
88
2-1. Instrument cluster
and a driving mode other than Eco drive
mode is selected
● The hybrid system indicator will be dis-
played in the following situations.
• When the meter display type setting is set
to display type 1 or display type 3
• When the tachometer setting is set to
always display the hybrid system indica-
tor
• When the tachometer setting is set to
change according to the driving mode
and Eco drive mode is selected
■ Engine speed
On hybrid electric vehicles, engine speed is
precisely controlled in order to help
improve fuel efficiency and reduce exhaust
emissions etc.
There are times when the engine speed that
is displayed may differ even when vehicle
operation and driving conditions are the
same.
■ Outside temperature display
● In the following situations, the correct
outside temperature may not be dis-
played, or the display may take longer
than normal to change:
• When stopped, or driving at low speeds
(less than 12 mph [20 km/h])
• When the outside temperature has
changed suddenly (at the entrance/exit
of a garage, tunnel, etc.)
● When “--” or “E” is displayed, the system
may be malfunctioning. Take your vehicle
to your Lexus dealer.
■ Liquid crystal display
Small spots or light spots may appear on the
display. This phenomenon is characteristic
of liquid crystal displays, and there is no
problem continuing to use the display.
■ Display items
Odometer
Displays the total distance the vehicle has
been driven.
Trip meter A/trip meter B
Displays the distance the vehicle has been
driven since the meter was last reset. Trip
meters A and B can be used to record and
WARNING
■ The information display at low tem-
peratures
Allow the interior of the vehicle to warm
up before using the liquid crystal infor-
mation display. At extremely low tem-
peratures, the information display
monitor may respond slowly, and display
changes may be delayed.
For example, there is a lag between the
driver’s shifting and the new gear num-
ber appearing on the display. This lag
could cause the driver to downshift
again, causing rapid and excessive
engine braking and possibly an accident
resulting in death or injury.
NOTICE
■ To prevent damage to the engine and
its components
● Do not let the indicator needle of the
tachometer enter the red zone, which
indicates the maximum engine speed.
● The engine may be overheating if the
engine coolant temperature gauge is
in the red zone (H); or “Engine Cool-
ant Temp High Stop in a Safe Place
See Owner’s Manual” is shown on the
multi-information display. In this case,
immediately stop the vehicle in a safe
place, and check the engine after it has
cooled completely. (P.436)
Odometer and trip meter dis-
play