Get Driving -> Starting Guide for Ford Mustang 2 Door Fifth Generation (2005-2014)

STARTING

Positions of the ignition

1. Off — locks the automatic

transmission gearshift lever and

allows key removal.

Note: The ignition key cannot be

removed from the ignition unless

the gearshift lever is securely

latched in P (Park).

2. Accessory — allows the electrical

accessories such as the radio to

operate while the engine is not

running.

3. On — all electrical circuits operational. Warning lights illuminated. Key

position when driving.

4. Start — cranks the engine. Release the key as soon as the engine

starts.

Preparing to start your vehicle

Engine starting is controlled by the powertrain control system.

This system meets all Canadian interference-causing equipment standard

requirements regulating the impulse electrical field strength of radio

noise.

When starting a fuel-injected engine, don’t press the accelerator before

or during starting. Only use the accelerator when you have difficulty

starting the engine. For more information on starting the vehicle, refer to

Starting the engine in this chapter.

WARNING: Extended idling at high engine speeds can produce

very high temperatures in the engine and exhaust system,

creating the risk of fire or other damage.

WARNING: Do not park, idle, or drive your vehicle in dry grass

or other dry ground cover. The emission system heats up the

engine compartment and exhaust system, which can start a fire.

Driving

190

2010 05+ Mustang (197)

Owners Guide, 3rd Printing

USA (fus)

WARNING: Do not start your vehicle in a closed garage or in

other enclosed areas. Exhaust fumes can be toxic. Always open

the garage door before you start the engine. See Guarding against

exhaust fumes in this chapter for more instructions.

WARNING: If you smell exhaust fumes inside your vehicle, have

your dealer inspect your vehicle immediately. Do not drive if you

smell exhaust fumes.

Important safety precautions

A computer system controls the engine’s idle revolutions per minute

(RPM). When the engine starts, the idle RPM runs higher than normal in

order to warm the engine. If the engine idle speed does not slow down

automatically, have the vehicle checked. Do not allow the vehicle to idle

for more than 10 minutes at the higher engine RPM.

Before starting the vehicle:

1. Make sure all vehicle occupants have buckled their safety belts. For

more information on safety belts and their proper usage, refer to the

Seating and Safety Restraints chapter.

2. Make sure the headlamps and vehicle accessories are off.

If starting a vehicle with an automatic transmission:

• Make sure the gearshift is in P

(Park).

Driving

191

2010 05+ Mustang (197)

Owners Guide, 3rd Printing

USA (fus)

• Make sure the parking brake is

set.

If starting a vehicle with a manual transmission:

• Make sure the parking brake is

set.

• Push the clutch pedal to the floor

3. Turn the key to 3 (on) without

turning the key to 4 (start).

Some warning lights will briefly illuminate. See Warning lights and

chimes in the Instrument Cluster chapter for more information

regarding the warning lights.

Driving

192

2010 05+ Mustang (197)

Owners Guide, 3rd Printing

USA (fus)

Starting the engine

1. Turn the key to 3 (on) without

turning the key to 4 (start). If there

is difficulty in turning the key,

rotate the steering wheel until the

key turns freely.

2. Turn the key to 4 (start), then

release the key as soon as the

engine starts.

Note: If the engine does not start within five seconds on the first try,

turn the key to off, wait 10 seconds and try again. If the engine still fails

to start, press and hold the accelerator to the floor and try again; this

will allow the engine to crank with the fuel shut off in case the engine is

flooded with fuel.

Guarding against exhaust fumes

Carbon monoxide is present in exhaust fumes. Take precautions to avoid

its dangerous effects.

WARNING: If you smell exhaust fumes inside your vehicle, have

your dealer inspect your vehicle immediately. Do not drive if you

smell exhaust fumes.

Important ventilating information

If the engine is idling while the vehicle is stopped for a long period of

time, open the windows at least 1 inch (2.5 cm) or adjust the heating or

air conditioning to bring in fresh air.

ENGINE BLOCK HEATER (IF EQUIPPED)

An engine block heater warms the engine coolant which aids in starting

and allows the heater/defroster system to respond quickly. If your vehicle

is equipped with this system, your equipment includes a heater element

which is installed in your engine block and a wire harness which allows

the user to connect the system to a grounded 120 volt A/C electrical

source. The block heater system is most effective when outdoor

temperatures reach below 0°F (-18°C).

Driving

193

2010 05+ Mustang (197)

Owners Guide, 3rd Printing

USA (fus)

WARNING: Failure to follow engine block heater instructions

could result in property damage or physical injury.

WARNING: To reduce the risk of electrical shock, do not use

your heater with ungrounded electrical systems or two-pronged

(cheater) adapters.

Prior to using the engine block heater, follow these recommendations for

proper and safe operation:

• For your safety, use an outdoor extension cord that is product

certified by Underwriter’s Laboratory (UL) or Canadian Standards

Association (CSA). Use only an extension cord that can be used

outdoors, in cold temperatures, and is clearly marked “Suitable for Use

with Outdoor Appliances.” Never use an indoor extension cord

outdoors; it could result in an electric shock or fire hazard.

• Use a 16-gauge outdoor extension cord, minimum.

• Use as short an extension cord as possible.

• Do not use multiple extension cords. Instead, use one extension cord

which is long enough to reach from the engine block heater cord to

the outlet without stretching.

• Make certain that the extension cord is in excellent condition (not

patched or spliced). Store your extension cord indoors at

temperatures above 32°F (0°C). Outdoor conditions can deteriorate

extension cords over a period of time.

• To reduce the risk of electrical shock, do not use your heater with

ungrounded electrical systems or two pronged (cheater) adapters.

Also ensure that the block heater, especially the cord, is in good

condition before use.

• Make sure that when in operation, the extension cord plug/engine

block heater cord plug connection is free and clear of water in order

to prevent possible shock or fire.

• Be sure that areas where the vehicle is parked are clean and clear of

all combustibles such as petroleum products, dust, rags, paper and

Driving -> Starting for Your Ford Mustang 2 Door Fifth Generation (2005-2014)

Related Topics

Popular Owner Manuals

Latest Owner Manuals