2024-2026 Lexus LBX SUV When trouble arises -> If the 12-volt battery is discharged User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

When trouble arises -> If the 12-volt battery is discharged for Your Lexus LBX SUV First Generation (2024-2026)

533
7
7-2. Steps to take in an emergency
When trouble arises
If you have a set of jumper (or booster)
cables and a second vehicle with a 12-
volt battery, you can jump start your
vehicle by following the steps below.
1 Confirm that the electronic key is
being carried.
When connecting the jumper (or booster)
cables, depending on the situation, the
alarm may activate and the doors may
lock. (P.88)
2 Open the hood (P.445) and
fuse box cover.
3 Open the exclusive jump starting
terminal cover.
4 Connect a positive jumper cable clamp to on your vehicle and connect the
clamp on the other end of the positive cable to on the second vehicle. Then,
connect a negative cable clamp to on the second vehicle and connect the
clamp at the other end of the negative cable to .
If the 12-volt battery is dis-
charged
The following procedures may be
used to start the hybrid system if the
vehicle’s 12-volt battery is dis-
charged.
You can also call any authorized
Lexus retailer or Lexus authorized
repairer, or any reliable repairer.
Restarting the hybrid system
A
B
C
D
534
7-2. Steps to take in an emergency
Use jumper cables that can reach the specified terminals and connecting point.
Exclusive jump starting terminal (your vehicle)
Positive (+) battery terminal (second vehicle)
Negative (-) battery terminal (second vehicle)
Metallic point shown in the illustration
5 Start the engine of the second vehi-
cle. Increase the engine speed
slightly and maintain at that level for
approximately 5 minutes to
recharge the 12-volt battery of your
vehicle.
6 Vehicles with steering lock system:
Open and close any of the doors of
your vehicle with the power switch
OFF.
7 Maintain the engine speed of the
second vehicle and start the hybrid
system of your vehicle by turning
the power switch to ON.
8 Make sure the “READY” indicator
comes on. If the indicator light does
not come on, contact any autho-
rized Lexus retailer or Lexus autho-
rized repairer, or any reliable
repairer.
9 Once the hybrid system has
started, remove the jumper cables
in the exact reverse order from
which they were connected.
10 Close the exclusive jump starting
terminal cover, and reinstall the
fuse box cover to its original posi-
tion.
Once the hybrid system starts, have
the vehicle inspected at any authorized
Lexus retailer or Lexus authorized
repairer, or any reliable repairer as
soon as possible.
■ Starting the hybrid system when the 12-
volt battery is discharged
The hybrid system cannot be started by
A
B
C
D
535
7
7-2. Steps to take in an emergency
When trouble arises
push-starting.
■ If the doors cannot be unlocked using
the smart entry & start system or wire-
less remote control
The doors can be opened by enabling its
respective manual release handle opera-
tion. (P.532)
■ Locking the doors after the 12-volt bat-
tery was discharged
The doors cannot be locked using the smart
entry & start system or wireless remote
control.
By locking the door using the mechanical
key, the operation of the manual release
handle can be disabled.
Driver’s door
1 Insert a plastic card, etc. into the gap in
the door handle to pry up the cover.
To avoid damage, do not apply excessive
force to the cover.
2 Remove the cover by pressing it on the
rear.
3 Using the mechanical key, turn the lock
cylinder to the lock side to lock the
door.
4 Check that the door cannot be opened.
Doors other than the driver’s door
1 Open the door. Using the mechanical
key, slide the cover in the direction
shown in the illustration.
To avoid damage, do not apply excessive
force to the cover.
2 Insert the mechanical key into the open-
ing.
3 Remove the mechanical key and slide
the cover back to its original position.
4 Check that all of the doors cannot be
opened.
536
7-2. Steps to take in an emergency
■ To prevent 12-volt battery discharge
● Turn off the headlights and the air condi-
tioning system while the hybrid system is
stopped.
● Turn off any unnecessary electrical com-
ponents when the vehicle is running at a
low speed for an extended period, such
as in heavy traffic.
● When ACC customization is in off,
power is still provided to the multimedia
system even though the power switch is
off.
