2004-2010 Kia Sportage SUV Driving your vehicle -> Manual climate control system User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Driving your vehicle -> Manual climate control system for Your Kia Sportage SUV Second Generation (2004-2010)

Driving your vehicle
MANUAL CLIMATE CONTROL SYSTEM (IF EQUIPPED)
1
2
3
4
5
6
7
8
9
1. Fan speed control knob
4. Air conditioning button (if equipped)
2. Mode selection knob
5. Air intake control button
3. Temperature control knob
6. Rear window defroster button
1KMN2130
4 66
Driving your vehicle
1
2
3
4
1KMN2136
1KMN2134
1KMN2135A
Fan speed control knob
Temperature control knob
Mode selection knob
5
The ignition switch must be in the ON
The temperature control knob allows
The mode selection knob controls
position for fan operation.
you to control the temperature of the
the direction of the air flow through
air flowing from the ventilation sys-
the ventilation system.
The fan speed control knob allows
6
tem. To change the air temperature in
you to control the fan speed of the air
The steps (•) between the air flow posi-
the passenger compartment, turn
flowing from the ventilation system.
tions adjust the direction of the air flow
the knob to the right for warm and
7
To change the fan speed, turn the
to the middle position.
hot air or left for cooler air.
knob to the right for higher speed or
left for lower speed.
8
Setting the mode selection knob to
the OFF position turns off the fan.
9
4 67
Driving your vehicle
MAX/ A/C position
MAX When
you select the MAX
A/C mode while the fan
A/C speed is on, the following
1
system settings will be
made automatically;
2
• the air conditioning sys-
tem will be turned on.
3
• the recirculated air posi-
tion will be selected.
4
• the face mode will be
selected.
If you select MAX A/C
5
mode, you will not be able
to cancel the A/C system
operation, or change the
6
recirculated air mode posi-
tion.
7
Set the fan speed control
knob to the desired speed
and rotate the tempera-
8
ture control knob to the
extreme left position for
9
maximum cooling.
(outlet port: B , E )
1KMB2134
4 68
Driving your vehicle
Face position
Floor position
Air flow is directed toward
Most of the air flow is
the upper body and face.
directed to the floor, with a
1
Additionally, each outlet
small amount of the air
can be controlled to direct
being directed to the wind-
the air discharged from
shield and side window
2
the outlet.
defroster.
(outlet port: B , E )
(outlet port: A , C , D , E , F )
3
Face - floor position
Floor - defrost position
Air flow is directed
Most of the air flow is
towards the face and the
directed to the floor and
4
1KMA2132
floor. The air to the floor is
the windshield with a
Instrument panel vents
warmer than the air to the
small amount directed to
face (except when the
the
side
window
5
If air flow control is not satisfactory,
temperature control is set
defrosters.
check the instrument panel vents.
to the extreme cold posi-
(outlet port: A , C , D , E , F )
The outlet port ( B , E ) can be opened
6
tion).
or closed separately using the hori-
Defrost position
(outlet port: B , C , E , F )
zontal thumbwheel. To close the
Most of the air flow is
vent, rotate it left to the maximum
OFF position
7
directed to the windshield
position. To open the vent, rotate it
The climate control sys-
with a small amount of air
right to the desired position.
OFF tem is turned off.
directed to the side win-
8
Also, you can adjust the direction of
dow defrosters.
air delivery from these vents using
(outlet port: A , D , E )
the vent control lever as shown.
9
4 69
Driving your vehicle
Recirculated air position
Outside (fresh) air position
The indicator light on the
The indicator light on the
button is illuminated when
button is not illuminated
1
the recirculated air posi-
when the outside (fresh)
tion is selected.
air position is selected.
With the recirculated air
With the outside (fresh) air
2
position selected, air from
position selected, air
passenger compartment
enters the vehicle from
3
will be drawn through the
outside and is heated or
heating system and heat-
cooled according to the
ed or cooled according to
function selected.
4
1KMN2135
the function selected.
Air intake control button
5
This is used to select outside (fresh)
air position or recirculated air posi-
tion.
6
To change the air intake control posi-
tion, push the control button.
7
8
9
4 70
Driving your vehicle
It should be noted that prolonged
WARNING - Recirculated
operation of the heating in recir-
culated air position will cause fog-
air
ging of the windshield and side
1
• Continued climate control
windows and the air within the
system operation in the recir-
passenger compartment will
culated air position may allow
2
become stale.
humidity to increase inside
In addition, prolonged use of the
vehicle which may fog the
air conditioning with the “recircu-
glass and obscure visibility.
3
lated air position” selected, will
• Continued climate control
result in excessively dry air in the
system operation in the recir-
4
passenger compartment.
culated air position can result
1KMN2137
in somewhat reduced oxygen
