Pneumatic suspension
Return to the nominal floor height
Warning lamp
Press the same number of times in reverse
as the level of the position displayed.
Refer to the "Instruments and controls"
section of chapter 2.
Deactivation
Good practice
Make a long press on both controls
simultaneously to deactivate the system.
The LEDs remain on.
Driving with the suspension set too high or
too low risks damaging components under
the body.
The height may be adjusted automatically to
take account of changes of temperature or
loading.
Reactivation
A second long press on both controls
simultaneously reactivates the system. The
LEDs go off.
You must avoid using this control in the
following circumstances:
-
-
-
when working underneath the vehicle,
when changing a wheel,
Above 3 mph (5 km/h), the system
reactivates automatically.
when the vehicle is being transported by
lorry, train, ferry, boat, ...
Automatic correction of loading
floor height
Above 12 mph (20 km/h), the system
automatically returns the rear height to its
nominal value.
English 