To turn off the multimedia system, use the
multimedia system power switch. For
details, refer to the Multimedia Owner’s
Manual.
■ When the 12-volt battery is removed or
discharged
● Information stored in the ECU is cleared.
When the 12-volt battery is depleted,
have the vehicle inspected at any autho-
rized Lexus retailer or Lexus authorized
repairer, or any reliable repairer.
● Some systems may require initialization.
(P.572)
■ When removing the 12-volt battery ter-
minals
● When the 12-volt battery terminals are
removed, the information stored in the
ECU is cleared. Before removing the 12-
volt battery terminals, contact any autho-
rized Lexus retailer or Lexus authorized
repairer, or any reliable repairer as soon
as possible.
● If a 12-volt battery terminal is discon-
nected, the doors will not be able to be
opened using the door opener switches
and the electronic key may become
trapped in the vehicle.
To prevent the electronic key (mechanical
key) from being locked inside the vehicle,
make sure to remove it from the vehicle
before disconnecting a 12-volt battery ter-
minal.
● If the electronic key (mechanical key) is
to be left in the vehicle, make sure to
open a window so an inside manual
release handle can be operated.
■ Charging the 12-volt battery
The electricity stored in the 12-volt battery
will discharge gradually even when the
vehicle is not in use, due to natural dis-
charge and the draining effects of certain
electrical appliances. If the vehicle is left for
a long time, the 12-volt battery may dis-
charge, and the hybrid system may be
unable to start. (The 12-volt battery
recharges automatically during driving.)
■ When recharging or replacing the 12-
volt battery
● In some cases, it may not be possible to
unlock the doors using the smart entry &
start system when the 12-volt battery is
discharged. Use the wireless remote
control or the mechanical key to lock or
unlock the doors.
● The hybrid system may not start on the
first attempt after the 12-volt battery has
recharged but will start normally after the
second attempt. This is not a malfunction.
● The power switch mode is memorized by
the vehicle. When the 12-volt battery is
reconnected, the system will return to the
mode it was in before the 12-volt battery
was discharged. Before disconnecting
the 12-volt battery, turn the power switch
537
7
7-2. Steps to take in an emergency
When trouble arises
off.
If you are unsure what mode the power
switch was in before the 12-volt battery
discharged, be especially careful when
reconnecting the 12-volt battery.
● If the 12-volt battery discharges, it may
not be possible to shift the shift position to
other positions. In this case, the vehicle
cannot be towed without lifting both front
wheels because the front wheels will be
locked.
● Some systems may require initialization.
(P.556)
■ When replacing the 12-volt battery
● Use a Central Degassing type 12-volt
battery (European Regulations).
● Use a 12-volt battery that the case size is
same as the previous one (LN0), 20
hour rate capacity (20HR) is equivalent
(39Ah) or greater, and performance rat-
ing (CCA) is equivalent (240A)or
greater.
• If the sizes differ, the 12-volt battery can-
not be properly secured.
• If an improper 12-volt battery is used, 12-
volt battery performance may decrease
and the hybrid system may not be able to
restart.
• If the 20 hour rate capacity is low, even if
the time period where the vehicle is not
used is a short time, the 12-volt battery
may discharge and hybrid system may
not be able to start.
● Use a ventilation type calcium battery.
● Use a 12-volt battery with a handle. If a
12-volt battery without a handle is used,
removal is more difficult.
● After exchanging, firmly attach the fol-
lowing items to the exhaust hole of the
12-volt battery.
• Use the exhaust hose that was attached
to the 12-volt battery before replacing
and confirm that it is firmly connected to
the hole section of the vehicle.
• Use the exhaust hole plug included with
the 12-volt battery replaced or the one
installed on the 12-volt battery prior to
the replacement. (Depending on the 12-
volt battery to be replaced, the exhaust
hole may be plugged.)
Exhaust hole
Exhaust hose
Hole section of the vehicle
For details, consult with at any authorized
Lexus retailer or Lexus authorized repairer,
or any reliable repairer as soon as possible.
