2016-2019 Mercedes GLE SUV Breakdown assistance -> Fuses User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Breakdown assistance -> Fuses for Your Mercedes GLE SUV First Generation (2016-2019)

Fuses364A minimum distance of 20 cm upwards andIf the vehicle has transmission damage or dam-10 cm downwards must be maintained to theage to the front or rear axle, have it transportedtransport a transporter or the event of damage to the electrical sys-X Secure all four wheels after loading the vehi-tem: if the battery is defective, the will be locked in position P. To shiftthe automatic transmission to position N, youVehicles with ADS PLUS (Adaptivemust provide power to the vehicle's on-boardDamping System PLUS)electrical system in the same way as when jump-starting ( Y page 359).Important safety noteHave the vehicle transported on a transporter orG lower damping forces of the vehicle to betransported can cause the vehicle/trailerTow-starting (emergency enginecombination to )As a result, when transporting vehicles with! Do not tow-start vehicles with automaticthe Adaptive Damping System PLUS, the vehi-transmission. You could otherwise damagecle/trailer combination may start to automatic , you could lose control of yourYou can find information on "Jump-starting" assistanceunder ( Y page 359).There is a risk of accident and transporting, make sure that:FusesR the vehicle has been loaded onto the trans-porter correctlyImportant safety notesR the vehicle is secured at all four wheels withG WARNINGsuitable tensioning strapsR the maximum permissible speed ofIf you manipulate, bridge or replace a faulty60 km/h is not exceededfuse with a fuse of a higher amperage, theelectric cables could be overloaded. This maySecuring the vehicleresult in a fire. There is a risk of an accident! After loading, the vehicle must be secured atand four wheels. Otherwise, the vehicle couldAlways replace faulty fuses with specified newbe of the correct amperage.A minimum distance of 20 cm upwards and10 cm downwards must be main
Fuses
364
A minimum distance of 20 cm upwards and
If the vehicle has transmission damage or dam-
10 cm downwards must be maintained to the
age to the front or rear axle, have it transported
transport platform.
on a transporter or trailer.
In the event of damage to the electrical sys-
X Secure all four wheels after loading the vehi-
tem: if the battery is defective, the automatic
cle.
transmission will be locked in position P. To shift
the automatic transmission to position N, you
Vehicles with ADS PLUS (Adaptive
must provide power to the vehicle's on-board
Damping System PLUS)
electrical system in the same way as when jump-
starting ( Y page 359).
Important safety note
Have the vehicle transported on a transporter or
G WARNING
trailer.
The lower damping forces of the vehicle to be
transported can cause the vehicle/trailer
Tow-starting (emergency engine
combination to swing.
starting)
As a result, when transporting vehicles with
! Do not tow-start vehicles with automatic
the Adaptive Damping System PLUS, the vehi-
transmission. You could otherwise damage
cle/trailer combination may start to skid.
the automatic transmission.
Consequently, you could lose control of your
You can find information on "Jump-starting"
vehicle.
Breakdown assistance
under ( Y page 359).
There is a risk of accident and injury.
When transporting, make sure that:
Fuses
R the vehicle has been loaded onto the trans-
porter correctly
Important safety notes
R the vehicle is secured at all four wheels with
G WARNING
suitable tensioning straps
R the maximum permissible speed of
If you manipulate, bridge or replace a faulty
60 km/h is not exceeded
fuse with a fuse of a higher amperage, the
electric cables could be overloaded. This may
Securing the vehicle
result in a fire. There is a risk of an accident
! After loading, the vehicle must be secured at
and injury.
all four wheels. Otherwise, the vehicle could
Always replace faulty fuses with specified new
be damaged.
fuses of the correct amperage.
A minimum distance of 20 cm upwards and
10 cm downwards must be maintained to the
! Only use fuses marked with an "S" for the
transport platform.
fuse box in the engine compartment and
X Secure all four wheels after loading the vehi-
under the rear bench seat. Components or
cle.
systems could otherwise be damaged.
! Make sure that no moisture can enter the
fuse box when the cover is open.
Information for 4MATIC vehicles
! When closing the cover, make sure that it is
lying correctly on the fuse box. Moisture seep-
! Vehicles with 4MATIC must not be towed
ing in or dirt could otherwise impair the oper-
with the front or rear axle raised; otherwise,
ation of the fuses.
the transmission may be damaged.
The fuses in your vehicle disconnect faulty cir-
Vehicles with 4MATIC may either be towed away
cuits. If a fuse blows, all the components in the
with both axles on the ground or be loaded up
circuit and their functions will fail.
and transported.
