BOOT LAYOUT (ESTATE)
1. Load space cover
To install it:
- position the front ends of the cover
on its support and press gently to
put it in place,
4. Boot floor and pillar stowing
rings
8. High load retaining net fixings
The high load retaining net can be
installed behind the front or rear
seats.
Open the covers of the correspond-
ing upper fixings.
Fit the ends of the metal bar in these
fixings.
To install the high load retaining net:
- behind the front seats, lift the rear
seat cushion, hook the net straps
on the fixings then fold the rear
seat;
- behind the rear seat, hook the net
straps in the stowing rings on the
floor.
The rings are located directly below
the corresponding upper fixings.
Pull the two straps taut.
5. Rear seat stowing rings
6. Luggage retaining net
Secure the net hooks in the stowing
rings on the floor or on the folded
rear seat (two horizontal positions)
or secure the net hooks in the stow-
ing rings on the boot pillars and in the
floor rings at the rear of the boot (one
vertical position).
- unfold the cover fully,
- position the rear ends of the cover
on its support and press gently to
put it in place.
To remove it:
- unclip the rear ends,
- fold the cover fully,
- unclip the front ends and remove
the cover.
To store it, slide it under the rear
seats (location A)
7. 12 volt socket (100 W max)
This is a lighter type socket, installed
on the load space cover left support.
It is supplied from the "Running" po-
sition.
2. Floor storage trays (2/3 - 1/3)
3. Storage nets
One of them contains the luggage re-
taining net.
9. Grab handles and coat hooks
85
English 