WARNING
■ When removing the 12-volt battery
terminals
Always remove the negative (-) terminal
first. If the positive (+) terminal contacts
any metal in the surrounding area when
the positive (+) terminal is removed, a
spark may occur, leading to a fire in addi-
tion to electrical shocks and death or
serious injury.
■ Avoiding 12-volt battery fires or
explosions
Observe the following precautions to
prevent accidentally igniting the flamma-
ble gas that may be emitted from the 12-
volt battery:
● Make sure each jumper cable is con-
nected to the correct terminal and that
it is not unintentionally in contact with
any other than the intended terminal.
● Do not allow the other end of the
jumper cable connected to the “+” ter-
minal to come into contact with any
other parts or metal surfaces in the
area, such as brackets or unpainted
metal.
A
B
C
538
7-2. Steps to take in an emergency
WARNING
● Do not allow the + and - clamps of the
jumper cables to come into contact
with each other.
● Do not smoke, use matches, cigarette
lighters or allow open flame near the
12-volt battery.
■ 12-volt battery precautions
The 12-volt battery contains poisonous
and corrosive acidic electrolyte, while
related parts contain lead and lead com-
pounds. Observe the following precau-
tions when handling the 12-volt battery:
● When working with the 12-volt battery,
always wear safety glasses and take
care not to allow any 12-volt battery
fluids (acid) to come into contact with
skin, clothing or the vehicle body.
● Do not lean over the 12-volt battery.
● In the event that 12-volt battery fluid
(acid) comes into contact with the skin
or eyes, immediately wash the affected
area with water and seek medical
attention.
Place a wet sponge or cloth over the
affected area until medical attention
can be received.
● Always wash your hands after han-
dling the 12-volt battery and other bat-
tery-related parts.
● Do not allow children near the 12-volt
battery.
■ After recharging the 12-volt battery
Have the 12-volt battery inspected at any
authorized Lexus retailer or Lexus
authorized repairer, or any reliable
repairer as soon as possible.
If the 12-volt battery is deteriorating, con-
tinued use may cause the 12-volt battery
to emit a malodorous gas, which may be
detrimental to the health of passengers.
■ When replacing the 12-volt battery
● For information regarding 12-volt bat-
tery replacement, contact any autho-
rized Lexus retailer or Lexus
authorized repairer, or any reliable
repairer.
● After replacing, securely attach the
exhaust hose and exhaust hole plug to
the exhaust hole of the replaced 12-
volt battery. If not properly installed,
gases (hydrogen) may leak into the
vehicle interior, and there is the possi-
ble danger of the gas igniting and
exploding.
NOTICE
■ When handling jumper cables
When connecting the jumper cables,
ensure that they do not become entan-
gled in the cooling fans or belt.
■ When connecting jumper cables
Make sure to connect jumper cables to
the specified terminals and connecting
point. Failure to do so may adversely
affect the electronic devices or damage
to them.
539
7
7-2. Steps to take in an emergency
When trouble arises
If the engine coolant temperature
gauge enters the red zone or
“Engine Coolant Temp High Stop in
a Safe Place See Owner’s Manual”
is shown on the multi-information
display
1 Stop the vehicle in a safe place and
turn off the air conditioning system,
and then stop the hybrid system.
2 If you see steam:
Carefully lift the hood after the
steam subsides.
If you do not see steam:
Carefully lift the hood.
3 After the hybrid system has cooled
down sufficiently, inspect the hoses
NOTICE
■ To prevent damaging the vehicle
The exclusive jump starting terminal is to
be used when charging the 12-volt bat-
tery from another vehicle in an emer-
gency. It cannot be used to jump start
another vehicle.
If your vehicle overheats
The following may indicate that
your vehicle is overheating.
The engine coolant temperature
gauge (P.97, 103) enters the
red zone, or a loss of hybrid sys-
tem power is experienced. (For
example, the vehicle speed does
not increase.)
“Engine Coolant Temp High Stop
in a Safe Place See Owner’s
Manual” or “Hybrid System
Overheated Reduced Output
Power” is shown on the multi-
information display.
Steam comes out from under the
hood.
Correction procedures

Related Topics

Popular Owner Manuals