2010-2017 Nissan Leaf 4 Door Safety-Seats, seat belts and supplemental restraint system -> Precautions on child restraints User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Safety-Seats, seat belts and supplemental restraint system -> Precautions on child restraints for Your Nissan Leaf 4 Door First Generation (2010-2017)

CHILD RESTRAINTS  
PRECAUTIONS ON CHILD  
RESTRAINTS  
–
–
NISSAN recommends that all child  
restraints be installed in the rear  
seat. Studies show that children are  
safer when properly restrained in  
the rear seat than in the front seat. If  
you must install a forward-facing  
child restraint in the front seat, see  
“Forward-facing child restraint in-  
stallation using the seat belts” in  
this section.  
Even with the NISSAN Advanced Air  
Bag System, never install a rear-  
facing child restraint in the front  
seat. An inflating air bag could seri-  
ously injure or kill a child. A rear-  
facing child restraint must only be  
used in the rear seat.  
A child restraint with a top tether  
strap should not be used in the front  
passenger seat.  
Keep seatbacks as upright as pos-  
sible after fitting the child restraint.  
Infants and children should always  
be placed in an appropriate child  
restraint while in the vehicle.  
–
–
WARNING  
•
Failure to follow the warnings and in-  
structions for proper use and installa-  
tion of child restraints could result in  
serious injury or death of a child or  
other passengers in a sudden stop or  
collision:  
•
When the child restraint is not in use,  
keep it secured with the LATCH system  
or a seat belt. In a sudden stop or  
collision, loose objects can injure oc-  
cupants or damage the vehicle.  
–
–
–
–
–
The child restraint must be used and  
installed properly. Always follow all  
of the child restraint manufacturer’s  
instructions for installation and use.  
Infants and children should never be  
held on anyone’s lap. Even the  
strongest adult cannot resist the  
forces of a collision.  
CAUTION  
Be sure to purchase a child restraint  
that will fit the child and vehicle.  
Some child restraints may not fit  
properly in your vehicle.  
A child restraint in a closed vehicle can  
become very hot. Check the seating sur-  
face and buckles before placing a child in  
the child restraint.  
Do not put a seat belt around both a  
child and another passenger.  
–
–
Child restraint anchor points are de-  
signed to withstand loads from child  
restraints that are properly fitted.  
Never use the anchor points for  
adult seat belts or harnesses.  
This vehicle is equipped with a universal child  
restraint anchor system, referred to as the LATCH  
(Lower Anchors and Tethers for CHildren) sys-  
tem. Some child restraints include rigid or  
webbing-mounted attachments that can be con-  
nected to these anchors.  
1-18 Safety–Seats, seat belts and supplemental restraint system  
For details, see “Lower Anchors and Tethers for  
CHildren System (LATCH)” in this section.  
• If the combined weight of the child and child  
restraint is greater than 65 lbs, (29.5 kg) use the  
vehicle’s seat belt (not the lower anchors) to  
install the child restraint.  
If you do not have a LATCH compatible child  
restraint, the vehicle seat belts can be used.  
• Be sure to follow the child restraint manufactur-  
er’s instructions for installation.  
Several manufacturers offer child restraints for  
infants and small children of various sizes. When  
selecting any child restraint, keep the following  
points in mind:  
All U.S. states and Canadian provinces or  
territories require that infants and small  
children be restrained in an approved child  
restraint at all times while the vehicle is  
being operated. Canadian law requires the  
top tether strap on forward-facing child re-  
straints be secured to the designated an-  
chor point on the vehicle.  
• Choose only a restraint with a label certifying  
that it complies with Federal Motor Vehicle  
Safety Standard 213 or Canadian Motor Ve-  
hicle Safety Standard 213.  
• Check the child restraint in your vehicle to be  
sure it is compatible with the vehicle’s seat and  
seat belt system.  
Lower Anchors and Tethers for  
CHildren System (LATCH)  
• If the child restraint is compatible with your  
vehicle, place your child in the child restraint  
