2001-2014 Peugeot 307 4 Door Checks -> Engine Compartments User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Checks -> Engine Compartments for Your Peugeot 307 4 Door 2001-2014

HANDBRAKE  
Applying  
"PORSCHE TIPTRONIC  
SYSTEM" AUTOMATIC  
GEARBOX  
Park: to immobilise the vehicle or  
start the engine, with the handbrake  
on or off.  
Pull the handbrake to immobilise  
your vehicle.  
Reverse: to reverse (select this  
position with the vehicle stationary,  
engine at idle).  
Releasing  
Pull on the handle and press the  
button to release the handbrake.  
Neutral: to start the engine and to  
park, with the handbrake on.  
Note: if position N is engaged inad-  
vertently while driving, allow the en-  
gine to return to idle before engaging  
position D to accelerate.  
When the vehicle is being  
driven, illumination of this  
warning light and of the  
Drive: for driving in automatic  
mode.  
STOP warning light, ac-  
companied by an audible  
signal and a message on the multi-  
function display, indicates that the  
handbrake is still on or has not been  
properly released.  
Manual: to select the gears.  
S sport programme.  
The four or six speed automatic  
gearbox offers a choice between the  
comfort of integral automatic op-  
eration, enhanced by a sport and a  
snow programme, or manual gear  
changing  
: snow programme.  
Starting the engine  
with the handbrake applied, select  
Gear selection gate  
Move the lever in the gate to  
select a position.  
position P N in the gate,  
turn the ignition key to the Starting  
position.  
The indicator light for the selec-  
tion is displayed on the instrument  
panel display.  
Otherwise, you are warned by an  
audible signal and a message on  
the multifunction display.  
When parking on a slope,  
direct your wheels towards  
the pavement and pull the  
handbrake.  
95  
HANDBRAKE  
Applying  
"PORSCHE TIPTRONIC  
SYSTEM" AUTOMATIC  
GEARBOX  
Park: to immobilise the vehicle or  
start the engine, with the handbrake  
on or off.  
Pull the handbrake to immobilise  
your vehicle.  
Reverse: to reverse (select this  
position with the vehicle stationary,  
engine at idle).  
Releasing  
Pull on the handle and press the  
button to release the handbrake.  
Neutral: to start the engine and to  
park, with the handbrake on.  
Note: if position N is engaged inad-  
vertently while driving, allow the en-  
gine to return to idle before engaging  
position D to accelerate.  
When the vehicle is being  
driven, illumination of this  
warning light and of the  
Drive: for driving in automatic  
mode.  
STOP warning light, ac-  
companied by an audible  
signal and a message on the multi-  
function display, indicates that the  
handbrake is still on or has not been  
properly released.  
Manual: to select the gears.  
S sport programme.  
The four or six speed automatic  
gearbox offers a choice between the  
comfort of integral automatic op-  
eration, enhanced by a sport and a  
snow programme, or manual gear  
changing  
: snow programme.  
Starting the engine  
with the handbrake applied, select  
Gear selection gate  
Move the lever in the gate to  
select a position.  
position P N in the gate,  
turn the ignition key to the Starting  
position.  
The indicator light for the selec-  
tion is displayed on the instrument  
panel display.  
Otherwise, you are warned by an  
audible signal and a message on  
the multifunction display.  
When parking on a slope,  
direct your wheels towards  
the pavement and pull the  
handbrake.  
95  
When maintenance opera-  
tions need to be carried out  
with the engine running, ap-  
ply the handbrake and select  
position P  
Never select position N when  
the vehicle is moving.  
Moving off  
With the engine running, to move off  
from position P  
Never select positions P  
unless the vehicle is stationary.  
R
it is essential to press the brake  
pedal,  
release the handbrake,  
Never change between positions  
to optimise braking on a slippery  
surface.  
Automatic operation  
Automatic changing of the four or  
six gears:  
select position R D  
M, then  
gradually release the pressure  
on the brake pedal; the vehicle  
moves off immediately.  
Sport and snow programmes  
In addition to the auto-adaptive  
programme, there are two special  
programmes.  
The programme is displayed on the  
instrument panel screen.  
select position D in the gate.  
You can also move off from position N  
The gearbox automatically adapts  
the gear in relation to the style of  
driving, the road profile and the ve-  
hicle load.  
The gearbox is then operating  
in auto-adaptive mode, without any  
action on your part.  
For immediate maximum accelera-  
tion without touching the gear lever,  
press the accelerator pedal down as  
far as it will go (kick down). The gear-  
box will automatically change down  
or maintain the gear selected until  
maximum engine speed is reached.  
When braking, the gearbox will  
automatically change down in order  
to provide efficient engine braking.  
Sport programme  
Press button S once the engine  
has been started.  
The gearbox automatically favours  
sporty driving and more dynamic  
acceleration.  
When the engine is at idle,  
brakes not applied, if posi-  
tion R D M is selected the  
vehicle moves even without  
the accelerator being pressed.  
For this reason, do not leave chil-  
dren unsupervised inside the ve-  
hicle, with the engine running  
If the lever is not in position P, an au-  
dible signal is heard and a message  
