Driving your vehicle -> SPECIAL DRIVING CONDITIONS for Your Hyundai I10 4 Door Second Generation (2013-2019)

Driving your vehicle  
SPECIAL DRIVING CONDITIONS  
Hazardous driving conditions  
When hazardous driving conditions are  
encountered such as water, snow, ice,  
mud or sand:  
Drive cautiously and allow extra distance  
for braking.  
Avoid sudden movements in braking or  
steering.  
Rocking the vehicle  
WARNING  
If it is necessary to rock the vehicle to  
free it from snow, sand, or mud, first turn  
the steering wheel right and left to clear  
the area around your front wheels. Then,  
shift back and forth between 1st and R  
(Reverse, for manual transaxle vehicle)  
or R (Reverse) and a forward gear (for  
automatic transaxle vehicle). Try to avoid  
spinning the wheels, and do not race the  
engine.  
To prevent transaxle wear, wait until the  
wheels stop spinning before shifting  
gears. Release the accelerator pedal  
while shifting, and press lightly on the  
accelerator pedal while the transaxle is in  
gear. Slowly spinning the wheels in for-  
ward and reverse directions causes a  
rocking motion that may free the vehicle.  
If the tires spin at high speed the  
tires can explode, and you or oth-  
ers may be injured. Do not attempt  
this procedure if people or objects  
are anywhere near the vehicle.  
The vehicle can overheat causing  
an engine compartment fire or  
other damage. Spin the wheels as  
little as possible and avoid spin-  
ning the wheels at speeds over 56  
km/h (35 mph) as indicated on the  
speedometer.  
If stuck in snow, mud, or sand, use sec-  
ond gear. Accelerate slowly to avoid spin-  
ning the drive wheels.  
WARNING  
Downshifting with an automatic  
transaxle, while driving on slippery  
surfaces can cause an accident.  
The sudden change in tire speed  
could cause the tires to skid. Be  
careful when downshifting on slip-  
pery surfaces.  
CAUTION  
If you are still stuck after rocking  
the vehicle a few times, have the  
vehicle pulled out by a tow vehicle  
to avoid engine overheating, possi-  
ble damage to the transaxle, and  
tire damage. See “Towing” in chap-  
ter 6.  
Use sand, rock salt, or other non-slip  
material under the drive wheels to pro-  
vide traction when stalled in ice, snow, or  
mud.  
To prevent damage to the transaxle,  
turn OFF the ESC (if equipped) prior  
to rocking the vehicle.  
5 34  
Driving your vehicle  
OLMB053041  
OCM053010  
OLMB053043  
Smooth cornering  
Driving at night  
Driving in the rain  
Night driving presents more hazards  
than driving in the daylight. Here are  
some important tips to remember:  
• Slow down and keep more distance  
between you and other vehicles, as it  
may be more difficult to see at night,  
especially in areas where there may  
not be any street lights.  
• Adjust your mirrors to reduce the glare  
from other driver's headlights.  
• Keep your headlights clean and prop-  
erly aimed. Dirty or improperly aimed  
headlights will make it much more diffi-  
cult to see at night.  
Avoid braking or gear changing in cor-  
ners, especially when roads are wet.  
Ideally, corners should always be taken  
under gentle acceleration.  
Rain and wet roads can make driving  
dangerous. Here are a few things to con-  
sider when driving in the rain or on slick  
pavement:  
• Slow down and allow extra following  
distance. A heavy rainfall makes it  
harder to see and increases the dis-  
tance needed to stop your vehicle.  
• Replace your windshield wiper blades  
when they show signs of streaking or  
missing areas on the windshield.  
• Avoid staring directly at the headlights  
of oncoming vehicles. You could be  
temporarily blinded, and it will take  
several seconds for your eyes to read-  
just to the darkness.  
5 35  
Driving your vehicle  
• Be sure your tires have enough tread.  
If your tires do not have enough tread,  
making a quick stop on wet pavement  
can cause a skid and possibly lead to  
an accident. See “Tire Tread” in chap-  
ter 7.  
Turn on your headlights to make it eas-  
ier for others to see you.  
• Driving too fast through large puddles  
can affect your brakes. If you must go  
through puddles, try to drive through  
them slowly.  
Hydroplaning  
Driving in flooded areas  
If the road is wet enough and you are  
going fast enough, your vehicle may have  
little or no contact with the road surface  
and actually ride on the water. The best  
advice is SLOW DOWN when the road is  
wet. The risk of hydroplaning increases  
as the depth of tire tread decreases, refer  
to “Tire Tread” in chapter 7.  
Avoid driving through flooded areas  
unless you are sure the water is no high-  
er than the bottom of the wheel hub.  
Drive through any water slowly. Allow  
adequate stopping distance because  
brake performance may be reduced.  
After driving through water, dry the  
brakes by gently applying them several  
times while the vehicle is moving slowly.  
• If you believe your brakes may be wet,  
apply them lightly while driving until  
normal braking operation returns.  
5 36