2019-2026 Lexus UX SUV Maintenance and care -> Cleaning and protecting the vehicle exterior User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Maintenance and care -> Cleaning and protecting the vehicle exterior for Your Lexus UX SUV First Generation (2019-2026)

346
6-1. Maintenance and care
6-1.Maintenance and care
Working from top to bottom, liber-
ally apply water to the vehicle body,
wheel wells and underside of the
vehicle to remove any dirt and dust.
Wash the vehicle body using a
sponge or soft cloth, such as a
chamois.
For hard-to-remove marks, use car
wash soap and rinse thoroughly with
water.
Wipe away any water.
Wax the vehicle when the water-
proof coating deteriorates.
If water does not bead on a clean surface,
apply wax when the vehicle body is cool.
■ Self-restoring coat
The vehicle body has a self-restoring coat-
ing that is resistant to small surface
scratches caused in a car wash etc.
● The coating lasts for 5 to 8 years from
when the vehicle is delivered from the
plant.
● The restoration time differs depending on
the depth of the scratch and outside tem-
perature. The restoration time may
become shorter when the coating is
warmed by applying warm water.
● Deep scratches caused by keys, coins,
etc. cannot be restored.
● Do not use wax that contain abrasives.
■ Automatic car washes
● Before washing the vehicle:
• Fold the mirrors
• Turn off the power back door (if
equipped)
Start washing from the front of the vehicle.
Extend the mirrors before driving.
● Brushes used in automatic car washes
may scratch the vehicle surface, parts
(wheel, etc.) and harm your vehicle’s
paint.
● Rear spoiler may not be washable in
some automatic car washes. There may
also be an increased risk of damage to
vehicle.
● When the shift position needs to be held
in N, refer to P.188
■ High pressure car washes
As water may enter the cabin, do not bring
the nozzle tip near the gaps around the
doors or perimeter of the windows, or spray
these areas continuously.
■ Note for a smart access system with
push-button start
● If the door handle becomes wet while the
electronic key is within the effective
range, the door may lock and unlock
repeatedly. In that case, follow the follow-
ing correction procedures to wash the
vehicle:
• Place the key in a position 6 ft. (2 m) or
more separate from the vehicle while the
vehicle is being washed. (Take care to
ensure that the key is not stolen.)
• Set the electronic key to battery-saving
mode to disable the smart access system
with push-button start. (P.140)
● If the electronic key is inside the vehicle
and a door handle becomes wet during a
car wash, a buzzer may sound outside the
vehicle and “Key Detected in Vehicle”
may be shown on the multi-information
display. To turn off the alarm, lock all the
doors.
■ Wheels and wheel ornaments
● Remove any dirt immediately by using a
neutral detergent.
● Wash detergent off with water immedi-
Cleaning and protecting the
vehicle exterior
Perform cleaning in a manner
appropriate to each component
and its material.
Cleaning instructions
347
6-1. Maintenance and care
6
Maintenance and care
ately after use.
● To protect the paint from damage, make
sure to observe the following precau-
tions.
• Do not use acidic, alkaline or abrasive
detergent
• Do not use hard brushes
• Do not use detergent on the wheels
when they are hot, such as after driving or
parking in hot weather
■ Brake pads and calipers
Rust may form if the vehicle is parked with
wet brake pads or disc rotors, causing them
to stick. Before parking the vehicle after it is
washed, drive slowly and apply the brakes
several times to dry the parts.
■ Bumpers
Do not scrub with abrasive cleaners.
■ Front side windows water-repellent
coating
The following precautions can extend the
effectiveness of the water-repellent coat-
ing.
● Remove any dirt, etc. from the front side
windows regularly.
● Do not allow dirt and dust to accumulate
on the windows for a long period.
Clean the windows with a soft, damp
cloth as soon as possible.
● Do not use wax or glass cleaners that
contain abrasives when cleaning the win-
dows.
● Do not use any metallic objects to
remove condensation build up.
■ Plated portions
If dirt cannot be removed, clean the parts as
follows:
● Use a soft cloth dampened with an
approximately 5% solution of neutral
detergent and water to clean the dirt off.
● Wipe the surface with a dry, soft cloth to
remove any remaining moisture.
● To remove oily deposits, use alcohol wet
wipes or a similar product.
WARNING
■ When washing the vehicle
Do not apply water to the inside of the
engine compartment. Doing so may
cause the electrical components etc. to
catch fire.
■ When cleaning the windshield (vehi-
cles with rain-sensing windshield wip-
ers)
Set the wiper switch to off.
