78
YOUR 306 IN DETAIL
CHANGING THE REMOTE
CONTROL BATTERIES
A
To gain access to the battery, unclip
the key casing with a coin where you
can see the ring (CR1620/3 volt
battery).
If the remote control does not work
after the battery has been changed,
re-programme the remote control.
PROGRAMMING THE
REMOTE CONTROL
B
Manual synchronisation
- Switch off the ignition,
- Switch on the ignition,
- Immediately after switching on the
ignition press button A.
KEYS
THE REMOTE CONTROL
A single press on button A locks the
doors and boot or tailgate, this is dis-
played by the direction indicators
staying on for about 2 seconds.
A single press on button B unlocks
the vehicle, this is displayed by the
direction indicators flashing rapidly.
Without central locking
The key individually Iocks and unlocks
the doors and boot or tailgate.
The remote control is now working
again.
Automatic synchronisation
- Switch on the ignition (position M),
- Switch off the ignition and, during
the next four minutes, lock the
vehicle using the remote control
(button A).
With central locking
Turning the key in the driver’s door
lock will lock or unlock the doors and
boot or tailgate. If either of the front
doors is not closed, the central locking
will not work.
The remote control is now working
again.
Note: do not repeatedly press the
button of your remote control out of
range of your vehicle. You risk
causing it not to work and the remote
control would have to be repro-
grammed.
English