WARNING
쐌 When engine is running, keep hands
and clothing away from any moving
parts such as fan drive belt.
쐌 Automatic transmission fluid is poi-
sonous and should be stored care-
fully in marked containers out of the
reach of children.
The fluid level should be checked using the HOT
range on the dipstick at fluid temperatures be-
tween 50 and 80°C (122 and 176°F) after the
vehicle has been driven approximately 5 minutes
in urban areas after the engine is warmed up.
The level can be checked at fluid temperatures
between 30 and 50°C (86 and 122°F) using the
COLD range on the dipstick for reference, after
the engine is warmed up but before driving.
However, the fluid level must be rechecked
using the HOT range.
1. Park the vehicle on a level surface and set the
parking brake.
2. Start the engine and then move the selector
lever through each gear range, ending in P.
3. Check the fluid level with the engine idling.
If the vehicle has been driven for a long
time at high speeds, or in city traffic in hot
weather, or if it is being used to pull a
trailer, the fluid level cannot be read accu-
rately. You should wait until the fluid has
cooled down (about 30 minutes).
4. Remove the dipstick and wipe it clean with
lint-free paper.
5. Re-insert the dipstick into the charging pipe
as far as it will go.
6. Remove the dipstick and note the reading.
If the level is on the low side of either range, add
fluid to the charging pipe.
Do not overfill.
CAUTION
Use CANADA NISSAN Automatic Trans-
mission Fluid (ATF) or equivalent. (For
more information regarding suitable flu-
ids, contact a NISSAN dealer for cor-
rect brands of DEXRON
TM
III/MERCON
TM
Automatic Transmission Fluid.)
SDI1583
AUTOMATIC TRANSMISSION
FLUID
Maintenance and do-it-yourself 8-13
墌 04.6.10/T30-J/V5.0 墍
English 
