Practical information -> Very cold climate screen for Your Peugeot 5008 SUV Second Generation (2017-2023)

Practical information  
► Stop the vehicle and check that the snow  
chains are correctly tightened.  
Fitting  
It is strongly recommended that before  
you leave, you practise fitting the snow  
chains on a level and dry surface.  
Avoid driving with snow chains on roads  
that have been cleared of snow to avoid  
damaging the vehicle's tyres and the road  
surface. If the vehicle is fitted with alloy  
wheels, check that no part of the chain or its  
fixings is in contact with the wheel rim.  
For fitting / removing, it is recommended  
that you contact a PEUGEOT dealer or a  
qualified workshop.  
► Hold the corresponding screen in front of the  
lower grille of the bumper.  
Before any operation, ensure that the  
engine is off and the cooling fan has  
stopped.  
► First insert the two lower fixing brackets into  
the bumper.  
► Tilt the screen upwards until the three upper  
fixing brackets click into the bumper.  
► Check that the unit is firmly held by pressing  
around the edges.  
Hybrid vehicles  
The use of snow chains is only  
authorised on the front wheels.  
It is essential to remove them when:  
– the exterior temperature exceeds  
10°C.  
Repeat these operations for the other screen.  
Very cold climate screen  
(Depending on country of sale.)  
This removable protective screen prevents the  
accumulation of snow at the radiator cooling fan.  
It consists of two elements to be attached to the  
front bumper.  
– towing.  
Removing  
– the speed is above 75 mph (120 km/h).  
178  
Practical information  
risk of injury resulting from an automatic  
► Insert a finger into the notch in the upper part  
of the screen.  
► Pull towards you to unclip the unit.  
Repeat these operations for the other screen.  
– For more than 10 minutes, to use the  
equipment for approximately 30 minutes.  
Let the engine run for the specified duration to  
ensure that the battery charge is sufficient.  
To recharge the battery, avoid repeatedly or  
continuously restarting the engine.  
7
change to START mode.  
Energy economy mode  
A flat battery prevents the engine from  
starting.  
For more information on the 12 V battery,  
refer to the corresponding section.  
This system manages the duration of use of  
certain functions, in order to conserve a sufficient  
level of charge in the battery with the ignition off.  
After switching off the engine, you can still  
use functions such as the audio and telematic  
system, the wipers and the dipped beam  
headlamps or courtesy lamps, for a combined  
duration of approximately 40 minutes.  
Hybrid vehicles  
Before any work is carried out under the  
bonnet, it is essential to switch off the ignition  
and check that the READY indicator lamp is  
off in the instrument panel - risk of serious  
injury!  
Load reduction mode  
This system manages the use of certain  
functions according to the level of charge  
remaining in the battery.  
When the vehicle is being driven, the load  
reduction function temporarily deactivates certain  
functions, such as the air conditioning and the  
heated rear screen.  
The deactivated functions are reactivated  
automatically as soon as conditions permit.  
The location of the interior bonnet  
release lever prevents the bonnet being  
opened when the left-hand front door is  
closed.  
Selecting the mode  
A confirmation message is displayed when  
energy economy mode is entered, and the active  
functions are placed on standby.  
When the engine is hot, handle the  
exterior safety catch and the bonnet stay  
with care (risk of burns), using the protected  
area.  
When the bonnet is open, take care not to  
damage the safety catch.  
If a telephone call is in progress at the  
time, it will be maintained for around 10  
minutes via the audio system’s hands-free  
system.  
Bonnet  
Do not open the bonnet under very windy  
conditions.  
Exiting the mode  
These functions are automatically reactivated the  
next time the vehicle is used.  
To restore the use of these functions  
immediately, start the engine and let it run:  
– For less than 10 minutes, to use the  
equipment for approximately 5 minutes.  
Stop & Start  
Before doing anything under the bonnet,  
you must switch off the ignition to avoid any  
Cooling of the engine when stopped  
The engine cooling fan may start after  
the engine has been switched off.  
179