Advertisement

Advertisement

Download User Manual App

Quickly access user manual for free!

QUICK HELP -> Battery for Your Peugeot Partner Van 2008-2014

Battery  
BATTERY  
To charge the battery using  
a battery charger  
-
-
Disconnect the battery,  
Follow the instructions for use  
given by the battery charger  
manufacturer,  
The presence of this label  
indicates the use of a 12 V  
-
-
Reconnect starting with the  
negative (-) terminal,  
Check that the terminals and  
connectors are clean. If they are  
covered with sulphate (white or  
greenish deposit), disconnect them  
and clean them.  
lead-acid battery with special  
technology and specication, for which  
the involvement of a PEUGEOT dealer  
or qualied workshop is required when  
replacing or disconnecting the battery.  
Failure to observe this  
recommendation may cause premature  
wear of the battery.  
Before disconnecting the battery, you  
must wait for 2 minutes after switching  
off the ignition.  
To start the vehicle from  
another battery  
-
-
-
Connect the red cable to the  
positive (+) terminals of the  
two batteries,  
Connect one end of the green  
or black cable to the negative (-)  
terminal of the slave battery,  
Connect the other end of the green  
or black cable to an earth point on  
the broken down vehicle as far as  
possible from the battery,  
Operate the starter, let the engine run,  
Wait for the engine to return to idle,  
then disconnect the cables.  
Never disconnect a terminal when the  
engine is running.  
Never charge a battery without rst  
After retting the battery, the Stop &  
Start system will only be active after  
several hours depending on the  
climatic conditions and the state of  
charge of the battery (up to about  
8 hours).  
disconnecting the terminals.  
After every reconnection of the battery,  
switch on the ignition and wait 1 minute  
before starting to allow the electronic  
systems to be initialised. If problems  
remain after doing this, please contact  
a PEUGEOT dealer or a qualied  
workshop.  
After changing bulbs, wait  
approximately 3 minutes before  
reconnecting the battery.  
The Stop & Start battery does not have  
to be disconnected for charging.  
-
-
It is advisable to disconnect the  
battery if the vehicle is not to be  
used for a period of more than one  
month.  
7
Changing a wheel  
ECONOMY MODE  
After the engine has stopped, with  
the key in the ignition position, certain  
functions (windscreen wiper, electric  
windows, courtesy lamps, audio  
equipment, etc.) can only be used for a  
cumulative duration of thirty minutes, to  
prevent discharging of the battery.  
Once the thirty minutes are over, the  
active functions are put on standby  
and the battery warning lamp ashes  
accompanied by a message in the  
screen.  
To resume the use of these functions  
immediately, start the engine and let it  
run for a few minutes.  
The time available will then be double  
the time for which the engine was left  
running. However, this time will always  
be between ve and thirty minutes.  
A at battery will prevent the engine  
from starting.