2004-2009 Nissan Micra 4 Door Pre-driving checks and adjustments -> Security system (if equipped) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Pre-driving checks and adjustments -> Security system (if equipped) for Your Nissan Micra 4 Door Third Generation (2004-2009)

Using panic alarm (if equipped)
GUID-76F2F34C-D427-4978-AD42-73F68D651FDF
If you are near your vehicle and feel threatened, you
may activate the alarm to call attention as follows:
1. Push the “PANIC ”
button
*
3
on the
Intelligent Key for more than 0.5 second.
2. The theft warn ing ala rm will stay on for 25
seconds.
3. The panic alarm stops when:
. It has run for 25 seconds, or
. Any of the buttons on the Intelligent Key are
pushed. (Note: Panic button should be pushed for
more than 0.5 second.)
Hazard indicator operation (if equipped)
GUID-3E887246-B122-4252-A41B-AD8DFF22C927
When you lock or unlock the doors, the hazard
indicator will flash as a confirmation.
. “LOCK”: The hazard indicator flashes once.
. “UNLOCK”: The hazard indicator flashes twice.
GUID-D9223F4A-C4F7-4DF4-923C-4DF78DD063B5
Your vehicle is equipped with either or both of the
following security systems:
. Theft warning system
. NISSAN Anti-Theft System (NATS)*
(* immobilizer)
The security condition will be shown by the security
indicator light.
THEFT WARNING SYSTEM
GUID-DD6E3CC0-5B1E-4CA5-8698-5B35C2258338
The theft warning system provides visual and audio
alarm signals if parts of the vehicle are disturbed.
Security indicator light
GUID-073B545C-0620-45E1-B6A4-ADFF07C91CB8
SIC2045
The security indicator light is located in the meter
panel.
This light operates whenever the ignition switch is in
the “ACC”, “OFF” or “LOCK” position. This is normal.
How to activate the system:
GUID-9E14C2E6-2E9C-4731-980B-C45B899B977B
1. Close all windows and push the ignition switch to
the “OFF” position.
The system can be activated even if the
windows are open.
2. Carry the Intelligent Key with you and get out of
the vehicle.
3. Make sure the hood is closed. Close and lock all
doors with the door handle request switch, LOCK
button
*
1
on the Intelligent Key (If the door
is locked using the inside lock knob, the system
will not be activated) or power door lock switch (If
the door is locked using the power door lock
switch with all the doors closed, the system will
not be activated. To activate the system, lock the
door using the power door lock switch with any of
the doors open, then close all the doors).
4. Confirm that the security indicator light comes on.
The security indicator light stays on for approxi-
mately 30 seconds. The vehicle security system is
now pre-armed. After approximately 30 seconds
the vehicle security system automatically shifts
into the armed phase. The security light begins to
flash once every approximately 3 seconds.
If, during this 30-second pre-arm time period, the
door is unlocked with the door handle request
switch, the “UNLOCK”
button
*
2
on the
Intelligent Key, the power door lock switch, or the
ignition switch is pushed to the “ACC” or “ON”
position, the system will not arm.
Even when the driver and/or passengers are in
the vehicle, the system will activate with all
doors locked and ignition switch in the “LOCK”
position. Push the ignition switch to the “ACC” or
“ON” position to turn the system off.
Theft warning system operation:
GUID-9E14C2E6-2E9C-4731-980B-C45B899B977B
The warning system will give the following alarm:
. The hazard indicator blinks and the horn sounds
intermittently for approximately 30 seconds.
Pre-driving checks and adjustments 3-17
SECURITY SYSTEM (if equipped)
3-18 Pre-driving checks and adjustments
. The alarm automatically turns off after approxi-
mately 30 seconds. However, the alarm reacti-
vates if the vehicle is tampered with again.
The alarm is activated by:
. Operating the door without using the Intelligent
Key system.
. Opening the hood.
How to stop alarm:
GUID-9E14C2E6-2E9C-4731-980B-C45B899B977B
. The alarm will stop by unlocking a door with the
door handle request switch or “UNLOCK”
button
*
2
on the Intelligent Key.
. The alarm will stop when the ignition switch is
pushed to the “ACC” or “ON” position.
If the system does not operate as described
above, have it checked by a NISSAN dealer.
NISSAN ANTI-THEFT SYSTEM (NATS)
GUID-146D5E08-481D-4F27-9160-54A5B46F3FD6
The NISSAN Anti-Theft System (NATS) will not allow
the engine to start without the use of the registered
NATS key.
If the engine does not start using the registered NATS
key, it may be due to interference caused by:
. Another NATS key.
. Automated toll road device.
. Automated payment device.
. Other devices that transmit similar signals.
Start the engine using the following procedure:
1. Remo ve any it ems tha t may be cau sing the
interference away from the NATS key.
2. Leave the ignition switch in the “ON” position for
approximately 5 seconds.
3. Turn the ignition switch to the “OFF” or “LOCK”
position, and wait approximately 10 seconds.
4. Repeat steps 2 and 3 again.
5. Start the engine.
6. Repeat the steps above until all possible inter-
ferences are eliminated.
If this procedure allows the engine to start, NISSAN
recommends placing the registered NATS key sepa-
rate from other devices to avoid interference.
FCC WARNING:
Changes or modifications not expressly ap-
proved by the party responsible for compliance
could void the user’s authority to operate the
equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions; (1) This device may not cause harm-
ful interference, and (2) this device must accept
any interference received, including interference
that may cause undesired operat ion of the
device.
Security indicator light
GUID-8BD5CF73-A6D C-4C4B-B5A1-B87AA750F0BA
SIC2045
The security indicator light is located on the meter
panel. It indicates the status of NATS.
The light operates whenever the ignition switch is in
the “LOCK”, “OFF” or “ACC” position. The security
indicator light indicates that the security systems on
the vehicle are operational.
If NATS is malfunctioning, this light will remain on while
the ignition switch is in the “ON” position.
If the light remains on and/or the engine does
not start, contact a NISSAN dealer for NATS
service as soon as possible. Be sure to bring all
NATS keys that you have when visiting a NISSAN
dealer for service.
For Right-Hand Drive (RHD) model (for Europe):
GUID-9E14C2E6-2E9C-4731-980B-C45B899B977B
If NATS is malfunctioning, the security indicator light
will illuminate when the ignition switch is in the “ON”
position. However, if the security indicator light turns
off after 15 minutes, you can start the engine once.
See a NISSAN dealer for NATS service as soon as
possible.

Related Topics

Popular Owner Manuals