2019-2026 Lexus UX SUV Do-it-yourself maintenance -> Replacing the tire User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Do-it-yourself maintenance -> Replacing the tire for Your Lexus UX SUV First Generation (2019-2026)

380
6-3. Do-it-yourself maintenance
Stop the vehicle in a safe place on a
hard, flat surface.
Set the parking brake.
Shift the shift lever to P.
Stop the hybrid system.
2WD models
Towing eyelet
Jack
*
/Jack handle
*
/Wheel nut wrench
*
*
: They can be purchased at your Lexus dealer.
Replacing the tire
When replacing the tires yourself,
prepare the necessary tools and a
jack.
If necessary tire replacement
seems difficult to perform, contact
your Lexus dealer.
Before jacking up the vehicle
Location of the jack and tools
A
B
381
6-3. Do-it-yourself maintenance
6
Maintenance and care
AWD models
Towing eyelet
Jack
*
/Jack handle
*
/Wheel nut wrench
*
*
: They can be purchased at your Lexus dealer.
A
B
WARNING
■ Using the tire jack
Observe the following precautions.
Improper use of the tire jack may cause
the vehicle to suddenly fall off the jack,
leading to death or serious injury.
● Do not use the tire jack for any pur-
pose other than replacing tires or
installing and removing tire chains.
● Only use the tire jack that comes with
this vehicle for replacing a flat tire. Do
not use it on other vehicles, and do not
use other tire jacks for replacing tires
on this vehicle.
● Put the jack properly in its jack point.
● Do not put any part of your body under
the vehicle while it is supported by the
jack.
● Do not start the hybrid system or drive
the vehicle while the vehicle is sup-
ported by the jack.
● Do not raise the vehicle while some-
one is inside.
● When raising the vehicle, do not put an
object on or under the jack.
● Do not raise the vehicle to a height
greater than that required to replace
the tire.
● Use a jack stand if it is necessary to get
under the vehicle.
● When lowering the vehicle, make sure
that there is no-one near the vehicle. If
there are people nearby, warn them
vocally before lowering.
382
6-3. Do-it-yourself maintenance
1 Chock the tires.
2 Slightly loosen the wheel nuts (one
turn).
3 Turn the tire jack portion by
hand until the notch of the jack is in
contact with the jack point.
The jack point guides are located under
the rocker panel. They indicate the jack
point positions.
4 Install the wheel nut wrench in jack
handle.
5 Raise the vehicle until the tire is
slightly raised off the ground.
6 Remove all the wheel nuts and the
tire.
When resting the tire on the ground, place
the tire so that the wheel design faces up to
Removing a tire
Tire Wheel chock positions
Front left-hand
side
Behind the rear right-
hand side tire
Front right-hand
side
Behind the rear left-
hand side tire
Rear left-hand
side
In front of the front
right-hand side tire
Rear right-hand
side
In front of the front left-
hand side tire
A
383
6-3. Do-it-yourself maintenance
6
Maintenance and care
avoid scratching the wheel surface.
1 Remove any dirt or foreign matter
from the wheel contact surface.
If foreign matter is on the wheel contact
surface, the wheel nuts may loosen while
the vehicle is in motion, causing the tire to
come off.
2 Install the tire and loosely tighten
each wheel nut by hand by approxi-
mately the same amount.
Turn the wheel nuts until the washers come
into contact with the disc wheel.
Disc wheel
Washer
3 Lower the vehicle.
4
Securely tighten the wheel nuts two
or three times in the order shown in
the illustration using a wheel nut
wrench.
WARNING
■ Replacing a tire
Do not touch the disc wheels or the area
around the brakes immediately after the
vehicle has been driven.
After the vehicle has been driven the disc
wheels and the area around the brakes
will be extremely hot. Touching these
areas with hands, feet or other body
parts while changing a tire, etc. may
result in burns.
■ Replacing a tire for vehicles with
power back door
In cases such as when replacing tires,
make sure to cancel the power back
door system (P.137). Failure to do so
may cause the back door to operate
unintentionally if the power back door
switch is accidentally touched, resulting
in hands and fingers being caught and
injured.
Installing the tire
A
B
384
6-3. Do-it-yourself maintenance
Tightening torque:
76 ft•lbf (103 N•m, 10.5 kgf•m)
5
Stow the tire jack and all tools.
WARNING
■ When installing the tire
Failure to follow these precautions could
cause the wheel nuts to loosen and the
tire to fall off, resulting in death or serious
injury.
● Never use oil or grease on the wheel
bolts or wheel nuts.
Oil and grease may cause the wheel
nuts to be excessively tightened, lead-
ing to bolt or disc wheel damage.
Remove any oil or grease that has
adhered when installing the wheel
nuts.
● Have the wheel nuts tightened with a
torque wrench to 76 ft•lbf (103 N•m,
10.5 kgf•m) as soon as possible after
changing wheels.
● After replacing a tire, check the tight-
ening torque as soon as possible. If you
cannot confirm the tightening torque
yourself, have the vehicle inspected at
your Lexus dealer.
● Do not attach a heavily damaged
wheel ornament, as it may fly off the
wheel while the vehicle is moving.
● When installing a tire, only use wheel
nuts that have been specifically
designed for that wheel.
● If there are any cracks or deformations
in the bolt screws, nut threads or bolt
holes of the wheel, have the vehicle
inspected by your Lexus dealer.
● Do not attach a heavily damaged
wheel ornament, as it may fly off the
wheel while the vehicle is moving.
■ After using the tools and jack (if
equipped)
Before driving, make sure all the tools
and jack are stored securely in place.
Failure to do so may cause injury in case
of a collision or sudden braking.
NOTICE
■ Repairing or replacing tires, wheels,
tire pressure warning valves, trans-
mitters and tire valve caps
P.373

Related Topics

Popular Owner Manuals