80 - DRIVING
Reactivating the cruise control
To memorise a speed lower than the
previous one:
F press button 2;
A brief press decreases by 1 mph (1 km/h).
An extended press decreases by 5 mph
(5 km/h).
Operating fault
After cancellation of the cruise con-
trol, press button 4. Your vehicle will
return to the last memorised speed.
The display indicates (e.g. at 70 mph
(110 km/h)):
In the event of a cruise control mal-
function, the memorised speed is
erased, the dashes lash for a few
seconds:
A maintained press decreases in
steps of 5 mph (5 km/h).
Cancelling the memorised
reference speed
F When the vehicle becomes
stationary, after switching off the
ignition, the system no longer
memorises a speed.
Contact a PEUGEOT dealer to have
the system checked.
It is also possible to reactivate the
cruise control by pressing button 2 or
3. The memorised speed will then be
the speed at which the vehicle was
travelling when the cruise control
was reactivated.
When changing the memo-
rised reference speed by
means of a maintained press,
pay attention as the speed
can increase or decrease rapidly.
Do not use the cruise control on slip-
pery roads or in heavy trafic.
Changing the memorised
reference speed
To memorise a speed higher than the
Switching the function off
F Place dial 1 in position 0 to
switch the system off.
previous one, there are two options:
In the event of a steep slope, the cruise
control cannot prevent the vehicle from
exceeding the programmed speed.
In any event, the cruise control cannot
replace the need to observe the speed
limits, nor can it replace the need for
vigilance and responsibility on the part
of the driver.
Without using the accelerator:
F press button 3;
A brief press increases by 1 mph
(1 km/h).
An extended press increases by 5 mph
(5 km/h).
A maintained press increases in
steps of 5 mph (5 km/h).
To prevent the mat from becoming
caught under the pedals:
-
ensure that the mat and
its ixings are positioned
correctly.
never it one mat on top of
another.
Using the accelerator:
F exceed the memorised speed
until the required speed is
reached,
-
F press button 2 or 3.
You are advised to keep your feet
near the pedals.
English 