Service indicator zero re-set
Dipstick
Engine oil level indicator
When the ignition is switched on,
the engine oil level is indicated for
a few seconds, after the service
information.
There are 2 marks on the
dipstick:
- never exceed level A,
- in position B, top up the
level via the oil filler cap,
using the type of oil suit-
ed to your engine.
Oil level correct
A
B = min.
Lack of oil
Flashing of "OIL"
linked with the serv-
Your PEUGEOT dealer carries out
this operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:
ice warning light,
accompanied by an
audible signal and
a message on the
multifunction display, indicates a lack of
oil which could damage the engine.
Switch off the ignition,
If the lack of oil is confirmed by a
check using the dipstick, it is essen-
tial that the level is topped up.
Press and hold the trip recorder
re-set button,
Switch on the ignition.
The display begins a countdown.
Oil level gauge fault
When the display shows "=0", re-
lease the button; the spanner disap-
pears.
Important: after this operation, if you
wish to disconnect the battery, lock
the vehicle and wait for at least five
minutes, otherwise the zero re-set
will not be registered.
Flashing of "OIL "
indicates a malfunc-
tion of the engine oil
level gauge.
Contact a PEUGEOT dealer.
The level read will only be correct if
the vehicle is on level ground and
the engine has been off for more
than 15 minutes.
24
English 
