Access
The electric window switches remain
operational for approximately one minute after
the key has been removed.
Once this time has elapsed, the electric
windows will not operate. To reactivate them,
switch the ignition on again.
With the warning lamp off, the switches are
active.
Electric windows
Reinitialising the electric
windows
Following reconnection of the battery, the
safety anti-pinch function must be reinitialised.
The anti-pinch safety function is not active
during these operations:
Safety anti-pinch
(depending on version)
1. Left-hand front.
2. Right-hand front.
3. Right-hand rear.
4. Left-hand rear.
-
-
bring the window down completely, then
bring it back up. It will go up by a few
centimetres with each press. Perform the
operation again until the window is fully
closed,
continue to pull the switch upwards for at
least one second after reaching the window
closed position.
When the window rises and meets an obstacle,
it stops and immediately partially lowers again.
In the event of unwanted opening of the window
when closing automatically, press the switch
until the window opens completely, then pull
the switch immediately until the window closes.
Continue to hold the switch for approximately
one second after the window has closed.
5. Deactivating the rear electric window
switches.
Maintaining the locking action (on the key
or the remote control) closes the windows
automatically.
Always remove the key when leaving the
vehicle, even for a short time.
The safety anti-pinch function is not active
during this operation.
In the event of contact (pinching) during
operation of the windows, you must
reverse the movement of the window. To
do this, press the switch concerned.
When operating the passenger electric
window switches, the driver must ensure
that no-one is preventing the windows
from closing correctly.
The driver must ensure that the
passengers use the electric windows
correctly.
Be aware of children when operating the
windows.
Manual operation
To open or close the window, press or pull the
switch gently, without exceeding the resistance
point. The window stops as soon as the switch
is released.
Deactivating the rear
electric window switches
Automatic operation
For the safety of your children, press
this switch to prevent operation
of the windows of the rear doors,
irrespective of their position.
To open or close the window, press or pull the
switch fully, beyond the resistance point: the
window opens or closes completely when the
switch is released. Pressing the switch again
stops the movement of the window.
If the indicator lamp is on, the rear controls are
deactivated.
50
English 