Get Heater, air conditioner and audio systems -> FM-AM RADIO WITH COMPACT DISC (CD) PLAYER Guide for Nissan X Trail SUV First Generation (2000-2006)

FM-AM RADIO WITH COMPACT

DISC (CD) PLAYER

1. PRESET ABC button

2. Display

3. CD button

4. CD eject button

5. CD insert slot

6. MENU button

7. AUDIO button

8. Station select buttons

9. SEEK/TRACK button

10.PWR/VOL control knob

11.BAND select button

Audio main operation

PWR/VOL control knob:

Turn the ignition key to the ACC or ON position,

then push the PWR/VOL control knob. If you

listen to the radio with the engine not running,

turn the key to the ACC position. The mode

(radio or CD) that was playing immediately be-

fore the system was turned off resumes playing.

When no CD is loaded, the radio comes on.

Pushing the PWR/VOL control knob again turns

the system off.

Turn the PWR/VOL control knob to the right to

increase volume or to the left to decrease vol-

ume.

SAA0840

4-20 Heater, air conditioner and audio systems

墌 04.6.10/T30-J/V5.0 墍

Adjusting tone quality and speaker bal-

ance:

To adjust the audio levels for bass, treble, fader,

and balance, push the AUDIO button and adjust

the level with the SEEK/TRACK button. Press

the AUDIO button once for BASS (bass), twice

for TREB (treble), 3 times for FAD (fader) and 4

times for BAL (balance). Once the audio level is

set the display will return back to radio or CD

display mode after 7 seconds or the AUDIO

button can be pressed again within 7 seconds to

set the next audio level. Pressing the AUDIO

button a fifth time will return the display back to

radio or CD display mode.

Fader adjusts the sound level between the front

and rear speakers, and balance adjusts the

sound level between the right and left speakers.

FM-AM radio operation

FM-AM band select :

Push the

button to change from AM to FM

reception.

The FM stereo indicator, ST, illuminates during

FM stereo reception. When the stereo broad-

cast signal is weak, the radio automatically

changes from stereo to monaural reception.

SEEK/manual/SCAN

tuning :

When the

button is pushed while the radio

is playing, tuning mode is cycled between:

SEEK tuning → manual tuning → SCAN mode

“TUNE” and “SCAN” are shown in the display

for each mode. No icon is displayed for SEEK

mode.

WARNING

The radio should not be tuned while

driving so full attention may be given to

vehicle operation.

SEEK tuning

Push the SEEK/TRACK tuning button (

) for less than 1.5 seconds. SEEK tuning

begins from low to high frequencies or high to

low frequencies, depending on which button is

pressed, and stops at the next broadcasting

station. If using the

button, once the high-

est broadcasting station is reached, the radio

continues in the SEEK mode at the lowest

broadcasting station. If using the

button,

once the lowest broadcasting station is reached,

the radio continues in the SEEK mode at the

highest broadcasting station.

Manual tuning

Use the

and buttons for manual

tuning. To move quickly through the channels,

hold either of the tuning buttons down.

SAA0841

Heater, air conditioner and audio systems 4-21

墌 04.6.10/T30-J/V5.0 墍

SCAN tuning

Push and hold the SEEK/TRACK tuning button

(

or ) for more than 1.5 seconds.

SCAN illuminates in the display window, and the

radio station blinks. SCAN tuning begins from

low to high frequencies or high to low frequen-

cies, depending on which button is pressed.

SCAN tuning stops at each broadcasting station

for 5 seconds. When scanning, SCAN is solid

and the radio station blinks. When temporarily

stopped on a station, SCAN blinks and the

station display is solid. Pushing the button again

during this 5 second period stops SCAN tuning

and the radio remains tuned to that station.

Station memory operations:

Each preset mode (A, B or C) has 6 presets,

capable of storing any combination of AM and

FM stations.

Press the PRESET ABC button to change be-

tween the presets:

A→B→C

The radio displays icon A, B or C to indicate

which set of presets is active.

To store a radio station in a preset:

1. Select the desired preset by pressing PRE-

SET ABC button.

2. Tune to the desired station.

3. Press the desired station select button for

more than 3 seconds. For example, in the

illustrations, ch2 is to be memorized. The

radio mutes when the station select button is

pushed.

4. When the indicator illuminates in the display

and the sound resumes, memorizing is com-

plete.

5. Other station select buttons can be set in the

same manner.

If the battery cable is disconnected, or if the

radio fuse opens, the radio memory is canceled.

In that case, reset the desired stations.

Compact disc (CD) player operation

Turn the ignition key to the ACC or ON position,

and carefully insert the compact disc into the

SAA0842

4-22 Heater, air conditioner and audio systems

墌 04.6.10/T30-J/V5.0 墍

slot with the label side up. The compact disc is

automatically pulled into the slot and starts to

play.

If the radio is already operating, it automatically

turns off and the compact disc begins to play.

CAUTION

Do not force a compact disc into the

slot. This could damage the player.

CD button :

When the CD button is pushed with a compact

disc loaded and the radio playing, the radio turns

off and the compact disc starts to play.

Track up/down, FF/REV

(rewind) buttons :

Track up/down

When the button is pushed and released

while the compact disc is playing, the selection

following the present one starts to play from the

beginning. Push the

button several times

to skip several selections. Each time the button

is pushed, the CD advances 1 additional selec-

tion. The number appears in the display window.

(When the last selection on the compact disc is

skipped, the first selection is played.)

When the

button is pushed and released,

the selection being played returns to the begin-

ning. Push the

button several times to skip

back several selections. Each time the button is

pushed, the CD moves back 1 selection.

If the play pattern is in MIX mode when the

or button is pushed the next selec-

tion will be chosen at random.

FF (Fast Forward)/REV (Reverse)

When the or button is pushed and

held while the compact disc is playing, the

compact disc plays at an increased speed while

fast forwarding or rewinding. When the button is

released, the compact disc returns to normal

play speed.

MENU :

When the

button is pushed while the

compact disc is playing, the play pattern

changes as follows:

RPT: The current selection is repeated.

MIX: Selections are played at random, not

following the sequence on the compact disc.

The same program may be repeated twice. If the

button is pushed in the MIX mode, selec-

tions will be chosen at random.

Blank (no symbol): All selections are played

repeatedly in sequence.

When a new compact disc is inserted, the

play pattern automatically changes to ALL.

CD EJECT button :

When the

button is pushed with a com-

pact disc loaded, the compact disc ejects.

When the

button is pushed while the

compact disc is playing, the compact disc ejects

and the system turns off.

DISC indicator light :

This light

comes on when a compact disc

is loaded into the player.

Heater, air conditioner and audio systems 4-23

墌 04.6.10/T30-J/V5.0 墍

Heater, air conditioner and audio systems -> FM-AM RADIO WITH COMPACT DISC (CD) PLAYER for Your Nissan X Trail SUV First Generation (2000-2006)

Related Topics

Popular Owner Manuals

Latest Owner Manuals