate the washer when the washer reservoir is empty.  
This may cause the washer pump to overheat. Check the washer fluid  
level frequently. Do not operate the wipers when the windshield is dry.  
This may scratch the glass, damage the wiper blades and cause the wiper  
motor to burn out. Before operating the wiper on a dry windshield,  
always use the windshield washer. In freezing weather, be sure the wiper  
blades are not frozen to the windshield before operating the wipers.  
Windshield wiper rainlamp feature (if equipped with autolamp)  
When the windshield wipers are turned on during daylight, and the  
headlamp control is in the autolamp position, the exterior lamps will turn  
on after a brief delay and will remain on until the wipers are turned off.  
TILT/TELESCOPE STEERING WHEEL  
To adjust the steering wheel:  
1. Pull the lever down to unlock the  
steering column.  
2. While the lever is in the down  
position, move the steering wheel  
up or down and in or out until you  
find the desired position.  
3. While holding the steering wheel  
in place, pull the lever up to its  
original position to lock the steering  
column.  
73  
2011 Fusion (fsn)  
Owners Guide, 3rd Printing  
USA (fus)  
Driver Controls  
WARNING: Never adjust the steering wheel when the vehicle is  
moving.  
ILLUMINATED VISOR MIRROR (IF EQUIPPED)  
Lift the mirror cover to turn on the  
visor mirror lamps.  
Slide-on-rod feature (if  
equipped)  
Rotate the visor towards the side  
window and extend it rearward for  
additional sunlight coverage.  
Note: To stow the visor back into  
the headliner, visor must be  
retracted before moving it back  
towards the windshield.  
74  
2011 Fusion (fsn)  
Owners Guide, 3rd Printing  
USA (fus)  
Driver Controls  
OVERHEAD CONSOLE  
The appearance of your vehicle’s overhead console will vary according to  
your option package.  
Storage compartment  
Press on the rear edge of the  
compartment door to open.  
The storage compartment may be  
used to secure sunglasses or a  
similar object.  
ELECTRONIC COMPASS (IF EQUIPPED)  
The compass heading is displayed in the center integrated display (CID).  
The compass reading may be affected when you drive near large  
buildings, bridges, power lines and powerful broadcast antenna. Magnetic  
or metallic objects placed in, on or near the vehicle may also affect  
compass accuracy.  
Usually, when something affects the compass readings, the compass will  
correct itself after a few days of operating your vehicle in normal  
conditions. If the compass still appears to be inaccurate, a manual  
calibration may be necessary. Refer to Compass calibration  
adjustment.  
Most geographic areas (zones) have a magnetic north compass point that  
varies slightly from the northerly direction on maps. This variation is four  
degrees between adjacent zones and will become noticeable as the  
vehicle crosses multiple zones. A correct zone setting will eliminate this  
error. Refer to Compass zone adjustment.  
75  
2011 Fusion (fsn)  
Owners Guide, 3rd Printing  
USA (fus)  
Driver Controls  
Compass zone adjustment  
1. Determine which magnetic zone  
you are in for your geographic  
location by referring to the zone  
map.  
3 2  
4
1
15  
14  
13  
2. Turn ignition to the on position.  
5
12  
6
7 8 91011  
3. Press and hold the 7 and 9 radio  
preset buttons together for  
approximately five seconds until  
ZONE XX appears in the CID.  
4. Press and release the 7 and 9  
radio preset buttons together,  
repeatedly until ZONE XX changes  
to the correct zone (1–15) in the  
CID.  
5. The direction will display after  
the buttons are released. The zone  
is now updated.  
Compass calibration adjustment  
Perform compass calibration in an open area free from steel structures  
and high voltage lines. For optimum calibration, turn off all electrical  
accessories (heater/air conditioning, wipers, etc.) and make sure all  
vehicle doors are shut.  
1. Start the vehicle.  
76  
2011 Fusion (fsn)  
Owners Guide, 3rd Printing  
USA (fus)  
Driver Controls  
2. To calibrate, press and hold the 7  
and 9 radio preset buttons together  
for approximately 10 seconds until  
CAL appears. Release the buttons.  
3. Slowly drive the vehicle in a  
circle (less than 3 mph [5 km/h])  
until the CAL display changes to the  
direction value (N, S, E, W, etc.). It  
may take up to five circles to  
complete calibration.  
4. The compass is now calibrated.  
CENTER CONSOLE  
Your vehicle may be equipped with a  
variety of console features. These  
include:  
1. Cupholders (with ambient lighting  
[if equipped]).  
2. Secondary storage bin (on hinges  
inside utility compartment).  
3. Utility compartment with power  
point, auxiliary input jack (AIJ),  
USB port (if equipped), and coin  
holder inside.  
WARNING: Use only soft cups in the cup holder. Hard objects  
can injure you in a collision.  
77  
2011 Fusion (fsn)  
Owners Guide, 3rd Printing  
USA (fus)  
Driver Controls  
INSTRUMENT PANEL STORAGE COMPARTMENT  
The storage compartment may be  
used to secure sunglasses or similar  
sized objects. Press the button to  
open the storage compartment.  
AUXILIARY POWER POINT (12V DC)  
Power outlets are designed for accessory plugs only. Do not insert  
any other object in the power outlet as this will damage the  
outlet and blow the fuse. Do not hang any type of accessory or  
accessory bracket from the plug. Improper use of the power  
outlet can cause damage not covered by your warranty.  
Auxiliary power points can be found in the following locations:  
On the instrument panel  
In the center console utility compartment  
Do not use the power point for operating the cigarette lighter element (if  
equipped).  
Note: Do not plug optional electrical accessories into the cigarette lighter  
socket (if equipped). Improper use of the lighter can cause damage not  
covered by your warranty, and can result in fire or serious injury.  
To prevent the fuse from being blown, do not use the power point(s) over  
the vehicle capacity of 12V DC/180W. If the power point is not working, a  
fuse may have blown. Refer to Fuses and relays in the Roadside  
Emergencies chapter for information on checking and replacing fuses.  
To have full capacity usage of your power point, the engine is required to  
be running to avoid unintentional discharge of the battery. To prevent  
the battery from being discharged:  
do not use the power point longer than necessary when the engine is  
not running,  
do not leave battery chargers, video game adapters, computers and  
other devices plugged in overnight or when the vehicle is parked for  
extended periods.  
Always keep the power point caps closed when not being used.  
78  
2011 Fusion (fsn)  
Owners Guide, 3rd Printing  
USA (fus)