Driving
Without touch screen
Malfunction
The flashing and then fixed illumination of the
under-inflation warning lamp, accompanied by
the illumination of the Service warning lamp,
indicates a fault with the system.
F With the ignition on and the vehicle
stationary, press this button for about
3 seconds then release it, an audible signal
confirms the reinitialisation.
In this case, under-inflation monitoring of the
tyres is no longer assured.
1. Speed limiter mode selection/off.
2. Increases the set value.
3. Decreases the set value.
4. Speed limiter on/pause.
With touch screen
The reinitialisation of the system is done with
the ignition on and the vehicle stationary.
Have the system checked by a PEUGEOT
dealer or a qualified workshop.
After any intervention on the system,
the pressures of the four tyres must be
checked and the system reinitialised.
The reinitialisation of the system is
configured in the Driving/Vehicle
menu.
The speed setting is selected with the engine
running, stationary or when driving. The
minimum speed setting possible is 19 mph
(30 km/h).
6
The vehicle responds to the accelerator until
resistance is felt in the pedal, which signifies
that the vehicle has reached the limiter speed
setting.
However, pressing the pedal beyond this point
of resistance to the floor permits exceeding
of the programmed speed. To resume use
of the limiter, simply reduce the pressure on
the accelerator pedal gradually and return to
a speed below that programmed.
Speed limiter "LIMIT"
The system prevents the vehicle from
exceeding the speed setting programmed by
the driver.
The new pressure parameters saved are
treated as reference values by the system.
Snow chains
The system does not have to be
reinitialised after fitting or removing snow
chains.
Steering mounted controls
Setting and operation of the system can be
done stationary with the engine running or
when driving.
91