appears when the driver’s door is  
opened or approximately 45 seconds  
after the ignition is switched off. Move  
the lever to P. The audible signal  
stops and the message disappears.  
Snow programme  
This programme improves starting  
and drive when traction is poor.  
Press button once the engine  
If you take your foot off the accel-  
erator suddenly, the gearbox will not  
change to a higher gear for reasons  
of safety.  
has been started.  
The gearbox adapts to driving on  
slippery roads.  
Note: you can return to the auto-  
adaptive programme at any time.  
Press button S or again to switch  
off the programme you are in.  
96  
Notes  
Manual operation  
Manual changing of the four or six  
gears:  
Operating abnormality  
It is only possible to change from one  
gear to another if the vehicle speed  
and engine speed permit. If they do  
not, the vehicle will operate tempo-  
rarily in automatic mode.  
In the event of under-revving or over-  
revving, the gear selected flashes for  
a few seconds, then the actual gear  
engaged is displayed.  
When the vehicle is stationary or  
moving very slowly, the gearbox au-  
tomatically selects gear M1  
Programme S (sport) and (snow)  
do not operate in manual mode.  
Any operating abnormality  
is indicated by the display-  
ing of this warning light, an  
audible signal and a mes-  
sage on the multi-function  
display.  
select position M in the gate,  
push the lever to the  
change to a higher gear,  
sign to  
pull the lever to the  
change to a lower gear.  
sign to  
In this situation the gearbox oper-  
ates in downgrade mode (locked in  
3rd gear). You may feel a substan-  
tial knock when changing from P to  
R and from N to R (this will not cause  
any damage to the gearbox).  
Do not exceed 60 mph (100 km/h),  
keeping within the limit of local speed  
restrictions.  
You can change from position D  
(driving in automatic mode) to posi-  
tion M (driving in manual mode) at  
any time.  
Contact a PEUGEOT dealer as soon  
as possible.  
Invalid value during manual  
operation  
This is displayed if a gear  
is not engaged correctly  
(selector between two posi-  
tions).  
If the battery is flat and the  
lever is in position P, it will be  
impossible to change to an-  
other position.  
Above all, do not force the lever as  
there is a risk of damage to the auto-  
matic gearbox.  
97  
Storing a speed  
SPEED LIMITER*  
Instrument panel display  
A speed can be stored without acti-  
vating the limiter.  
Press buttons 2 and 3 briefly to de-  
crease or increase by 1 mph (1 km/h).  
An extended press decreases or  
increases by 5 mph (5 km/h).  
A maintained press decreases or  
increases the programmed speed in  
steps of 5 mph (5 km/h).  
This speed limiter, of the new gener-  
ation, has a display on the instrument  
panel to indicate the programmed  
speed.  
It prevents exceeding of the vehicle  
speed programmed by the driver.  
When the programmed speed is  
reached, pressing the accelerator  
pedal no longer has any effect.  
Activating/  
deactivating the limiter  
Pressing button 4 once activates  
the limiter, pressing the button again  
deactivates it.  
When the speed limiter function is  
active, pressing this button displays  
the distance recorders.  
After a few seconds or when this  
button is pressed again, the display  
returns to the speed limiter function.  
When the limiter is active, the display  
indicates (e.g. at 70 mph (110 km/h)):  
The limiter operates with a pro-  
grammed speed of at least 18 mph  
(30 km/h); it remains active regard-  
less of any action on the brake and  
clutch pedals.  
Selecting the function  
Place the dial 1 in the LIMIT posi-  
tion. The limiter is not yet active.  
By default, the display indicates:  
The operating actions must be  
carried out:  
- when stationary, with the engine  
running,  
or  
- with the vehicle moving.  
* According to country.  
98  
Exceeding the programmed  
speed  
In exceptional circumstances, use  
this mode to exceed the programmed  
speed.  
Switching the function off  
Place dial 1 in position 0 or switch  
off the ignition to switch the sys-  
tem off. The last programmed  
speed remains in the memory.  
Pressing the accelerator in order to  
exceed the programmed speed will  
have no effect unless you press the  
pedal firmly beyond the point of  
resistance  
The limiter is deactivated tempo-  
rarily and the speed displayed on  
the instrument panel flashes (e.g. at  
70 mph (110 km/h):  
Operating fault  
In the event of a limiter malfunction,  
the programmed speed is cleared,  
the dashes flash for a few seconds:  
Intheeventofasteepdescent  
or sharp acceleration, the  
speed limiter will not be able  
to prevent the vehicle from  
exceeding the programmed speed.  
In any event, the speed limiter cannot  
replace the need to observe speed  
limits, nor can it replace the need for  
vigilance and responsibility on the  
part of the driver.  
Note: the speed also flashes when  
the limiter cannot prevent the vehi-  
cle from exceeding the programmed  
speed (on a steep descent, in the  
event of sharp acceleration).  
To reactivate the limiter, release the  
accelerator to slow down to a speed  
below the programmed speed.  
Contact a PEUGEOT dealer to have  
the system checked.  
To prevent the mat from becoming  
caught under the pedals:  
- ensure that the mat is positioned  
correctly.  
- never fit one mat on top of another.  
99  

Related Topics

Popular Owner Manuals