Air conditioning button
levels, causing drowsiness or
(if equipped)
5
sleepiness, and loss of vehicle
Push the A/C button to turn the air
control. Set the air intake con-
conditioning system on (indicator
trol to the outside (fresh) air
6
light will illuminate). Push the button
position as much as possible
again to turn the air conditioning sys-
while driving.
tem off.
7
8
9
4 71
Driving your vehicle
System operation
Heating
Air conditioning (if equipped)
1. Set the mode to the
position.
All Kia Air Conditioning Systems are
Ventilation
filled with environmentally friendly
2. Set the air intake control to the
1. Set the mode to the
position.
1
R-134a refrigerant which is not dam-
outside (fresh) air position.
2. Set the air intake control to the
aging to the ozone layer.
3. Set the temperature control to the
outside (fresh) air position.
1. Start the engine. Push the air con-
2
desired position.
3. Set the temperature control to the
ditioning button.
4. Set the fan speed control to the
desired position.
2. Set the mode to the
position.
desired speed.
3
4. Set the fan speed control to the
3. Set the air intake control to the
5. If dehumidified heating is desired,
desired speed.
outside air or recirculated air posi-
turn the air conditioning system (if
4
tion.
equipped) on.
4. Set the temperature control knob
• If cool air is desired at face level for
to the desired position.
bi-level operation, set the mode to
5
the
position.
5. Set the fan speed control to the
desired speed.
• If the windshield fogs up, set the
6
mode to the
,
position.
6. Adjust the fan speed control and
temperature control to maintain
maximum comfort.
7
• If warmer air is desired at floor
level for bi-level operation, set the
8
mode to the
position and
adjust the temperature control to
maintain maximum comfort.
9
4 72
Driving your vehicle
• When maximum cooling is desired,
Air conditioning system oper-
• The air conditioning system
set the temperature control to the
ation tips
includes a function that automati-
extreme left position, set the air
cally turns the air conditioning
• If the vehicle has been parked in
intake control to the recirculated air
compressor off if engine coolant
1
direct sunlight during hot weather,
position, then set the fan speed
temperature approaches an over
open the windows for a short time
control to the highest speed.
heating level. The air conditioning
to let the hot air inside the vehicle
2
compressor operation will resume
escape.
once engine coolant temperature
✽ NOTICE
• To help reduce moisture inside of
returns to the normal range. Also,
3
• When using the air conditioning
windows on rainy humid days,
the air conditioning compressor is
system, monitor the temperature
decrease the humidity inside the
automatically turned off for a few
gauge closely while driving up
vehicle by operating the air condi-
seconds when the accelerator is
4
hills or in heavy traffic when out-
tioning system.
fully depressed (wide open throt-
side temperatures are high. Air
tle).
• During air conditioning system
conditioning system operation
5
operation, you may occasionally
• When operating the air condition-
may cause engine overheating.
notice a slight change in engine
ing system use the outside (fresh)
Continue to use the blower fan but
speed at idle as the air condition-
air position.
6
turn the air conditioning system
ing compressor cycles on. This is a
• Operating the air conditioning sys-
off if the temperature gauge indi-
normal system operation charac-
tem in the recirculated air position
cates engine overheating.
teristics.
7
does provide maximum cooling,
• When opening the windows in
• Use the air conditioning system
however, continual operation in this
humid weather air conditioning
every month if only for a few min-
mode may cause the air inside the
may create water droplets inside
8
utes to ensure maximum system
vehicle to become stale.
the vehicle. Since excessive water
performance.
droplets may cause damage to
• When using the air conditioning
9
electrical equipment, air condi-
system, you may notice clear water
tioning should only be run with
dripping (or even pudding) on the
the windows closed.
ground under the passenger side
of the vehicle. This is a normal sys-
tem operation characteristics.
4 73
Driving your vehicle
Checking the amount of air
CAUTION
conditioner refrigerant and
The air conditioner refrigerant
compressor lubricant
container is highly pressurized.
1
When the amount of refrigerant is
Therefore it should be serviced
low, the performance of the air con-
by an authorized Kia dealer.
ditioning is reduced. Overfilling also
2
Improper service may cause
has a bad influence on the air condi-
serious injury.
tioning system.
3
Therefore, if abnormal operation is
found, have the system inspected by
✽ NOTICE
an authorized Kia dealer.
4
When the performance of the air
conditioning system is reduced it is
important that the correct type and
5
amount of oil and refrigerant is
used. Otherwise, damage to the
compressor and abnormal system
6
operation may occur.
7
8
9
4 74

Related Topics

Popular Owner Manuals