and check the various adjustments to be sure  
the child restraint is compatible with your child.  
Choose a child restraint that is designed for  
your child’s height and weight. Always follow all  
recommended procedures.  
Your vehicle is equipped with special anchor  
points that are used with Lower Anchors and  
Tethers for CHildren System (LATCH) compat-  
ible child restraints. This system may also be  
referred to as the ISOFIX or ISOFIX compatible  
system. With this system, you do not have to use  
a vehicle seat belt to secure the child restraint  
unless the combined weight of the child and child  
restraint exceeds 65 lbs (29.5 kg). If the com-  
bined weight of the child and child restraint is  
greater than 65 lbs, (29.5 kg) use the vehicle’s  
• If the combined weight of the child and child  
restraint is less than 65 lbs (29.5 kg), you may  
use either the LATCH anchors or the seat belt to  
install the child restraint (not both at the same  
time).  
Safety–Seats, seat belts and supplemental restraint system 1-19  
seat belt (not the lower anchors) to install the  
child restraint. Be sure to follow the child restraint  
manufacturer’s instructions for installation.  
•
Child restraint anchorages are de-  
signed to withstand only those loads  
imposed by correctly fitted child re-  
straints. Under no circumstances are  
they to be used to attach adult seat  
belts, or other items or equipment to  
the vehicle. Doing so could damage  
the child restraint anchorages. The  
child restraint will not be properly in-  
stalled using the damaged anchorage,  
and a child could be seriously injured  
or killed in a collision.  
LATCH lower anchor  
WARNING  
Failure to follow the warnings and in-  
structions for proper use and installation  
of child restraints could result in serious  
injury or death of a child or other passen-  
gers in a sudden stop or collision:  
•
Attach LATCH system compatible child  
restraints only at the locations shown  
in the illustration.  
LATCH lower anchor location  
•
Inspect the lower anchors by inserting  
your fingers into the lower anchor  
area. Feel to make sure there are no  
obstructions over the anchors such as  
seat belt webbing or seat cushion ma-  
terial. The child restraint will not be  
secured properly if the lower anchors  
are obstructed.  
LATCH lower anchor location  
The LATCH anchors are located at the rear of the  
seat cushion near the seatback. A label is at-  
tached to the seatback to help you locate the  
LATCH anchors.  
1-20 Safety–Seats, seat belts and supplemental restraint system  
Top tether anchor  
WARNING  
If the tonneau cover contacts the top  
•
tether strap when it is attached to the  
top tether anchor, remove the tonneau  
cover from the vehicle or secure it on  
the cargo floor below its attachment  
location. If the tonneau cover is not  
removed, it may damage the top tether  
strap during a collision. Your child  
could be seriously injured or killed in a  
collision if the child restraint top tether  
strap is damaged.  
Do not allow cargo to contact the top  
tether strap when it is attached to the  
top tether anchor. Properly secure the  
cargo so it does not contact the top  
tether strap. Cargo that is not properly  
secured or that contacts the top tether  
strap may damage the top tether strap  
during a collision. Your child could be  
seriously injured or killed in a collision  
if the child restraint top tether strap is  
damaged.  
LATCH webbing-mounted attachment  
Installing child restraint LATCH lower  
anchor attachments  
LATCH rigid-mounted attachment  
When installing a child restraint, carefully read  
and follow the instructions in this manual and  
those supplied with the child restraint.  
•
LATCH compatible child restraints include two  
rigid or webbing-mounted attachments that can  
be connected to two anchors located at certain  
seating positions in your vehicle. With this sys-  
tem, you do not have to use a vehicle seat belt to  
secure the child restraint. Check your child re-  
straint for a label stating that it is compatible with  
the LATCH system. This information may also be  
in the instructions provided by the child restraint  
manufacturer.  
Safety–Seats, seat belts and supplemental restraint system 1-21  

Related Topics

Popular Owner Manuals