Access -> Electric windows for Your Peugeot 5008 SUV Second Generation (2017-2023)

Access  
The red indicator lamp in the button comes  
on and a confirmation message is displayed.  
The lamp will remain lit until the controls are  
reactivated.  
In wintry conditions  
Automatic operation  
2
To avoid any operating problems, remove  
the snow or wait until the ice melts before  
requesting motorised opening of the tailgate.  
To open/close the window, press/pull the  
switch past its resistance point: the window  
opens/closes completely when the switch is  
released.  
The rear electric windows can still be controlled  
using the driver's controls.  
When washing  
Operating the switch again stops the movement  
of the window.  
When washing the vehicle in an  
automatic car wash, do not forget to lock  
the vehicle to prevent any risk of unwanted  
opening.  
Reinitialising the electric  
windows  
Following reconnection of the battery, or if  
the windows move abnormally, the anti-pinch  
function must be reinitialised.  
Window controls remain operational for  
approximately 45 seconds after switching  
off the ignition or after locking the vehicle.  
After that time, the controls are disabled.  
To reactivate them, switch on the ignition or  
unlock the vehicle.  
Electric windows  
The safety anti-pinch function is not active  
during these operations.  
For each of the windows:  
Anti-pinch  
► Lower the window fully, then raise it; it will  
rise in steps of a few centimetres each time the  
control is pressed. Repeat the operation until the  
window is fully closed.  
► Continue to pull the switch for at least  
one second after reaching the window closed  
position.  
If the window meets an obstacle while rising, it  
stops and immediately partially lowers again.  
Deactivating the rear  
controls for the rear electric  
windows  
1. Left-hand front  
2. Right-hand front  
3. Right-hand rear  
4. Left-hand rear  
If an electric window meets an obstacle  
during operation, the movement of the  
window must be reversed. To do this, press  
the switch concerned.  
When the driver operates the passengers’  
electric window switches, it is important to  
ensure that nothing can prevent the window  
from closing properly.  
5. Deactivation of the electric window controls  
located by the rear seats  
Manual operation  
To open/close the window, press/pull the  
switch without passing the point of resistance;  
the window stops as soon as the switch is  
released.  
For your children's safety, press control 5 to  
deactivate the controls for the rear electric  
windows, irrespective of their positions.  
It is important to ensure that the passengers  
use the electric windows correctly.  
41  
Access  
Be particularly aware of children when  
operating the windows.  
Be aware of passengers and/or other persons  
present when closing the windows using  
the electronic key or the "Keyless Entry and  
Starting" system.  
Precautions  
Operation  
When opening the sunroof fully, the movable  
glass moves to a partially open position, then  
slides over the roof. All intermediate positions  
are allowed.  
Do not put your head or arms through the  
sunroof when driving - risk of serious  
injury!  
Depending on the speed of the vehicle,  
the partially open position may vary to  
improve the acoustics.  
Ensure that any luggage or accessories  
carried on the roof bars does not  
interfere with the movement of the sunroof.  
Do not place heavy loads on the movable  
glass panel of the sunroof.  
Panoramic sunroof  
The panoramic sunroof consists of a movable  
glass panel that slides over the roof and a blind  
that can be opened independently. Opening the  
sunroof automatically opens the blind.  
Before operating the sunroof or blind  
control buttons, ensure that no object or  
person might prevent the movement.  
Be particularly aware of children when  
operating the sunroof or blind.  
If something is trapped when operating the  
sunroof or blind, you should reverse the  
movement of the sunroof or blind by pressing  
the control in question.  
If the sunroof is wet, following a shower  
or washing the vehicle, wait until it is  
completely dry before opening.  
Do not operate the sunroof if it is covered by  
snow or ice - risk of damage!  
To operate the panoramic sunroof or the  
blind, use the buttons in the roof console.  
Use only plastic scrapers to remove snow or  
ice from the sunroof.  
The driver must ensure that passengers use  
the sunroof and blind correctly.  
Check the condition of the sunroof seals  
regularly (presence of dust or deposits,  
dead leaves, etc.).  
Anti-pinch system  
If the sunroof or blind encounters an obstacle  
when closing, the movement is automatically  
reversed.  
The roof anti-pinch system is designed to be  
effective at speeds of up to 75 mph (120 km/h).  
If using a car wash, check that the roof is  
correctly closed in advance and keep the  
tip of the high-pressure lance at least 30  
centimetres from the seals.  
A. Sunroof blind control  
B. Sunroof control  
The sunroof or blind can be operated when the  
ignition is turned on (if the battery is charged  
enough), with the engine running, in STOP mode  
of Stop & Start, and up to 45 seconds after  
turning off the ignition or after locking the vehicle.  
Never leave the vehicle with the sunroof  
open.  
Opening / Closing  
To open the sunroof or the blind, use the part  
of the button located towards the rear.  
42