
336
5-5. Using the other interior features
genuine manufacturer parts) and acces-
sory, it may not be possible to charge.
When charging is not performed even with
the portable device placed on the charge
area, remove the cover and accessories.
■ AM radio cooperation function during
charging
● When noise enters the AM radio during
charging, charging frequency will be
automatically changed to reduce noise.
● During the AM radio automatic tuning,
charging is temporarily stopped in order
to prevent tuning error due to noise
caused by charging. When tuning is fin-
ished, charging will be automatically
resumed.
■ Important points of the wireless charger
● If the electronic key cannot be detected
within the vehicle interior, charging can-
not be done. When the door is opened
and closed, charging may be temporarily
suspended.
● When charging, the wireless charging
device and portable device will get
warmer, however this is not a malfunc-
tion.
When a portable device gets warm while
charging, charging may stop due to the
protection function on the portable
device side. In this case, when the tem-
perature of the portable device drops
significantly, charge again.
The fan may start operating to lower the
temperature inside the wireless charger,
however this is not a malfunction.
■ Operation sounds
A buzzing noise may be heard when press-
ing the power switch to turn to ACC or ON
or when detecting a portable device. How-
ever, this is not a malfunction.
■ Cleaning the wireless charger
P.350
■ Situations in which the function may not
operate normally
Devices may not be charged normally in
the following situations.
● The portable device is fully charged
● The portable device is being charged
with a cable connected
● There is foreign matter between the
charge area and portable device
● Charging has caused the portable device
to heat up
● The temperature around the wireless
charger is 95°F (35°C) or higher, such
as in extreme heat
● The portable device is placed with its
charging surface facing up
● The small portable device such as fold-
able type is placed in an area misaligned
from the charge area
● The portable device is larger than the
charging tray
● The vehicle is in an area where strong
electrical waves or noise are emitted,
such as near a television tower, power
plant, gasoline station, broadcasting sta-
tion, large display, airport, etc.
● The electronic key is not inside the vehi-
cle
● Any of the following is stuck or installed
between the charging side of the porta-
ble device and the charge area.
• Thick cases or covers
• A case or cover attached with an uneven
or tilted surface, so that the charging side
is not flat
• Thick decorations
• Accessories, such as finger rings, straps,
etc.
● When there is a gap between the
charging side of the portable device and
the charge area due to a protrusion such
as a camera on the charging side of the
portable device.
● When the portable device is in contact
with, or is covered by any of the following
metallic objects:
• A card that has metal on it, such as alumi-
num foil, etc.
• A pack of cigarettes that includes alumi-
num foil
• A wallet or bag that is made of metal
• Coins
• A heating pad
• CDs, DVDs or other media
• A metal accessory