2019-2026 Lexus UX SUV Opening, closing and locking the doors -> Smart access system with push-button start User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Opening, closing and locking the doors -> Smart access system with push-button start for Your Lexus UX SUV First Generation (2019-2026)

138
3-2. Opening, closing and locking the doors
2 Press and hold the power back
door switch on the back door for 2
seconds.
• When the settings are completed,
the buzzer sounds 4 times.
• When opening the back door the
next time, the back door will stop at
that position.
■ Returning the back door automatic stop
position to the initial settings
Press and hold the power back door switch
on the back door for 7 seconds.
After the buzzer sounds 4 times, it sounds
twice more. When the power back door
does the opening operation the next time,
the door will open to the initial settings posi-
tion.
■ Antenna location
Antennas outside the cabin
Antennas inside the cabin
Operating the smart access system with
push-button start (P.138)
Smart access system with
push-button start
The following operations can be
performed simply by carrying the
electronic key (including the card
key) on your person, for example in
your pocket. The driver should
always carry the electronic key.
Locks and unlocks the doors
(P.120)
Locks and unlocks the back door
(P.124)
Starts the hybrid system
(P.177)
A
B
139
3-2. Opening, closing and locking the doors
3
Before driving
■ Effective range (areas within which the
electronic key is detected)
When locking or unlocking the doors
The system can be operated when the elec-
tronic key is within about 2.3 ft. (0.7 m) of
either of the outside front door handles and
back door opener switch. (Only the doors
detecting the key can be operated.)
When starting the hybrid system or
changing power switch modes
The system can be operated when the elec-
tronic key is inside the vehicle.
■ If an alarm sounds or a warning message
is displayed
An alarm sounds and warning message dis-
plays shown on the multi-information dis-
play are used to protect against
unexpected accidents or theft of the vehicle
resulting from erroneous operation. When
a warning message is displayed, take
appropriate measures based on the dis-
played message.
When only an alarm sounds, circumstances
and correction procedures are as follows.
● When an exterior alarm sounds once for
5 seconds
● When an interior alarm pings continu-
ously
■ If “Key Detected in Vehicle” is shown on
the multi-information display
An attempt was made to lock the doors
using the smart access system with push-
button start while the electronic key was still
inside the vehicle. Retrieve the electronic
key from the vehicle and lock the doors
again.
■ Battery-saving function
The battery-saving function will be acti-
vated in order to prevent the electronic key
battery and the 12-volt battery from being
discharged while the vehicle is not in opera-
tion for a long time.
● In the following situations, the smart
access system with push-button start may
take some time to unlock the doors. Also
the illuminated entry system may not
operate properly.
• The electronic key has been left in an
area of approximately 11.5 ft. (3.5 m) of
the outside of the vehicle for 40 seconds
or longer.
• The smart access system with push-but-
ton start has not been used for 5 days or
longer.
● If the smart access system with push-but-
ton start has not been used for 14 days or
longer, the doors cannot be unlocked at
any doors except the driver’s door. In this
case, take hold of the driver’s door han-
dle, or use the wireless remote control or
the mechanical key, to unlock the doors.
Situation
Correction proce-
dure
An attempt was
made to lock the
vehicle while a door
was open.
Close all of the
doors and lock the
doors again.
A
B
Situation
Correction proce-
dure
The power switch
was turned to ACC
while the driver’s
door was open (or
the driver’s door was
opened while the
power switch was in
ACC).
Turn the power
switch to OFF and
close the driver’s
door.
140
3-2. Opening, closing and locking the doors
■ Turning an electronic key to battery-
saving mode
● When battery-saving mode is set, battery
depletion is minimized by stopping the
electronic key from receiving radio
waves.
Press twice while pressing and
holding .
Confirm that the electronic key indicator
flashes 4 times.
While the battery-saving mode is set, the
smart access system with push-button start
cannot be used. To cancel the function,
press any of the electronic key buttons.
● Electronic keys that will not be used for
long periods of time can be set to the bat-
tery-saving mode in advance.
■ When electronic key function stops
If the position of the electronic key has not
changed for a certain amount of time such
as when the electronic key is left some-
where, the function of the electronic key
stops to reduce depletion of the battery.
In this case, function can automatically be
restored by moving the position of the key
such as by lifting it up.
■ Conditions affecting operation
The smart access system with push-button
start uses weak radio waves. In the follow-
ing situations, the communication between
the electronic key and the vehicle may be
affected, preventing the smart access sys-
tem with push-button start, wireless remote
control and immobilizer system from oper-
ating properly.
● When the electronic key battery is
depleted
● Near a TV tower, electric power plant,
gas station, radio station, large display,
airport or other facility that generates
strong radio waves or electrical noise
● When the electronic key is in contact
with, or is covered by the following metal-
lic objects
• Cards to which aluminum foil is attached
• Cigarette boxes that have aluminum foil
inside
• Metallic wallets or bags
• Coins
• Hand warmers made of metal
• Media such as CDs and DVDs
● When other wireless key (that emits
radio waves) is being used nearby
● When carrying the electronic key
together with the following devices that
emit radio waves
• Portable radio, cellular phone, cordless
phone or other wireless communication
devices
• Another electronic key or a wireless key
that emits radio waves
• Personal computers or personal digital
assistants (PDAs)
• Digital audio players
• Portable game systems
● If window tint with a metallic content or
metallic objects are attached to the rear
window
● When the electronic key is placed near a
battery charger or electronic devices
● When the vehicle is parked in a pay park-
ing spot where radio waves are emitted.
