INSTRUMENTS and CONTROLS
Manual mode
The digital clock does not display
seconds.
When the "minutes" display is
set or reset to zero, the clock
starts at the zero second of the
minute selected.
1
The time setting is lost if the
battery is disconnected.
) Turn button B "TUNE" to the left or
to the right to select "CT ON" (auto-
matic mode) or "CT OFF" (manual
mode).
) After selecting the mode, you can
exit the "Functions setting mode"
menu by pressing button B "TUNE"
for approximately 2 seconds.
Set the time using the buttons as
indicated below:
) with the ignition on or in the ACC
(Accessories) position, press and
hold the CLOCK button until the
time display flashes.
) Press the appropriate button to set
the time:
Button H: to set the hours
The hours digits scroll when you press
this button.
Button M: to set the minutes
If no action is carried out within
10 seconds, the system will exit
the "Functions setting mode"
menu automatically.
The minutes digits scroll when you
press this button.
Button 00: to reset the minutes to
zero.
Automatic mode
-
-
from 1 to 29 min: rounded down to
the previous hour,
from 30 to 59 min: rounded up to
the next hour.
In this mode, setting is automatic using
the signal from the RDS radio stations.
) After setting the time, press the
DISP button; the time display stops
flashing.
English 