Pre-driving checks and adjustments -> Integrated key for remote control system for Your Nissan Patrol SUV Fifth Generation (1998-2009)

INTEGRATED KEY FOB/REMOTE  
CONTROL SYSTEM (if so  
equipped)  
Do not place the remote controller for  
an extended period in an area where  
temperatures exceed 60°C (140°ꢀꢁ  
All doors can be locked/unlocked from the outf  
side by pressing the LOCK/UNLOCK button  
the integrated keyfob.  
USING INTEGRATED KEYFOBI  
REMOTE CONTROL SYSTEM  
3. The panic alarm stops when:  
Unlocking doors  
It has run for about 30 seconds, or  
1 . Push the UNLOCK button on the remote  
controller.  
A
WARNING:  
The LOCK or UNLOCK button is pressed, or  
If a remote controller is lost or stolen,  
The remote controller can operate at a d  
of approximately 1 m (3.3 ft) from the  
(The effective distance depends upon the  
ditions around the vehicle.)  
For Super Lock System equipped models,  
failure to follow the precautions below  
may lead to hazardous situations. Make  
sure the Super Lock System activation is  
always safely conducted.  
NISSAN recommends erasing the ID code  
Only the driver's door unlocks.  
The PANIC button is pushed on the remote  
controller for longer than 0.5 second.  
of that controller. This will 'prevent the  
controllerfrom unauthorized use to unlock  
the vehicle. For information regarding the  
erasing procedure, contact a NISSAN  
dealer.  
The hazard indicators flash once.  
The room light will stay on for 30 seconds  
when the room light switch is in the center 0  
position.  
As many as four remote controllers can be  
with one vehicle. For information concerning  
purchase and use of additional remote  
lers, contact a NISSAN dealer.  
When the vehicle is occupied, never lock  
the dooꢂ with the remote controller.  
Doing so will trap the occupants, since  
the Super Lock System prevents the  
dooꢂ from being opened from the in-  
side of the vehicle.  
If your vehicle is equipped with a genuine  
NISSAN anti-theft system, operating the remote  
control door lock system will simultaneously  
operate the anti-theft system.  
2. Push the UNLOCK button on the remote  
controller again within 5 seconds.  
CAUTION:  
All doors unlock.  
Always remove the ignition key, close  
Locking doors  
The hazard indicators flash once.  
of a  
replacement  
ing the  
regard  
nformation  
For i  
op-  
before  
sunroof  
the  
and  
dows  
all win  
1 . Remove the ignition key.  
2. Close all the doors.  
Only operate the remote controller lock  
button when there is a clearview of the  
vehicle. This is to prevent anybody from  
being trapped inside the vehicle  
through the Super Lock System activa-  
tion.  
battery, see "Battery" in the "8. Maintenance and  
erating the system.  
The room light can be turned offwithout waiting  
for 30 seconds by turning the ignition switch to  
the ON position or by locking the doors with the  
remote controller.  
do-it-yourself" section.  
Ensure that the driver's door is securely  
closed before operating the remote  
control door lock system, to ensure cor-  
rect operation of the system.  
3. Push the LOCK button on the remote con-  
troller.  
Using panic alarm  
4. The hazard indicators flash once.  
5. All the doors will lock.  
Listed below are conditions or occurrences  
which will damage the remote controller.  
If you are near your vehicle and feel threatened,  
you may activate the alarm to call attention as  
follows:  
All of the dooꢂ will lock when the LOCK  
button on the remote controller is pushed  
even if the key is in the ignition switch.  
However, the super lock system (if so  
equipped) does not activate.  
Do not allow the remote controller to  
become wet.  
1 . Push the PANIC button on the remote con- .  
troller for longer than 0.5 second.  
Do not drop the remote controller.  
2. The theft warning alarm and headlights will  
stay on for about 30 seconds.  
Do not strike the remote controller  
sharply against another object.  
When the LOCK button is pushed with all  
Pre-driving.checks and adjustments ꢀꢁꢂ 1  
3-1 0 Pre-driving checks and adjustments  
SECURITY SYSTEM (if so  
equipped)  
.
the LOCK button on the remote controller (if  
so equipped).  
The headlights blink and the horn sounds  
intermittently.  
NISSAN ANTI-THEFT SYSTEM  
(NATS)  
ing  
ollOW  
e f  
f th  
h o  
bot  
or  
one  
has  
icle  
veh  
ur  
Yo  
hes  
flas  
already  
tor  
ica  
ind  
doors  
hazard  
e
th  
nder  
,
locked  
rs  
doo  
s:  
m
te  
sys  
ty  
uri  
sec  
.
are  
e
th  
at  
th  
mi  
re  
a
as  
ce  
on  
locked  
4. Confirm that the security indicator light  
comes on. The light glows for ,about 30  
seconds and then blink. The system is now  
activated. If, during this 30 second time  
period, the door is unlocked by the key or the  
remote controller, or the ignition switch is  
turned to ACC or ON, the system will not  
activate.  
