Starting and Stopping the Engine
During starting, the fuel injectors are turned
STARTING A GASOLINE
ENGINE - E85
For general information on starting a
gasoline engine. See Starting a Gasoline
Engine (page 121).
off as long as the accelerator pedal is
depressed. This can be used to drain
excessive fuel from the intake manifold
after several unsuccessful starting
attempts.
If the battery has been disconnected or
after the fuel type has been changed, the
idle speed may be irregular. This will
improve after 10 to 30 seconds.
Starting at low ambient
temperatures
When the temperature is lower than -10°C
(14°F) and the vehicle is filled with E85, an
engine block heater should be used to
facilitate starting. See Engine Block
Heater (page 123). Failure to do this will
result in a non start.
STARTING A DIESEL ENGINE
Cold or hot engine
All vehicles
Note: When the temperature is below -15°C
(5°F), you may need to crank the engine for
up to 25 seconds.
If the temperature is expected to remain
below -10°C (14°F), it is recommended
that you increase the proportion of
gasoline in the tank by topping up with 95
octane unleaded gasoline if the tank is not
already full. About 10 liters (2.2 gallons) of
gasoline will reduce the proportion of E85
in a ¾ full tank from 85% to 70% and will
considerably improve cold start capability.
Note: Continue cranking the engine until it
starts.
Note: You can only operate the starter for
a maximum of 30 seconds at a time.
Switch the ignition on and wait
until the glow plug indicator goes
off.
If, at very low temperatures, the tank is
filled with only E85 and there is no way to
use an engine block heater, you may
experience difficulties starting the engine.
Vehicles with manual transmission
If the engine fails to start, proceed as
follows:
Note: Do not touch the accelerator pedal.
1. Fully depress the clutch pedal.
2. Start the engine.
1. Fully depress the accelerator pedal.
2. Turn the ignition key to position III.
CAUTION
Vehicles with automatic transmission
Release the ignition key as soon as
1. Select park or neutral.
2. Fully depress the brake pedal.
3. Start the engine.
the engine has started.
3. Gradually release the accelerator pedal
after five seconds of engine cranking
or as the engine speed rises.
If the engine fails to start, repeat steps 1, 2
and 3, or connect an engine block heater
for two hours before attempting another
start.
122
Mondeo (CA2) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 31-12-2014, CG3536en enGBR, Edition date: 11/2013
English 
