Reinitialisation
Following reconnection of the bat-
tery, in the event of a malfunction or
in the event of unwanted opening of
the roof on closing, the safety auto-
reverse must be reinitialised:
-
place the dial in the fully closed
position (initial position "O"),
-
-
press the dial immediately,
continue to press until the roof
is fully closed.
PANORAMIC SUNROOF
Operation
To open: turn the dial to the left
(nine possible settings).
Once the roof is open, the front
shutter cannot be closed.
The safety autoꢀreverse function
is not operational during this
operation.
This sunroof is a panoramic assembly
which provides maximum brightness
and visibility in the passenger com-
partment.
Always remove the ignition
key when leaving the vehicle,
even for a short time.
It consists of two parts:
To close: return the control to the
initial position "O".
-
-
a fixed rear part,
a moving front part.
In the event of contact during operation
of the roof, the movement of the roof
must be reversed. To do this, operate
the control concerned.
Each part has an independent
manual shutter.
The sunroof is controlled electrically
by a dial with 9 opening positions.
When the driver operates the roof
control, he must ensure that no one
is preventing the roof from closing
correctly.
The driver must ensure that the
passengers use the sunroof correctly.
Safety autoꢀreverse
When the roof meets an obstacle
while closing, it partially opens
again.
Be aware of children when operating
the roof.
Check that the slides are clean
to ensure that the sunroof slides
correctly.
You can close the sunroof
using the remote control
when locking (refer to the
corresponding chapter).
84
English