2016-2026 Mazda Mx-5 SUV If Trouble Arises -> When the Roof Cannot be Closed User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

If Trouble Arises -> When the Roof Cannot be Closed for Your Mazda Mx-5 SUV Fourth Generation (2016-2026)

If Trouble Arises  
When the Roof Cannot be Closed  
When the Roof Cannot be Closed  
If the roof cannot be closed electrically by pressing the retractable hardtop switch, verify the  
roof operation conditions first.  
Refer to Operation Conditions on page 3-45.  
If the roof cannot be closed even after the operation conditions are all met, have it checked  
at an Authorized Mazda Dealer.  
If you are unable to have the roof checked at an Authorized Mazda Dealer, the roof can be  
closed manually as an emergency measure.  
The procedure for manually closing the roof is as follows:  
1. Opening the rear roof  
Release the locks of the rear roof and open it.  
2. Closing the front roof  
Lift up the front roof and close it.  
3. Closing the rear roof  
Tie the ropes to the rear roof links and close the rear roof.  
Front roof  
Rear roof  
Rear roof link  
7-57  
If Trouble Arises  
When the Roof Cannot be Closed  
CAUTION  
Do not drive the vehicle with the roof partially open. The vehicle operation may be aꢀected  
by the wind and could result in an accident.  
Do not perform the procedure in a strong wind as it could cause an unexpected accident.  
Two adults are required to perform the procedure, especially when lifting up the front roof.  
Do not do it alone so as not to cause injury or vehicle damage.  
Some steps in the procedure require using multiple tools at the same time and a certain  
level of technical expertise. In addition, holding your body extended over the car can result  
in muscle strains so Mazda recommends having the roof checked at an Authorized Mazda  
Dealer.  
NOTE  
This procedure is for manually closing the roof as an emergency measure. After closing  
the roof manually, electric operation is not possible until the system is restored by an  
Authorized Mazda Dealer.  
Using a flashlight will facilitate the procedure.  
7-58  
If Trouble Arises  
When the Roof Cannot be Closed  
Opening the rear roof  
Manual closing  
Before closing manually  
CAUTION  
WARNING  
When turning the bolt, cover the front  
roof using a cloth. The front roof may be  
damaged if the L-shaped hexagonal  
wrench contacts it.  
Verify that the ignition is switched oꢀ  
before manually operating the roof:  
Manually closing the roof with the ignition  
not switched oꢀ is dangerous as the  
motors could turn on suddenly and cause  
injury resulting from hands or ꢁngers being  
pinched in the mechanism.  
Because the clearance with the stored  
front roof is narrow, be careful not to let  
the L-shape hexagonal wrench contact  
the roof when turning the bolt.  
NOTE  
1. Park on a hard, level surface off the  
right-of-way and firmly set the parking  
brake.  
2. Put a vehicle with an automatic  
transmission in Park (P), a manual  
transmission in Neutral.  
Moving the seats as far forward as  
possible and folding the seatbacks forward  
will facilitate the procedure.  
Refer to Adjusting the Driver's Seat on  
page 2-5.  
Refer to Adjusting the Passenger's Seat on  
page 2-10.  
3. Switch the ignition off while  
depressing the brake pedal.  
4. Turn on the hazard warning flasher if it  
is needed.  
1. Remove the antenna if it is installed.  
Refer to Antenna on page 5-17.  
2. Insert the short end of the L-shaped  
hexagonal wrench (Large) into the  
motor bracket bolt.  
Tool preparation  
Take out the five tools stored in the seat  
side box.  
Refer to Seat Side Box on page 5-99.  
Bolt  
Gear  
(tool kit)  
Wire  
Rope  
L-shaped  
hexagonal wrench  
(Small)  
L-shaped  
hexagonal wrench  
(Large)  
7-59  
If Trouble Arises  
When the Roof Cannot be Closed  
NOTE  
NOTE  
If it is difficult to see the bolt, remove  
the windblocker and identify the bolt  
from the center of the vehicle.  
The tip of the long end of the L-shaped  
hexagonal wrench can be used at an  
angle. Moving the wrench upward  
slightly will increase the clearance  
between the rear roof and the stored  
front roof and facilitate the procedure.  
5. Turn the L-shaped hexagonal wrench  
(Large) counterclockwise 13 times or  
more while pressing the wrench  
against the bolt.  
Windblocker  
3. Turn the L-shaped hexagonal wrench  
(Large) counterclockwise to loosen the  
bolt slightly.  
NOTE  
The bolt cannot be removed  
completely.  
If it is hard to turn the bolt, repeat  
Step 3 a few times.  
6. Hook the wire to the link pin shown in  
the figure.  
4. Remove the L-shaped hexagonal  
wrench (Large) once from the bolt,  
then insert the long end of the wrench  
into the bolt.  
7-60  
If Trouble Arises  
When the Roof Cannot be Closed  
7. While one person pushes the rear roof  
down, another person pulls the wire  
until a latch sound is heard and the rear  
roof unlocks.  
CAUTION  
Do not let go of the rear roof on both  
sides until it is fully open. The rear  
roof could fall if it is released too soon  
and cause injury.  
Wire  
Link Pin  
Do not attempt to forcefully lift the  
rear roof. If the rear roof is forcefully  
lifted without being unlocked, it  
could damage vehicle parts.  
Lock  
Unlock  
Lift the rear roof with its left and right  
height as parallel as possible. If the  
rear roof is lifted with the left or right  
height slanted, it could deform the  
link mechanism.  
8. Do the same procedure on the other  
side.  
Closing the front roof  
9. While standing on both sides of the  