The alarm automatically turns off after 2 to 3  
minutes. However, the alarm reactivates if the  
vehicle is tampered with again.  
The NISSAN Anti-Theft System (NATS)' will not  
allow the engine to start without the use of the  
registered NATS key.  
.
Theft warning  
Unlocking doors  
NISSAN Anti-Theft System (NATS),  
(' immobilizer)  
Type A:  
The alarm is activated by:  
'Immobilizer  
The security condition will be shown by the  
security indicator light.  
1 . Push the UNLOCK button on the remote  
controller once.  
Unlocking the door or back door without  
using the keyor remote controller. (Even if the  
door is opened by releasing the door inside  
lock knob, the alarm is activated.)  
If the engine fails to start using the registered  
NATS key, it may be due to interference caused  
by another NATS key, an automated toll road  
device or automated payment device on the key  
ring. Restart the engine using the following  
procedures:  
THEFT WARNING  
Only the driver's door unlocks  
d
are  
an  
ual  
vis  
ve  
provides  
tem  
sys  
g
nin  
war  
ft  
the  
e
Th  
au  
The hazard indicators flash twice.  
CAUTION:  
le  
hic  
the  
of  
ts  
if par  
nals  
sig  
m
alar  
dio  
Connecting the battery connector after it has  
been disconnected from battery for more  
than 1 second.  
2. Push the UNLOCK button ,on the remote  
controller again within 5 seconds.  
If the key is turned slowꢅy towꢄrd the  
front of the vehicle when ꢅocking the  
door, the system mꢄy not ꢄctivꢄte. If the  
key is returned beyond the veꢃicꢄꢅ po-  
sition towꢄrd the reꢄr of the vehicꢅe to  
remove the key, the system mꢄy be  
deꢄctivꢄted. If the indicꢄtor ꢅight fꢄils to  
gow for 30 seconds, unlock the door  
once ꢄnd lock it gꢄin.  
.
rbed  
tu  
dis  
Security indicator light  
(Except for TD42ITD42Ti engine models):  
All doors unlock  
n,  
i  
h i  
tc  
wi  
n �  
itio  
ign  
Opening the hood. (Even if the hood is  
opened by the hood release handle, the alarm  
is activated.) - if so designed  
the  
ever  
en  
wh  
nks  
bli  
LOCK  
ht  
lig  
is  
the  
ind  
1 . Leave the ignition switch in the ON position  
for approximately 5 seconds.  
Th  
The hazard indicators flash twice.  
n
tio  
nc  
fu  
is  
Th  
n.  
tio  
posi  
ACC  
or  
, OFF  
the  
on  
uipped  
eq  
s
tem  
sys  
ty  
uri  
tio  
e sec  
th  
tes  
hicle  
ica  
Type B:  
2. Turn the ignition switch to the OFF or LOCK  
position and wait approximately 5 seconds.  
.
nal  
opera  
are  
ve  
1 . Push the UNLOCK button on the remote  
controller.  
How to stop alarm  
How to activate the theft warning  
system  
The alarm will stop only by unlocking a door or  
back door with the key or by pressing the  
UNLOCK button on the remote controller. The  
alarm will not stop if the ignition switch is turned  
to ACC or ON.  
3.  
Repeat step 1 and 2 again.  
2. The hazard indicators flash twice.  
3. All doors will unlock.  
Even when the driver ꢄnd/or pꢄssengers  
ꢄre in the vehicle, the system wiꢅl ꢄcti-  
vꢄte with ꢄꢅl doors ꢅocked ꢄnd ignition  
key off. Turn the ignition switch to ACC  
to turn the system off.  
4. Restart the engine while holding the device  
(which may have caused the interference)  
separate from the registered NATS key.  
1 . Close all windows.  
The system cꢄn be ꢄctivꢄted even if the  
windows ꢄre open.  
(For TD42ITD42Ti engine models):  
1 . Turn the ignition switch to OFF.  
If the system does not operꢄte ꢄs de-  
scribed ꢄbove, hꢄve it checked by ꢄ  
NISSAN deꢄler.  
2. Remove the key from the ignition switch.  
Theft warning system activation  
3. Close and lock all doors, hood and back  
door. Lock all doors by the key or pressing  
2. Wait for 1 minute. The security indicator light  
will blink.  
The warning system will give the following alarm:  
i !  
Pre-driving checks ꢄnd ꢄdjustments 3-ꢂ 3  
3-1 2 Pre-driving checks ꢄnd ꢄdjustments