If the switch is in AUTO, the wipers may
operate unexpectedly in the following
situations, and may result in hands being
caught or other serious injuries and
cause damage to the wiper blades.
Off
AUTO
● When the upper part of the windshield
where the raindrop sensor is located is
touched by hand
● When a wet rag or similar is held close
to the raindrop sensor
● If something bumps against the wind-
shield
● If you directly touch the raindrop sen-
sor body or if something bumps into
the raindrop sensor
■ Precautions regarding the exhaust
pipe
Exhaust gasses cause the exhaust pipe to
become quite hot.
When washing the vehicle, be careful not
to touch the pipe until it has cooled suffi-
ciently, as touching a hot exhaust pipe
can cause burns.
A
B
348
6-1. Maintenance and care
WARNING
■ Precautions regarding the front and
rear bumpers
If the paint of the rear bumper is chipped
or scratched, the following systems may
not function correctly. If this occurs, con-
sult your Lexus dealer.
● Lexus Safety System + 3
● BSM
● RCTA
● PKSB (if equipped)
NOTICE
■ To prevent paint deterioration and
corrosion on the body and compo-
nents (aluminum wheels etc.)
● Wash the vehicle immediately in the
following cases:
• After driving near the sea coast
• After driving on salted roads
• If coal tar or tree sap is present on the
paint surface
• If dead insects, insect droppings or
bird droppings are present on the
paint surface
• After driving in an area contaminated
with soot, oily smoke, mine dust, iron
powder or chemical substances
• If the vehicle becomes heavily soiled
with dust or mud
• If liquids such as benzene and gasoline
are spilled on the paint surface
● If the paint is chipped or scratched,
have it repaired immediately.
● To prevent the wheels from corroding,
remove any dirt and store in a place
with low humidity when storing the
wheels.
■ Cleaning the exterior lights
● Wash carefully. Do not use organic
substances or scrub with a hard brush.
This may damage the surfaces of the
lights.
● Do not apply wax to the surfaces of the
lights.
Wax may cause damage to the lenses.
■ When using an automatic car wash
(vehicles with rain-sensing windshield
wipers)
Set the wiper switch to the off position.
If the wiper switch is in AUTO, the wipers
may operate and the wiper blades may
be damaged.
■ When using a high pressure car wash
● When washing the vehicle, do not
spray the camera or its surrounding
area directly with a high pressure
washer. Shock applied from high pres-
sure water may cause the device to not
operate normally.
● Do not spray water directly on the
radar which is equipped behind the
radar sensor cover. Otherwise it may
cause the device to be damaged.
● Do not bring the nozzle tip close to
boots (rubber or resin manufactured
cover), connectors or the following
parts. The parts may be damaged if
they come into contact with high-pres-
sure water.
• Traction related parts
• Steering parts
• Suspension parts
• Brake parts
● Keep the cleaning nozzle at least 11.9
in. (30 cm) away from the vehicle
body. Otherwise resin section, such as
moldings and bumpers, may be
deformed and damaged. Also, do not
continuously hold the nozzle in the
same place.
349
6-1. Maintenance and care
6
Maintenance and care
Remove dirt and dust using a vac-
uum cleaner. Wipe dirty surfaces
with a cloth dampened with luke-
warm water.
If dirt cannot be removed, wipe it off
with a soft cloth dampened with
neutral detergent diluted to approx-
imately 1%.
Wring out any excess water from
the cloth and thoroughly wipe off
remaining traces of detergent and
water.
■ Shampooing the carpets
There are several commercial foaming-
type cleaners available. Use a sponge or
brush to apply the foam. Rub in overlapping
circles. Do not use water. Wipe dirty sur-
faces and let them dry. Excellent results are
obtained by keeping the carpet as dry as
possible.
■ Handling the seat belts
Clean with mild soap and lukewarm water
using a cloth or sponge. Also check the
belts periodically for excessive wear, fray-
ing or cuts.
■ Front side windows with UV protective
coating (vehicles with UV protective
coating)
The front side windows have UV protective
coating. To prevent any damage to the UV
protective coating, observe the following:
● If the windows are dirty, gently wipe them
NOTICE
● Do not spray the lower part of the
windshield continuously. If water
enters the air conditioning system
intake located near the lower part of
the windshield, the air conditioning
system may not operate correctly.
● Do not wash the underside of the vehi-
cle using a high pressure car washer.
Cleaning and protecting the
v
ehicle interior
Perform cleaning in a manner
appropriate to each component
and its material.
Protecting the vehicle interior

Related Topics

Popular Owner Manuals