● Connect the valve and hose securely
with the tire installed on the vehicle.
If the hose is not properly connected to
the valve, air leakage may occur as seal-
ant may be sprayed out.
● If the hose comes off the valve while
inflating the tire, there is a risk that the
hose will move abruptly due to air
pressure.
● After inflation of the tire has com-
pleted, the sealant may splatter when
the hose is disconnected or some air is
let out of the tire.
● Follow the operation procedure to
repair the tire. If the procedures not
followed, the sealant may spray out.
● Keep back from the tire while it is
being repaired, as there is a chance of
it bursting while the repair operation is
being performed. If you notice any
cracks or deformation of the tire, turn
off the compressor switch and stop the
repair operation immediately.
● The repair kit may overheat if oper-
ated for a long period of time. Do not
operate the compressor continuously
for more than 40 minutes.
● Parts of the repair kit become hot
during operation. Be careful handling
the repair kit during and after opera-
tion. Do not touch the metal part con-
necting the bottle and the compressor.
It will be extremely hot.
● Do not attach the vehicle speed warn-
ing sticker to an area other than the
one indicated. If the sticker is attached
to an area where an SRS airbag is
located, such as the pad of the steering
wheel, it may prevent the SRS airbag
from operating properly.
■ Driving to spread the liquid sealant
evenly
Observe the following precautions to
reduce the risk of accidents.
Failing to do so may result in a loss of
vehicle control and cause death or seri-
ous injury.
● Drive the vehicle carefully at a low
speed. Be especially careful when
turning and cornering.
● If the vehicle does not drive straight or
you feel a pull through the steering
wheel, stop the vehicle and check the
following:
• Tire condition. The tire may have sepa-
rated from the wheel.
• Tire inflation pressure. If the tire infla-
tion pressure is 130 kPa (1.3 kgf/cm
2
or bar, 19 psi) or less, the tire may be
severely damaged.
■ When performing an emergency
repair
● Perform the emergency repair without
removing the nail or screw that has
punctured the tread of the tire. If the
object that has punctured the tire is
removed, repair by the emergency tire
puncture repair kit may not be possi-
ble.
● The repair kit is not waterproof. Make
sure that the repair kit is not exposed
to water, such as when it is being used
in the rain.
● Do not put the repair kit directly onto
dusty ground such as sand at the side
of the road. If the repair kit vacuums up
dust, etc., a malfunction may occur.
● Make sure the sealant bottle of the
repair kit is in a vertical position. The
repair kit does not operate properly
when it is laid.