2017-2023 Nissan Micra 4 Door Do-it-yourself -> Battery replacement User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Do-it-yourself -> Battery replacement for Your Nissan Micra 4 Door Fifth Generation (2017-2023)

BATTERY REPLACEMENT  
CAUTION  
Be careful not to allow children to swal-  
low the battery or removed parts.  
2. Insert a small screwdriver into the slit of  
B
the corner  
and twist it to separate  
the upper part from the lower part. Use  
a cloth to protect the casing.  
3. Replace the battery with a new one.  
∙ Do not touch the internal circuit and  
electric terminals as doing so could  
cause a malfunction.  
∙ Make sure that the + side faces the  
C
bottom of the case  
.
Recommended battery: CR1620 or equiva-  
lent.  
4. Close the lid and install the screw se-  
curely.  
5. Operate the buttons to check its op-  
eration.  
If replacement is required, it is recom-  
mended that you visit a NISSAN dealer for  
this service.  
SDI2134A  
If the battery is removed for any reason  
other than replacement, perform step 5.  
KEY FOB (if so equipped)  
Replace the battery in the key fob as fol-  
lows:  
An improperly disposed battery can  
hurt the environment. Always con-  
firm local regulations for battery dis-  
posal.  
A
1. Remove the screw  
.
Do-it-yourself 8-21  
LIGHTS  
The key fob is water-resistant; how-  
ever, if it does get wet, immediately  
wipe completely dry.  
For Canada:  
HEADLIGHTS  
For additional information on headlight  
bulb replacement, refer to the instructions  
outlined in this section.  
This device complies with Industry  
Canada licence-exempt RSS standard(s).  
Operation is subject to the following two  
conditions: (1) this device may not cause  
interference, and (2) this device must ac-  
cept any interference, including interfer-  
ence that may cause undesired opera-  
tion of the device.  
The operational range of the key fob  
extends to approximately 10 m (33 ft)  
from the vehicle. This range may vary  
with conditions.  
Operation is subject to the following two  
conditions: (1) This device may not cause  
harmful interference, and (2) this device  
must accept any interference received,  
including interference that may cause  
undesired operation of the device.  
FCC Notice:  
For USA:  
This device complies with Part 15 of the  
FCC Rules. Operation is subject to the fol-  
lowing two conditions: (1) This device  
may not cause harmful interference, and  
(2) this device must accept any interfer-  
ence received, including interference  
that may cause undesired operation.  
Note:  
Changes or modifications not expressly  
approved by the party responsible for  
compliance could void the user’s author-  
ity to operate the equipment.  
8-22 Do-it-yourself  

Related Topics

Popular Owner Manuals