2019-2024 Ford Puma SUV Crash and Breakdown Information -> Fail-Safe Cooling User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Crash and Breakdown Information -> Fail-Safe Cooling for Your Ford Puma SUV 2019-2024

Crash and Breakdown InformationSWITCHING THE HAZARDFLASHERS ON AND OFFWARNING: Use only adequatelysized cables with insulated hazard flasher button is onWARNING: Make sure that theE75790the instrument panel. Press thecables are clear of any moving parts andbutton to switch the hazardfuel delivery system on if your vehicle is creating asafety hazard for other road : Connect batteries withWhen you switch the hazard flashers on,only the same nominal front and rear direction indicators : If the engine is runningNote: The hazard flashers operate whenwhile the hood is open, stay clear ofthe ignition is in any position, or if the key ismoving engine components. Failure tonot in the ignition. The battery loses chargefollow this warning could result in seriousand could have insufficient power to restartpersonal injury or the button again to switch them not attempt to push-start an automatictransmission vehicle. This could causeJUMP STARTING THE VEHICLEtransmission not disconnect the battery of thedisabled vehicle. This could damage yourJUMP STARTING PRECAUTIONSvehicle's electrical THE VEHICLEWARNING: Batteries normallyproduce explosive gases which canUse only a 12 volt supply to start yourcause personal injury. Therefore, do flames, sparks or lightedsubstances to come near the the booster vehicle close to the hoodWhen working near the battery, alwaysof the disabled vehicle, making sure theshield your face and protect your vehicles do not provide correct STARTING THE VEHICLEWARNING: Keep batteries out ofreach of children. Batteries containsulfuric acid. Avoid contact with skin,eyes or clothing. Shield your eyes whenWARNING: Make sure that theworking near the battery to protectcables are clear of any moving parts andagainst possible splashing of acidfuel delivery system . In
Crash and Breakdown Information
SWITCHING THE HAZARD
FLASHERS ON AND OFF
WARNING: Use only adequately
sized cables with insulated clamps.
The hazard flasher button is on
WARNING: Make sure that the
E75790
the instrument panel. Press the
cables are clear of any moving parts and
button to switch the hazard
fuel delivery system parts.
flashers on if your vehicle is creating a
safety hazard for other road users.
WARNING: Connect batteries with
When you switch the hazard flashers on,
only the same nominal voltage.
all front and rear direction indicators flash.
WARNING: If the engine is running
Note: The hazard flashers operate when
while the hood is open, stay clear of
the ignition is in any position, or if the key is
moving engine components. Failure to
not in the ignition. The battery loses charge
follow this warning could result in serious
and could have insufficient power to restart
personal injury or death.
your vehicle.
Press the button again to switch them off.
Do not attempt to push-start an automatic
transmission vehicle. This could cause
JUMP STARTING THE VEHICLE
transmission damage.
Do not disconnect the battery of the
disabled vehicle. This could damage your
JUMP STARTING PRECAUTIONS
vehicle's electrical system.
PREPARING THE VEHICLE
WARNING: Batteries normally
produce explosive gases which can
Use only a 12 volt supply to start your
cause personal injury. Therefore, do not
vehicle.
allow flames, sparks or lighted
substances to come near the battery.
Park the booster vehicle close to the hood
When working near the battery, always
of the disabled vehicle, making sure the
shield your face and protect your eyes.
two vehicles do not touch.
Always provide correct ventilation.
JUMP STARTING THE VEHICLE
WARNING: Keep batteries out of
reach of children. Batteries contain
sulfuric acid. Avoid contact with skin,
eyes or clothing. Shield your eyes when
WARNING: Make sure that the
working near the battery to protect
cables are clear of any moving parts and
against possible splashing of acid
fuel delivery system parts.
solution. In case of acid contact with skin
or eyes, flush immediately with water for
Note: In the illustration, the bottom vehicle
a minimum of 15 minutes and get prompt
represents the booster vehicle.
medical attention. If acid is swallowed,
call a physician immediately.
338
Puma (CF7) Vehicles Built From: 27-03-2023, CG3833en enGBR, Edition date: 202301, First-Printing
Crash and Breakdown Information1E270780345. Start the engine of the booster vehicleand press the accelerator gently to2keep the engine speed between 2000and 3000 RPM.6. Start the engine of the disabled vehicle.7. Once the disabled vehicle has beenstarted, run both vehicle engines for anadditional three minutes beforedisconnecting the jumper the jumper cables in the reverseorder that they were connected.E142664Note: Do not switch the headlamps onSwitch off the engine and any electricalwhen disconnecting the cables. The could blow the bulbs.1.Connect the positive jumper cable tothe positive terminal of the dischargedPOST-CRASH ALERT SYSTEMbattery.2. Connect the other end of the positiveWHAT IS THE POST-CRASHjumper cable to the positive terminalALERT SYSTEMof the assisting battery.3. Connect the negative jumper cable toThe system helps draw attention to yourthe negative terminal of the assistingvehicle in the event of a serious .4. Make the final connection of theHOW DOES THE POST-CRASHnegative jumper cable to an exposedALERT SYSTEM WORKmetal part of the stalled vehicle'sengine, or connect the negative cableThe system is designed to turn the hazardto a ground connection point ifflashers on, turn the courtesy lamps on, sound the horn and unlockall doors in the event of a serious impactthat deploys an airbag or the seatbeltpretensioners.339Puma (CF7) Vehicles Built From: 27-03-2023, CG3833en enGBR, Edition date: 202301, First-Printing
Crash and Breakdown Information
1
E270780
3
4
5. Start the engine of the booster vehicle
and press the accelerator gently to
2
keep the engine speed between 2000
and 3000 RPM.
6. Start the engine of the disabled vehicle.
7. Once the disabled vehicle has been
started, run both vehicle engines for an
additional three minutes before
disconnecting the jumper cables.
Remove the jumper cables in the reverse
order that they were connected.
E142664
Note: Do not switch the headlamps on
Switch off the engine and any electrical
when disconnecting the cables. The peak
equipment.
voltage could blow the bulbs.
1.
Connect the positive jumper cable to
the positive terminal of the discharged
POST-CRASH ALERT SYSTEM
battery.
2. Connect the other end of the positive
WHAT IS THE POST-CRASH
jumper cable to the positive terminal
ALERT SYSTEM
of the assisting battery.
3. Connect the negative jumper cable to
The system helps draw attention to your
the negative terminal of the assisting
vehicle in the event of a serious impact.
battery.
4. Make the final connection of the
HOW DOES THE POST-CRASH
negative jumper cable to an exposed
ALERT SYSTEM WORK
metal part of the stalled vehicle's
engine, or connect the negative cable
The system is designed to turn the hazard
to a ground connection point if
flashers on, turn the courtesy lamps on,
available.
intermittently sound the horn and unlock
all doors in the event of a serious impact
that deploys an airbag or the seatbelt
pretensioners.
339
Puma (CF7) Vehicles Built From: 27-03-2023, CG3833en enGBR, Edition date: 202301, First-Printing

Related Topics

Popular Owner Manuals