2017-2023 Peugeot 5008 SUV Access -> Alarm User Manual

MY CAR USER MANUAL

Access -> Alarm for Your Peugeot 5008 SUV Second Generation (2017-2023)

Access  
For more information on Reinitialising the  
remote control, refer to the corresponding  
section.  
► Switch off the ignition and remove the key  
from the switch.  
The remote control is now fully operational  
again.  
Alarm  
(Depending on version)  
Do not throw remote control batteries  
away, as they contain metals that are  
harmful to the environment. Take them to an  
approved disposal point.  
With Keyless Entry and Starting  
Reinitialising the remote  
control  
Following replacement of the battery or in  
the event of a fault, it may be necessary to  
reinitialise the remote control.  
System which protects and provides a deterrent  
against theft and break-ins.  
Exterior perimeter monitoring  
The system checks for opening of the vehicle.  
The alarm is triggered if anyone tries to open a  
door, the boot or the bonnet, for example.  
Without Keyless Entry and Starting  
► Insert the mechanical key (incorporated into  
the remote control) into the lock to open the  
vehicle.  
► Place the electronic key against the back-up  
reader on the steering column and hold it there  
until the ignition is switched on.  
Interior volumetric monitoring  
The system checks for any variation in volume in  
the passenger compartment.  
The alarm is triggered if anyone breaks a  
window, enters the passenger compartment or  
moves inside the vehicle.  
► Switch on the ignition by pressing the  
"START/STOP" button.  
Anti-tilt monitoring  
► With a manual gearbox, place the gear lever  
in neutral then fully depress the clutch pedal.  
► With an automatic gearbox, while in mode  
P, depress the brake pedal.  
If the fault persists after reinitialisation, contact  
a PEUGEOT dealer or a qualified workshop  
without delay.  
The system checks for any change in the attitude  
of the vehicle.  
The alarm goes off if the vehicle is lifted or  
moved.  
► Switch off the ignition.  
► Return the key to position 2 (Ignition on).  
► Immediately press the closed padlock button  
for a few seconds.  
34  
Access  
When the vehicle is parked, the alarm  
will not be triggered if the vehicle is  
knocked.  
If an opening (door, boot or bonnet) is not  
properly closed, the vehicle is not locked,  
but the exterior perimeter monitoring will be  
activated after 45 seconds, at the same time  
as the interior volumetric and anti-tilt  
monitoring.  
Locking the vehicle  
with exterior perimeter  
monitoring only  
Deactivate the interior volumetric and anti-tilt  
monitoring to avoid the unwanted triggering of  
the alarm, in certain cases such as:  
– Slightly open window.  
– Washing the vehicle.  
– Changing a wheel.  
– Towing the vehicle.  
– Transport on a ship or ferry.  
2
Self-protection function  
The system checks for the putting out of service  
of its components.  
The alarm is triggered if the battery, the central  
control or the siren wiring is put out of service or  
damaged.  
Deactivation  
► Press one of the remote control unlocking  
buttons:  
short press  
For all work on the alarm system, contact  
a PEUGEOT dealer or a qualified  
workshop.  
long press  
Deactivating the interior volumetric  
and anti-tilt monitoring  
► Switch off the ignition and within 10 seconds  
press the alarm button until its red indicator lamp  
is on fixed.  
or  
Locking the vehicle with full  
alarm system  
► Unlock the vehicle with the Keyless Entry and  
Starting system.  
The monitoring system is deactivated: the  
indicator lamp in the button goes off and the  
direction indicators flash for about 2 seconds.  
► Get out of the vehicle.  
Activation  
► Lock the vehicle immediately using the  
remote control or with the “Keyless Entry and  
Starting” system.  
Only the exterior perimeter monitoring is  
activated; the red indicator lamp in the button  
flashes every second.  
► Switch off the ignition and exit the vehicle.  
► Lock or deadlock the vehicle using the  
remote control or with the “Keyless Entry and  
Starting” system.  
When the monitoring system is active, the red  
indicator lamp in the button flashes once per  
second and the direction indicators come on for  
about 2 seconds.  
If the vehicle automatically locks itself  
again (as happens if a door or the boot is  
not opened within 30 seconds of unlocking),  
the monitoring system is automatically  
reactivated.  
To take effect, this deactivation must be  
carried out after each time the ignition is  
switched off.  
The exterior perimeter monitoring is activated  
after 5 seconds and the interior volumetric and  
anti-tilt monitoring after 45 seconds.  
35  
Access  
Reactivating the interior volumetric  
and anti-tilt monitoring  
► Switch on the ignition; this stops the alarm.  
The indicator lamp in the button goes off.  
From inside  
► Pull the interior opening control of a door; this  
unlocks the vehicle completely.  
► Deactivate the exterior perimeter monitoring  
by unlocking the vehicle using the remote control  
or the Keyless Entry and Starting system.  
The indicator lamp in the button goes off.  
► Reactivate all monitoring by locking the  
vehicle using the remote control or the Keyless  
Entry and Starting system.  
Locking the vehicle without  
activating the alarm  
► Lock or deadlock the vehicle using the key  
(integral to the remote control) in the driver's  
door lock.  
With selective unlocking activated:  
– Opening the driver's door unlocks  
the driver's door only (if the vehicle has not  
already been completely unlocked).  
– Opening one of the passenger doors  
unlocks the rest of the vehicle.  
The red indicator lamp in the button once again  
flashes every second.  
Malfunction  
When the ignition is switched on, fixed  
illumination of the red indicator lamp in the  
button indicates a malfunction of the system.  
Have it checked by a PEUGEOT dealer or a  
qualified workshop.  
Closing  
Triggering of the alarm  
This is indicated by sounding of the siren  
and flashing of the direction indicators for 30  
seconds.  
Depending on the country of sale, certain  
monitoring functions remain active until the alarm  
has been triggered eleven times consecutively.  
When the vehicle is unlocked using the remote  
control or the Keyless Entry and Starting system,  
rapid flashing of the red indicator lamp in the  
button informs you that the alarm was triggered  
during your absence. When the ignition is  
switched on, this flashing stops.  
If a door is not properly closed, this  
warning lamp comes on accompanied by  
a message if the engine is running, and an  
audible signal when the vehicle is travelling at  
more than 6 mph (10 km/h).  
Doors  
Boot  
Opening  
Opening the tailgate  
From outside  
► After unlocking the vehicle or with the  
Keyless Entry and Starting electronic key in the  
recognition zone, pull the door handle.  
When selective unlocking is activated,  
the first press of the remote control  
unlocking button permits unlocking of the  
driver's door only.  
Failure of the remote control  
To deactivate the monitoring functions:  
► Unlock the vehicle using the key in the  
driver's door lock.  
►
With the vehicle unlocked or with the  
"Keyless Entry and Starting" system electronic  
key in the recognition zone, press the central  
tailgate control.  
► Open the door; the alarm is triggered.  
► Raise the tailgate.  
36  

Related Topics

Access

Remote control / Key
Keyless Entry and Starting
Doors
Electric windows
Panoramic sunroof