Fuses365Blown fuses must be replaced with fuses of thesame rating, which you can recognise by thecolour and fuse rating. The fuse ratings are listedin the fuse allocation fuse allocation chart is located in the fusebox under the rear bench seat ( Y page 366).If the newly inserted fuse also blows, have thecause traced and rectified at a qualified special-ist workshop, e.g. a Mercedes-Benz replacing a fuseX Open the front-passenger door.X To open: pull cover : outwards in the direc-Observe the important safety notes:tion of the arrow and remove it.( Y page 364)X To close: clip in cover : on the front of theX Switch off the .X Switch off all electrical consumers.X Fold cover : inwards until it engages.X Remove the key from the ignition , on vehicles with KEYLESS-GO start functionor KEYLESS‑GO:Fuse box in the engine compartmentBreakdown assistanceX Open the driver's door.G WARNINGThe vehicle electronics are now in key posi-tion u. This is the same as the key havingWhen the bonnet is open, and the windscreenbeen are set in motion, you can be injured byThe driver's door can be closed wiper linkage. There is a risk of injury.X Secure the vehicle against rolling awayAlways switch off the windscreen wipers and( Y page 166).the ignition before opening the indicator lamps on the instrument clustermust be fuses are located in various fuse boxes:R fuse box on the front-passenger side of thedashboardR fuse box in the engine compartment on theright-hand side of the vehicle, when viewed inthe direction of travelR fuse box under the rear bench seatDashboard fuse box! Do not use a pointed object such as a screw-X Open the bonnet ( Y page 337).driver to open the cover in the dashboard. YouX Remove any existing moisture from the fusecould damage the dashboard or the using a dry -Benz recommends that you have thisX To open: open clamps ;.work performed at a qualified
Fuses
365
Blown fuses must be replaced with fuses of the
same rating, which you can recognise by the
colour and fuse rating. The fuse ratings are listed
in the fuse allocation chart.
The fuse allocation chart is located in the fuse
box under the rear bench seat ( Y page 366).
If the newly inserted fuse also blows, have the
cause traced and rectified at a qualified special-
ist workshop, e.g. a Mercedes-Benz Service
Centre.
Before replacing a fuse
X Open the front-passenger door.
X To open: pull cover : outwards in the direc-
Observe the important safety notes:
tion of the arrow and remove it.
( Y page 364)
X To close: clip in cover : on the front of the
X Switch off the engine.
dashboard.
X Switch off all electrical consumers.
X Fold cover : inwards until it engages.
X Remove the key from the ignition lock.
Or, on vehicles with KEYLESS-GO start function
or KEYLESS‑GO:
Fuse box in the engine compartment
Breakdown assistance
X Open the driver's door.
G WARNING
The vehicle electronics are now in key posi-
tion u. This is the same as the key having
When the bonnet is open, and the windscreen
been removed.
wipers are set in motion, you can be injured by
The driver's door can be closed again.
the wiper linkage. There is a risk of injury.
X Secure the vehicle against rolling away
Always switch off the windscreen wipers and
( Y page 166).
the ignition before opening the bonnet.
All indicator lamps on the instrument cluster
must be off.
The fuses are located in various fuse boxes:
R fuse box on the front-passenger side of the
dashboard
R fuse box in the engine compartment on the
right-hand side of the vehicle, when viewed in
the direction of travel
R fuse box under the rear bench seat
Dashboard fuse box
! Do not use a pointed object such as a screw-
X Open the bonnet ( Y page 337).
driver to open the cover in the dashboard. You
X Remove any existing moisture from the fuse
could damage the dashboard or the cover.
box using a dry cloth.
Mercedes-Benz recommends that you have this
X To open: open clamps ;.
work performed at a qualified specialist work-
X Fold cover : up in the direction of the arrow
shop, e.g. at a Mercedes-Benz Service Centre.
and remove it.
Z
Fuses366X To close: check whether the seal is lying cor-rectly in cover :.X Insert cover : at the side of the fuse box intothe retainers.X Fold down cover : and close clamps ;.X Close the box under the rear bench seatBreakdown assistanceX Fold the right-hand rear bench seat forward( Y page 317).X To open: lift and fold out carpet : in thedirection of the arrow.X Release clamps ; by pressing them in thedirection of the arrow.X Fold cover = up in the direction of the arrowand remove it.i The fuse allocation chart is located undercover =.X To close: insert cover = at the side of thefuse box into the retainers.X Fold down cover = until clamps ; engageaudibly.X Fold the right-hand rear bench seat back( Y page 317).
Fuses
366
X To close: check whether the seal is lying cor-
rectly in cover :.
X Insert cover : at the side of the fuse box into
the retainers.
X Fold down cover : and close clamps ;.
X Close the bonnet.
Fuse box under the rear bench seat
Breakdown assistance
X Fold the right-hand rear bench seat forward
( Y page 317).
X To open: lift and fold out carpet : in the
direction of the arrow.
X Release clamps ; by pressing them in the
direction of the arrow.
X Fold cover = up in the direction of the arrow
and remove it.
i The fuse allocation chart is located under
cover =.
X To close: insert cover = at the side of the
fuse box into the retainers.
X Fold down cover = until clamps ; engage
audibly.
X Fold the right-hand rear bench seat back
( Y page 317).

Related Topics

Popular Owner Manuals