Get In the event of a breakdown -> Spare wheel Guide for Peugeot Ion 4 Door First Generation (2010-2020)

In the event of a breakdown

Spare wheel

Tools required

Parking the vehicle

Wheel with wheel trim

-

A jack: for lifting the vehicle.

A wheelbrace: for removing and refitting

the wheel bolts.

Immobilise the vehicle where it does not

block traffic: the ground must be level,

stable and not slippery.

Apply the parking brake, switch off the

ignition and put the drive selector in

position P to lock the wheels.

If necessary, place a chock under the

wheel diagonally opposite the wheel to

be changed.

When removing the wheel, first

remove the wheel trim using the

wheelbrace, by pulling at the valve hole.

When refitting the wheel, refit the

wheel trim starting by aligning the valve

hole with the valve, and then press on

the edge of the trim with the palm of

your hand.

-

A handle: for operating the jack.

These tools are not supplied with your vehicle.

You must ensure that the occupants get

out of the vehicle and wait where they

are safe.

Never go underneath a vehicle raised

using a jack; use an axle stand.

8

121

In the event of a breakdown

Removing a wheel

F

Slacken the bolts using the wheelbrace.

Position the foot of the jack on the ground

and ensure that it is directly below the

front A or rear B jacking point provided on

the underbody, whichever is closest to the

wheel to be changed.

F

Extend the jack until its head comes into contact with the jacking point A or B used. The

vehicle's contact surface A or B must be engaged with the central part of the head of the jack.

Raise the vehicle until there is sufficient space between the wheel and the ground.

122

In the event of a breakdown

F

Remove the bolts and store them in a clean

place.

Remove the wheel.

Ensure that the jack is stable. If the

ground is slippery or loose, the jack

might slip or drop - Risk of injury!

Take care to position the jack only at

one of the vehicle’s jacking points A

or B under the vehicle, ensuring that the

contact surface of the vehicle’s jacking

point is centred on the head of the jack.

Otherwise there is a risk of damage to

the vehicle and/or that the jack might

drop - Risk of injury!

8

123

In the event of a breakdown

Fitting a wheel

F

Put the wheel in place on the hub.

Screw in the bolts by hand.

Pre-tighten the bolts using the wheelbrace.

F

Lower the vehicle fully.

Fold the jack and detach it.

F

Tighten the bolts using the wheelbrace.

After changing a wheel

Have the tightening of the bolts and the

tyre pressure of the new wheel checked

by a PEUGEOT dealer or a qualified

workshop without delay.

124

In the event of a breakdown -> Spare wheel for Your Peugeot Ion 4 Door First Generation (2010-2020)

Related Topics

In the event of a breakdown