vehicle, lift the rear roof to the position  
it stops while keeping the height of its  
left and right sides as parallel as  
possible.  
CAUTION  
Some steps in the procedure require  
holding your body in a strained position  
and if over exerted it could result in  
injury.  
Do the procedure being very careful not  
to get your hands and ꢁngers caught  
while closing the front roof. Otherwise,  
your hands or ꢁngers could be injured.  
Removal of the headliner is included in  
the procedure, however, never drive the  
vehicle with the headliner removed.  
Driving the vehicle with the headliner  
removed is prohibited by law. Correctly  
perform the procedure while following  
the instructions.  
7-61  
If Trouble Arises  
When the Roof Cannot be Closed  
NOTE  
1. While standing on both sides of the  
vehicle, hold the front and rear sides of  
the front roof and pull the front roof  
upward.  
The next step cannot be done if the  
front roof is closed completely.  
4. Remove the link covers on the left and  
right sides by pulling them out by  
hand.  
Link cover  
5. Remove the fasteners and the  
headliner.  
2. Switch your hand on the rear side of  
the front roof to the front side and pull  
the front roof forward.  
3. Stop pulling the front roof before it  
completely closes.  
7-62  
If Trouble Arises  
When the Roof Cannot be Closed  
6. Lightly press the front edge of the  
front roof from outside of the vehicle  
to close the front roof completely.  
CAUTION  
Insert the gear (tool kit) securely until it  
engages with the top lock motor gear. If  
the gear (tool kit) is not inserted  
securely, it may come oꢀ and be  
damaged.  
9. Rotate the hexagonal wrench and  
move the hook in the lock direction so  
that there is enough space for the  
opening of the headliner to be attached  
to the hook.  
7. Insert the short end of the hexagonal  
wrench (Small) into the gear (tool kit)  
and assemble.  
Gear (tool kit)  
Lock  
Lock  
Unlock  
L-shaped hexagonal  
wrench (Small)  
Unlock  
8. Insert the point of the gear (tool kit)  
into the hole beside the top lock motor  
gear with the hexagonal wrench  
inserted into the gear tool.  
NOTE  
Turning the gear (tool kit) requires  
some effort due to motor resistance.  
Slowly operate the hexagonal wrench.  
Top lock motor  
gear  
Gear (tool kit)  
7-63  
If Trouble Arises  
When the Roof Cannot be Closed  
NOTE  
10. Insert the hook into the opening of the  
headliner.  
The top lock lever completely engages  
with the vehicle body (locked  
condition) at the position where the  
teeth of the gear (tool kit) contact the  
bracket.  
Hook  
Bracket  
Headliner  
11. Turn the hexagonal wrench (Small)  
and gear (tool kit) counterclockwise  
and engage the hook with the vehicle  
body side.  
Gear (tool kit)  
12. Lift the rear end of the headliner with  
it hinged on the opening of the  
headliner.  
7-64  
If Trouble Arises  
When the Roof Cannot be Closed  
13. Install the headliner to the front roof  
using the fasteners at two locations.  
Closing the rear roof  
CAUTION  
Slowly close the rear roof. If the rear roof  
is closed suddenly, a hand or other body  
part may be pinched, leading to a serious  
injury.  
Do not attempt to forcefully push the  
rear roof. Pushing the rear roof forcefully  
may damage vehicle parts.  
1. Fold the rope in half and hook it to the  
link pin of the rear roof.  
NOTE  
The fasteners in the five locations at  
the front of the headliner are not  
fastened. Do not lose the fasteners  
because they are needed for the  
required servicing at the Authorized  
Mazda Dealer.  
Rope  
Link pin  
14. Install the left and right link covers  
from the vehicle interior.  
Link cover  
2. Do the same procedure on the other  
side.  
3. Close the rear roof uniformly on both  
sides using two adults, one on each  
side of the vehicle.  
CAUTION  
Close the rear roof with its left and right  
positions as parallel as possible. If the  
rear roof is closed with its left or right  
height slanted, it could deform the link  
mechanism.  
7-65  
If Trouble Arises  
When the Roof Cannot be Closed  
NOTE  
4. Slowly close the rear roof while lightly  
pulling the rope with one hand so that  
the rope does not unhook.  
The rear roof is locked completely if  
the position where the rope is  
hooked is at the rear end of the  
bracket groove in the direction of the  
vehicle rear, as shown in the figure,  
when viewed from the vehicle  
interior.  
Rope  
Rope  
Link pin  
NOTE  
Route the rope rearward through the  
clearance between the rear roof and  
trunk.  
5. One person pushes the rear roof down  
and the other person pulls the rope  
strongly and straight back towards the  
vehicle rear until a click sound is  
heard.  
If the rear roof is not locked  
completely, the trunk will not open  
even if the remote release button,the  
electric trunk lid opener, or the trunk  
button on the transmitter is  
operated.  
Rope  
6. Do the same procedure on the other  
side.  
7. Open the trunk and tie the rope to the  
trunk hinge.  
Hinge  
Rope  
7-66  
If Trouble Arises  
When the Roof Cannot be Closed  
8. Tie off the other side rope the same  
way.  
9. Close the trunk lid.  
After finishing the procedure  
After finishing the procedure, have the  
roof checked at an Authorized Mazda  
Dealer as soon as possible.  
WARNING  
Drive the vehicle at a speed of 40 km/h (24  
mph) or lower before having the roof  
checked at an Authorized Mazda Dealer:  
The front roof may open while the vehicle is  
being driven and cause an accident.  
7-67  

Related Topics

Popular Owner Manuals