2001-2014 Peugeot 307 4 Door Warning Lights and Indicators -> Operation Warning Lights User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Warning Lights and Indicators -> Operation Warning Lights for Your Peugeot 307 4 Door 2001-2014

Coolant temperature indicator  
Engine oil temperature gauge  
Automatic gearbox lever  
positions indicator  
Park  
Reverse  
Neutral  
Drive  
When the engine is running, this indi-  
cates the oil temperature.  
When the needle is in zone A, the  
temperature is correct.  
Manual mode:  
The temperature is too high if the  
maximum graduation is reached.  
You must stop immediately.  
When the needle is in zone B the  
temperature is too high. The central  
STOP warning light flashes,  
panied by an audible signal and a  
message on the multifunction dis-  
play.  
You must stop immediately.  
Warning: wait for the engine to cool  
before topping up the level.  
The cooling system is pressurised.  
In order to avoid any risk of scalding,  
unscrew the cap two turns to allow  
the pressure to drop.  
When the pressure has dropped, re-  
move the cap and top up the level.  
Contact a PEUGEOT dealer.  
1st gear engaged  
Contact a PEUGEOT dealer.  
2nd gear engaged  
3rd gear engaged  
4th gear engaged  
5th gear** engaged  
6th gear** engaged  
** According to model.  
21  
In the event of under-revving or over-  
revving, the gear selected flashes for  
a few seconds, then the actual gear  
engaged is displayed.  
INSTRUMENT PANEL DISPLAY  
Service indicator  
This indicates when the next service  
is due in accordance with the manu-  
facturer’s servicing schedule.  
The point at which the next service  
is due is calculated from the last indi-  
cator zero reset (see corresponding  
section). It is determined by two pa-  
rameters:  
Invalid value during manual  
operation  
- the distance travelled,  
- the time which has elapsed since  
the last service.  
This is displayed if a gear is  
not engaged correctly (selec-  
tor between two positions).  
Note: the distance remaining before  
the next service may be weighted  
by the time factor, depending on the  
user’s driving habits.  
After switching on the ignition, three  
functions are shown in succession:  
- service indicator,  
- engine oil level indicator,  
- total distance recorder (total and  
trip distances).  
Note: the total and trip distances are  
displayed for 30 seconds when the  
ignition is switched off, on opening  
the driver’s door, as well as on lock-  
ing and unlocking the vehicle.  
Automatic gearbox indicator  
lights  
"SPORT" indicator light  
This comes on when the  
"SPORT" programme on  
the automatic gearbox is se-  
lected.  
It also displays the information re-  
lating to the cruise control or speed  
limiter, when either of these is acti-  
vated (see corresponding section).  
"SNOW" indicator light  
This comes on when the  
"SNOW" programme on the  
automatic gearbox is selected.  
22  
Operation  
The distance remaining to  
the next service is less than  
500 miles (1,000 km).  
Example: 400 miles (900 km) remain  
before the next service.  
The service is overdue.  
The spanner flashes for 5 seconds  
after the ignition is switched on.  
For 5 seconds after the ignition is  
switched on, the spanner symbolis-  
ing the servicing operations comes  
on; the distance recorder display indi-  
cates the number of miles [kilometres]  
(rounded off) remaining until the next  
service.  
Example: the service is overdue by  
300 miles/km, your vehicle must be  
serviced as soon as possible.  
For 5 seconds after the ignition is  
switched on, the display indicates:  
For 5 seconds after the ignition is  
switched on, the display indicates:  
Example: 4,800 miles/km remain  
before the next service. For five sec-  
onds after the ignition is switched on,  
the display indicates:  
5 seconds after the ignition was  
switched on, the distance recorder  
resumes its normal operation and  
the spanner remains lit  
It indicates that a service must be  
carried out soon. The display indi-  
cates the total and trip distance.  
5 seconds after the ignition was  
switched on, the distance recorder  
resumes its normal operation and the  
spanner remains lit. The display indi-  
cates the total and trip distance.  
Note: the spanner may also come on  
if more than two years have elapsed  
since the last service.  
5 seconds after the ignition was  
switched on, the distance recorder  
resumes its normal operation and  
the display indicates the total and trip  
distance.  
23  

Related Topics

Popular Owner Manuals