2004-2009 Nissan Micra 4 Door In case of emergency -> Jump starting User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

In case of emergency -> Jump starting for Your Nissan Micra 4 Door Third Generation (2004-2009)

GUID-E4D85193-CD36-4C13-A769-57184268F3FB
WARNING:
. Incorrect jump starting can lead to a battery
explosion. The battery explosion may result
in severe injury or death. It may also result in
damage to the vehicle. Be sure to follow the
instructions in this section.
. Explosive hydrogen gas is always present in
the vicinity of the battery. Keep all sparks
and flames away from the battery.
. Always wear suitable eye protection and
remove rings, bracelets, and any other jew-
elry whenever working on or near a battery.
. Never lean over the batte ry while jump
starting.
. Never allow battery fluid to c ome i nto
contact with eyes, skin, clothes or the
vehicle’s painted surfaces. Battery fluid is a
corrosive sulfuric acid which can cause
severe burns. If the fluid comes into contact
with anything, immediately flush the con-
tacted area with plenty of water.
. Keep the battery out of the reach of children.
. The booster battery must be rated at 12
volts. Use of an incorrectly rated battery will
damage your vehicle.
. Never attempt to jump start a frozen battery.
It could explode and cause serious injury.
JVE0111X
HR12DDR engine model
JVE0112X
HR12DE and HR15DE engine model
JVE0113X
K9K engine model
1. If the booster battery is in another vehicle
*
B
,
position the two vehicles
*
A
and
*
B
to bring the
batteries into close proximity to each other.
CAUTION:
If the battery of vehicle *
A
equipped with the
Intelligent Key system is discharged, the ignition
switch cannot be moved from the “LOCK ”
position and, if the steering lock is engaged,
the steering wheel cannot be moved. Connect
the jumper cables to the booster vehicle
*
B
before turning the ignition switch and disenga-
ging the steering lock.
2. Apply the parking brake.
3. Automatic Transmission (AT)/Continuously Vari-
able Transmission (CVT) model: Move the shift
lever to the “P” (Park) position.
Manual Transmission (MT) model: Move the shift
lever to the “N” (Neutral) position.
4. Switch off al l unnecessary electrical systems
(headlights, heater, air conditioner, etc.).
5. Turn the ignition switch to the “LOCK” position.
6. Remove the vent caps, if equipped, on the battery.
7. Cover the battery with a firmly wrung out moist
cloth to reduce the hazard of an explosion.
8. Connect the jumper cables in the sequence as
illustrated (
*
1
,
*
2
,
*
3
,
*
4
).
CAUTION:
. Always connect positive + to positive + and
negative 7 to body ground, NOT to the
battery’s negative 7.
In case of emergency 6-9
JUMP STARTING
6-10 In case of emergency
. Be sure that the jumper cables do not touch
moving parts in the engine compartment.
. Be sure that the jumper cable’s clamps do
not contact any other metal.
9. Start the engine of the booster vehicle
*
B
and let
it run for a few minutes.
10. Depress the accelerator pedal of the booster
vehicle
*
B
at about 2,000 rpm.
11. Start the engine of the jumped vehicle
*
A
in the
normal manner.
CAUTION:
. Never keep the starter motor engaged for
more than 10 seconds. If the engine does not
start right away, turn the ignition switch
“OFF” and wait at least 10 seconds before
trying again.
. If the starter motor does not start by pushing
the ignition switch, push the ignition switch
to the OFF position before trying again.
12. After the engine is started, carefully disconnect
the jumper cables in the opposite sequence from
that illustrated (
*
4
,
*
3
,
*
2
,
*
1
).
13. Remove and dispose of the cloth as it may be
contaminated with corrosive acid.
14. Replace the vent caps, if removed.
NOTE:
. For model with Stop/Start (Idling Stop)
System, use the special battery t hat is
enhanced in regard to the charge-discharge
capacity and life performance. Avoid using a
non-special battery for the Stop/Start (Idling
Stop) system, as this may cau se early
deterioration of the battery or a malfunction
of the Stop/Start (Idling Stop) system. For
the battery, it is recommended to use
Genuine NISSAN parts. For more informa-
tion, contact a NISSAN dealer.
. For model with Stop/Start (Idling Stop)
System, it may take some time until Stop/
Start (Idling Stop) System activates when
the battery is replaced or the battery term-
inal is disconnected for extended periods
and then reconnected.
GUID-818A8DA5-53AB-4D7C-8EC2-4D904BE854C1
Do not attempt to start the engine by pushing the
vehicle.
CAUTION:
. Automatic Transmission (AT)/Continuously
Variable Transmission (CVT)/Manual Trans-
mission (MT) model cannot be started by
pushing. Attempting to do so may cause
damage to the transmission.
. Three-way catalyst equipped model should
not be started by pushing. Attempting to do
so may cause damage to the catalyst.
. Never try to start the engine by towing.
When the engine starts, the forward surge
could cause the vehicle to collide with the
towing vehicle.
. Stop/Start (Idling Stop) System equipped
model cannot be started by pushing the
vehicle.
PUSH STARTING

Related Topics

Popular Owner Manuals