ACCESSES
4
Changing the remote control
battery
Reprogramming the remote
control
ELECTRONIC ENGINE
IMMOBILISER
Following disconnection of the vehi-
cle's battery, replacement of the
remote control battery or in the event
of a remote control malfunction, the
remote control must be reinitialised.
This locks the engine control system
a few moments after the ignition has
been switched off and therefore pre-
vents starting of the vehicle by anyone
who does not have the key.
Switch off the ignition.
The ignition key has an electronic chip
which has a special code. When the
ignition is switched on, the code is rec-
ognised and starting is possible.
If the system does not function cor-
rectly, the service warning light comes
on, accompanied by an audible signal
and a message on the multifunction
display.
Switch the ignition on again.
Press the remote control locking but-
ton immediately for a few seconds.
Switch off the ignition and remove
the remote control key from the
ignition lock.
The remote control is now working
again.
Battery ref.: CR1620 / 3 volts.
In this case, your vehicle will not start.
Contact a PEUGEOT dealer as soon
as possible.
The information "battery flat" is given
by displaying of the service warning
light, accompanied by an audible sig-
nal and a message on the multi-func-
tion display.
To replace the battery, unclip the cas-
ing using a coin at the notch.
If the remote control does not work
after the battery has been changed,
re-programme the remote control.
Do not discard the batteries,
they contain metals which are
harmful to the environment.
Take them to an approved col-
lection point.
60
English 