If the doors cannot be locked/unlocked
using the smart access system with push-
button start, lock/unlock the doors by per-
forming any of the following:
● Bring the electronic key close to either
front door handle and operate the entry
function.
● Operate the wireless remote control.
If the doors cannot be locked/unlocked
using the above methods, use the mechani-
cal key. (P.430)
If the hybrid system cannot be started using
the smart access system with push-button
start, refer to P.431.
141
3-2. Opening, closing and locking the doors
3
Before driving
■ Note for the entry function
● Even when the electronic key is within the
effective range (detection areas), the sys-
tem may not operate properly in the fol-
lowing cases:
• The electronic key is too close to the win-
dow or outside door handle, near the
ground, or in a high place when the doors
are locked or unlocked.
• The electronic key is on the instrument
panel, luggage compartment or floor, or
in the door pockets or glove box when
the hybrid system is started or power
switch modes are changed.
• A person is between the vehicle and
electronic key, blocking radio waves
when the door is unlocked
● Do not leave the electronic key on top of
the instrument panel or near the door
pockets when exiting the vehicle.
Depending on the radio wave reception
conditions, it may be detected by the
antenna outside the cabin and the doors
will become lockable from the outside,
possibly trapping the electronic key
inside the vehicle.
● As long as the electronic key is within the
effective range, the doors may be locked
or unlocked by anyone. However, only
the doors detecting the electronic key
can be used to unlock the vehicle.
● Even if the electronic key is not inside the
vehicle, it may be possible to start the
hybrid system if the electronic key is near
the window.
● The doors may unlock if a large amount
of water splashes on the door handle,
such as in the rain or in a car wash when
the electronic key is within the effective
range. (The doors will automatically be
locked after approximately 60 seconds if
the doors are not opened and closed.)
● If the wireless remote control is used to
lock the doors when the electronic key is
near the vehicle, there is a possibility that
the door may not be unlocked by the
entry function. (Use the wireless remote
control to unlock the doors.)
● Touching the door lock sensor while
wearing gloves may delay or prevent
lock operation. Remove the gloves and
touch the lock sensor again.
● Some models: When the lock operation
is performed using the lock sensor, rec-
ognition signals will be shown up to two
consecutive times. After this, no recogni-
tion signals will be given.
● If the door handle becomes wet while the
electronic key is within the effective
range, the door may lock and unlock
repeatedly. In that case, follow the follow-
ing correction procedures to wash the
vehicle.
• Place the electronic key in a location 6 ft.
(2 m) or more away from the vehicle.
(Take care to ensure that the key is not
stolen.)
• Set the electronic key to battery-saving
mode to disable the smart access system
with push-button start. (P.140)
● If the electronic key is inside the vehicle
and a door handle becomes wet during a
car wash, a message may be shown on
the multi-information display and a
buzzer will sound outside the vehicle. To
turn off the alarm, lock all the doors.
● The lock sensor may not work properly if
it comes into contact with ice, snow, mud,
etc. Clean the lock sensor and attempt to
operate it again.
● A sudden approach to the effective
range or door handle may prevent the
doors from being unlocked. In this case,
return the door handle to the original
position and check that the doors unlock
before pulling the door handle again.
● If there is another electronic key in the
detection area, it may take slightly longer
to unlock the doors after the door handle
is gripped.
■ When the vehicle is not driven for
extended periods
● To prevent theft of the vehicle, do not
leave the electronic key within 6 ft. (2 m)
of the vehicle.
● The smart access system with push-but-
ton start can be deactivated in advance.
(P.460)
● Battery-saving mode can reduce the
power consumption of electronic keys.
(P.140)
142
3-2. Opening, closing and locking the doors
■ To operate the system properly
Make sure to carry the electronic key when
operating the system. Do not get the elec-
tronic key too close to the vehicle when
operating the system from the outside of
the vehicle.
Depending on the position and holding
condition of the electronic key, the key may
not be detected correctly and the system
may not operate properly. (The alarm may
go off accidentally, or the door lock preven-
tion may not operate.)
■ If the smart access system with push-
button start does not operate properly
● Locking and unlocking the doors: Use
the mechanical key. (P.430)
● Starting the hybrid system: P.431
■ Customization
Settings (e.g. smart access system with
push-button start) can be changed.
(Customizable features: P.460)
If the smart access system with push-button
start has been deactivated in a customized
setting, refer to the explanations for the fol-
lowing operations.
● Locking and unlocking the doors: Use
the wireless remote control or mechani-
cal key. (P.120, 430)
● Starting the hybrid system and changing
power switch modes: P.431
● Stopping the hybrid system: P.178
WARNING
■ Caution regarding interference with
electronic devices
● People with implantable cardiac pace-
makers, cardiac resynchronization
therapy-pacemakers or implantable
cardioverter defibrillators should
maintain a reasonable distance
between themselves and the smart
access system with push-button start
antennas. (P.138)
The radio waves may affect the opera-
tion of such devices. If necessary, the
entry function can be disabled. Ask
your Lexus dealer for details, such as
the frequency of radio waves and tim-
ing of the emitted radio waves. Then,
consult your doctor to see if you
should disable the entry function.
● User of any electrical medical device
other than implantable cardiac pace-
makers, cardiac resynchronization
therapy-pacemakers or implantable
cardioverter defibrillators should con-
sult the manufacturer of the device for
information about its operation under
the influence of radio waves.
Radio waves could have unexpected
effects on the operation of such medi-
cal devices.
Ask your Lexus dealer for details for dis-
abling the entry function.

Related Topics

Popular Owner Manuals